海上风电大直径单桩基础固有频率影响因素的数值分析

针对海上风电整机结构其低阶固有频率的控制问题,基于有限元分析技术开展小直径桩土相互作用的数值模拟分析,与试验结果、API规范计算结果进行对比,验证了数值模型的适用性,分析大直径单桩结构桩内土芯、冲刷深度、表层土置换措施对整机固有频率的影响,结果表明,基于有限元实体单元计算所得一、二阶整机固有频率要明显大于传统p-y方法计算结果;桩内土芯对一、二阶整机固有频率影响很小;在一定范围内,随着泥面冲刷深度的增加,一、二阶固有频率降低不明显,认为传统p-y方法对于大直径单桩的适用性有待研究;在实际工程设计中,桩内土芯的影响可忽略;对于大直径单桩,在一定范围内可以忽略冲刷的影响。     

A real-time adaptive signal control in a connected vehicle environment

The state of the practice traffic signal control strategies mainly rely on infrastructure based vehicle detector data as the input for the control logic. The infrastructure based detectors are generally point detectors which cannot directly provide measurement of vehicle location and speed. With the advances in wireless communication technology, vehicles are able to communicate with each other and with the infrastructure in the emerging connected vehicle system. Data collected from connected vehicles provides a much more complete picture of the traffic states near an intersection and can be utilized for signal control. This paper presents a real-time adaptive signal phase allocation algorithm using connected vehicle data. The proposed algorithm optimizes the phase sequence and duration by solving a two-level optimization problem. Two objective functions are considered: minimization of total vehicle delay and minimization of queue length. Due to the low penetration rate of the connected vehicles, an algorithm that estimates the states of unequipped vehicle based on connected vehicle data is developed to construct a complete arrival table for the phase allocation algorithm. A real-world intersection is modeled in VISSIM to validate the algorithms. Results with a variety of connected vehicle market penetration rates and demand levels are compared to well-tuned fully actuated control. In general, the proposed control algorithm outperforms actuated control by reducing total delay by as much as 16.33% in a high penetration rate case and similar delay in a low penetration rate case. Different objective functions result in different behaviors of signal timing. The minimization of total vehicle delay usually generates lower total vehicle delay, while minimization of queue length serves all phases in a more balanced way.     

基于PLC的模糊频载调节器设计

介绍可编程序控制器(PLC)实现船舶电站模糊调频调载的软硬件实现方法,采用离线计算、在线查表的方法在PLC上实现模糊控制,利用硬件在环仿真进行试验研究,结果表明,智能频载控制器具有较好的稳、动态性能。     

A signal-based fault detection and classification method for heavy haul wagons

This paper proposes a signal-based fault detection and isolation (FDI) system for heavy haul wagons considering the special requirements of low cost and robustness. The sensor network of the proposed system consists of just two accelerometers mounted on the front left and rear right of the carbody. Seven fault indicators (FIs) are proposed based on the cross-correlation analyses of the sensor-collected acceleration signals. Bolster spring fault conditions are focused on in this paper, including two different levels (small faults and moderate faults) and two locations (faults in the left and right bolster springs of the first bogie). A fully detailed dynamic model of a typical 40t axle load heavy haul wagon is developed to evaluate the deterioration of dynamic behaviour under proposed fault conditions and demonstrate the detectability of the proposed FDI method. Even though the fault conditions considered in this paper did not deteriorate the wagon dynamic behaviour dramatically, the proposed FIs show great sensitivity to the bolster spring faults. The most effective and efficient FIs are chosen for fault detection and classification. Analysis results indicate that it is possible to detect changes in bolster stiffness of ±25% and identify the fault location.     

射频识别技术在物流工程中的应用研究

简要介绍了射频识别技术的工作原理和优点,综述了射频识别技术在国内各个领域的主要应用,最后指出了当前射频识别技术所存在的主要问题。     

轨道交通信号设备实训课程体系的研究

高职院校以"服务为宗旨、就业为导向",与地方经济发展相结合,积极探索实践教学的方法,搭建技能型人才培养实践教学体系推动行业与自身的可持续发展。以此为出发点,建立一个完整而完善的信号设备实训课程体系,不仅有利于专业自身的发展,同时也对其他院校有着一定的借鉴意义。从而减少一些重复的工作,推动省内院校轨道信号相关专业整体水平的提升。     

油底壳有限元模态分析及实验验证

以EQ491型发动机油底壳为研究对象,通过有限元法得到了油底壳模型的固有频率和振型,运用模态实验技术,验证了有限元模型的合理性。在原始有限元模型的基础上,对油底壳模型进行约束模态分析,验证了油底壳结构的合理性,即油底壳固有频率远大于发动机机体激振频率。     

高速公路直线路段突起路标间隔设置方法

基于驾驶人的视觉惰性、视觉警示频率和感觉特性,分析了突起路标的视觉警示作用,确定了突起路标的闪现频率,计算与修正了突起路标的初始间隔。应用ADAMS/Car仿真软件模块,建立了道路、车辆和突起路标模型,将车型设置为大型车和小型车,大型车的车速设置为60、80、100km·h-1,小型车的车速设置为80、100、120km·h-1,大型车和小型车的方向盘转角均设置为1°、3°、5°。分别对提出的12m间隔与现行规范推荐的15m间隔各进行243次仿真,分析振动警示效果。仿真结果表明:在12m间隔下,平均碾压率为93.1%,小型车和大型车对应的平均警示率分别为41.7%和5.6%;在15m间隔下,平均碾压率为93.7%,小型车和大型车对应的平均警示率分别为33.3%和28.9%;12、15m间隔对小型车都具有较好的振动警示效果,15m间隔对大型车的振动警示效果更好。当高速公路夜间交通流较大或需要加大交通设施的夜间安全效果时,可选12m间隔提供良好的视觉连续性和视觉警示效果;考虑施工维护的方便性和经济性或者大型车比例较大时,可选择15m间隔。     

由船舶响应反推当前海浪频谱的探索研究

借助白噪声谱在数学处理上的独特优势,利用计算流体力学方法(CFD),生成了高精度的白噪声长峰不规则波,实现了船模在该海浪环境下顶浪航行时的纵摇及垂荡耦合运动的数值模拟,从而计算船模纵摇和垂向加速度的响应幅值算子(RAO),达到了由海上实测摇荡时历反推较高精度海浪频谱的目标,并将反推结果与海上实测海浪数据进行了对比,效果良好,从而为在航船舶提供了一种获取当前海浪信息的新方法。