第三轨供电系统中受流器与第三轨的接触压力及其对受流性能的影响分析

介绍了第三轨受流器的结构原理。分析比较了弹簧式和气压式受流器与第三轨接触压力调节方式的特点。基于电接触基本理论详细的阐述了受流滑板与第三轨接触区的导电机理。接触区域的导电电路由无数微小的电阻及电容并联而成,接触压力通过影响微小电阻、电容的数量比例,进而影响接触面上的导电能力和磨损性能。标称静态接触压力的设计值接近或等于"法向压应力临界值"时,导电能力和磨损特性取得均衡。     

超深振捣条件下混凝土墙体模板侧压力的简化计算方法

超深振捣对混凝土成品质量有害无益,研究超深振捣引起模板侧压力增大的规律,可为规避其害提供依据。为此设计4个混凝土墙体试件,实测在浇筑过程中模板侧压力的变化情况。基于振捣液化和液体压力平衡理论,建立了超深振捣情况下混凝土模板侧压力计算模型,推导了计算公式,并与实验数据进行对比验证。研究结果表明,振捣深度是影响混凝土墙体模板侧压力的重要因素,本文提出的计算模型能很好地预测墙体结构超深振捣位置的模板侧压力。     

某散货船试航中主机滑油低压故障的排除

文章分析了某散货轮在试航中主机多次出现因滑油低压而报警停车的故障现象,并将该故障出现的原因及排除过程进行了总结和思考,以期为船厂、船东以及试航的相关人员提供参考。     

西南红层软岩地区铁路滑坡形成机理分析及治理措施

红层软岩地区铁路工程建设中滑坡问题突出。本文结合西南地区一铁路红层滑坡治理工程,利用该地区红层滑坡的现场调查结果,从红层软岩特性、地层岩性、地质地貌、水文地质条件、深孔位移监测数据等多方面对该地区铁路滑坡形成机理进行分析,并论述红层滑坡与一般滑坡的不同点,分析红层软岩岩体力学特性、地层主要成分以及红层软岩中的粉砂质泥岩在不同风化程度下的力学特性。根据分析结果提出治理措施,并对治理措施进行评价。总结得出地层岩性、地质水文、人为因素是导致红层滑坡病害发生的主要因素。     

相继增压系统对改善船用直列八缸发动机性能的试验研究

随着大型柴油发动机经济性和排放要求的不断提升,以及对发动机稳态、瞬态特性要求的不断提高,传统的涡轮增压系统已无法满足船用发动机全工况性能的要求。为了提高产品竞争力和适配性,针对某8缸直列船用柴油发动机开发了带有定压排气管的相继增压系统,并进行了发动机台架试验研究。结果表明：发动机中、低转速时,相继增压系统使发动机比油耗可以下降5%-10%,排气温度降低30%-45%,烟度下降55%-60%；最大扭矩可以提升15.1%-36.4%；发动机最大扭矩转速工况突加突卸响应性提升约28%-29%；相继增压系统中定压排气管的设计使得发动机高工况性能也有所提升,从而实现发动机全工况性能的提升。     

Changes in fuel economy: An analysis of the Spanish car market

This paper estimates the role that technological change and car characteristics have played in the rate of fuel consumption of vehicles over time. Using data from the Spanish car market from 1988 to 2013, we estimate a reduced form equation that relates fuel consumption with a set of car characteristics. The results for the sales-weighted sample of vehicles show that energy efficiency would have improved by 30% and 42% for petrol and diesel cars respectively had car characteristics been held constant at 1988 values. However, the shift to bigger and more fuel-consuming cars reduced the gains from technological progress. Additionally, using the results of the fuel equation we show that, besides a natural growth rate of 1.1%, technological progress is affected by both the international price of oil and the adoption of mandatory emission standards. Moreover, according to our estimations, a 1% growth in GDP would modify car characteristics in such a way that fuel consumption would increase by around 0.23% for petrol cars and 0.35% for diesel cars.     

5000 PCC“SHANGHAI HIGHWY”船主机启动分析与处理

分析5 000 PCC"SHANGHAI HIGHWAY"船主机伺服油压低引起主机启动故障的原因、介绍调查与处理过程,在实施了恰当的处理方法后,解决了问题。以期为类似问题的处理与解决提供借鉴和参考。     

内压载荷下X80管道裂纹应力分布规律研究

为了研究内压作用下管道裂纹应力场分布规律,以含有表面裂纹的X80管道为研究对象,对不同形状、不同方向、不同内压、不同尺寸的含裂纹管道进行仿真分析和实验验证。结果表明:裂纹尖端处应力远大于裂纹中心应力。裂纹形状对应力影响作用较小,随着裂纹方向与管道轴向夹角增大,裂纹尖端应力先增大后减小,随着管道内压、裂纹深度、裂纹长度的增大,裂纹尖端处应力随之线性增大。其中,裂纹长度对裂纹尖端应力的影响小于管道内压和裂纹深度。     

Driving cycle prediction model based on bus route features

Bus fuel economy is deeply influenced by the driving cycles, which vary for different route conditions. Buses optimized for a standard driving cycle are not necessarily suitable for actual driving conditions, and, therefore, it is critical to predict the driving cycles based on the route conditions. To conveniently predict representative driving cycles of special bus routes, this paper proposed a prediction model based on bus route features, which supports bus optimization. The relations between 27 inter-station characteristics and bus fuel economy were analyzed. According to the analysis, five inter-station route characteristics were abstracted to represent the bus route features, and four inter-station driving characteristics were abstracted to represent the driving cycle features between bus stations. Inter-station driving characteristic equations were established based on the multiple linear regression, reflecting the linear relationships between the five inter-station route characteristics and the four inter-station driving characteristics. Using kinematic segment classification, a basic driving cycle database was established, including 4704 different transmission matrices. Based on the inter-station driving characteristic equations and the basic driving cycle database, the driving cycle prediction model was developed, generating drive cycles by the iterative Markov chain for the assigned bus lines. The model was finally validated by more than 2 years of acquired data. The experimental results show that the predicted driving cycle is consistent with the historical average velocity profile, and the prediction similarity is 78.69%. The proposed model can be an effective way for the driving cycle prediction of bus routes.     

铁路路基动态变形模量的数值模拟分析

介绍铁路路基动态变形模量理论计算公式的推导及动态变形模量的测试原理,采用有限元软件模拟动态变形模量的测试过程,分析承载板与土体接触压力、路基动态变形模量的影响因素,并计算动态变形模量的有效测试深度.结果表明:在承载板中心一定范围内,接触压力模拟结果较理论计算值大;土体的动弹性模量对接触压力影响很小,可以忽略;路基动态变形模量测试冲击荷载作用下,土体只发生弹性变形;动态变形模量与土体动弹性模量呈线性关系,路基动态变形模量的模拟结果大于理论计算值;土体的泊松比对动态变形模量影响较小;动态变形模量有效测试深度建议取0.5~0.6 m.