全文获取类型
收费全文 | 280篇 |
免费 | 30篇 |
专业分类
公路运输 | 108篇 |
综合类 | 62篇 |
水路运输 | 104篇 |
铁路运输 | 22篇 |
综合运输 | 14篇 |
出版年
2024年 | 1篇 |
2023年 | 1篇 |
2022年 | 10篇 |
2021年 | 10篇 |
2020年 | 18篇 |
2019年 | 8篇 |
2018年 | 11篇 |
2017年 | 8篇 |
2016年 | 14篇 |
2015年 | 17篇 |
2014年 | 29篇 |
2013年 | 16篇 |
2012年 | 26篇 |
2011年 | 25篇 |
2010年 | 23篇 |
2009年 | 11篇 |
2008年 | 13篇 |
2007年 | 18篇 |
2006年 | 20篇 |
2005年 | 13篇 |
2004年 | 8篇 |
2003年 | 3篇 |
2002年 | 2篇 |
2001年 | 2篇 |
2000年 | 1篇 |
1993年 | 1篇 |
1992年 | 1篇 |
排序方式: 共有310条查询结果,搜索用时 226 毫秒
31.
32.
[Objectives]In this paper, the numerical simulation method is used to study the anti-penetration performance and energy absorption mode of a stiffened plate, as well as the influence of different stiffened bars on the flight attitude of the projectile body.[Methods] Finite element software LS-DYNA is used to simulate the process of a truncated oval-nosed projectile penetrating a stiffened plate, and the results of the numerical simulation are compared with an experiment to verify the reliability of the numerical simulation method. The momentum method and mass equivalence method are used to predict the residual velocity of the projectile, and the applicability of different theoretical methods within different velocity ranges is compared. The deformation energy of different regions of the stiffened plate is then extracted to analyze the influence of the initial velocity of the projectile body on the energy absorption mode of the target plate. Finally, the structure of the stiffeners is changed and the influence of the relative position of the stiffeners on the penetration attitude of the projectile body is analyzed.[Results]The results show that the mass equivalence method is more accurate than the momentum method in predicting the residual velocity of the stiffened plate when the initial velocity of the projectile body is in the range of 300–900 m/s. The ratio of the deformation energy of the stiffened plate to the energy loss of the projectile body decreases with the increase of the initial velocity of the projectile body. The effect of a T-stiffened plate on trajectory is greater than that of a rectangular-stiffened plate.[Conclusions]The related calculation method and research results have certain reference value for research and engineering application surrounding the anti-penetration of stiffened plates. © 2023 Chinese Journal of Ship Research. All rights reserved. 相似文献
33.
船用柴油机采用水下排气方式具有降低排气噪声、改善舱外空气质量等优点,在大型豪华游轮等特殊船舶中具有广泛应用前景。为防止海水由排气管倒灌入柴油机造成事故,需弄清水下排气管内水倒流发生的条件。对大管径垂直管防止水倒灌临界条件即完全携带点的已有认识较为统一,而对小管径垂直管仍未有清晰的认识。在管径25~100 mm范围对垂直管的完全携带点进行了实验,探究了小管径垂直管的完全携带点预报方法。实验结果表明在小管径范围,垂直管完全携带点对应的临界表观气速随管径增大而升高,但气相Wallis数随管径增大而减小,说明Wallis数过度关联了管径对临界表观气速的影响。基于气相Kutateladze数和无量纲气相黏性,对小管径垂直管提出了新的完全携带点预报模型和相应实验关联式。 相似文献
34.
改性沥青胶浆性能试验研究 总被引:1,自引:0,他引:1
通过高温锥入度试验和低温小梁蠕变试验,研究了改性沥青胶浆性能随改性剂剂量和粉油比变化的规律。 相似文献
35.
采用砂桩处置软土地基,在自重及路基堆载作用下将产生较大的固结沉降,而且其固结系数也随时间而变化,具有非线性的固结特性。如果仍然采用恒定的固结参数计算固结度,将会带来一定的误差。基于江苏某高速公路软土路堤的实测沉降数据,采用恒定的固结参数计算沉降,发现其结果较实测偏大,且二者差距随时间有增大趋势。文章通过曾国熙固结度的普遍表达式,反演出固结参数的非线性函数,结合砂井地基固结度计算中的改进的太沙基法,提出对固结度进行修正的计算公式,并基于现场的静力触探(CPT)试验资料,采用复合模量法计算出沉降曲线,将其与实测沉降曲线对比,证明其精度较恒定固结参数的计算结果有较大提高。 相似文献
36.
高速弹丸侵彻储油容器液固耦合数值分析 总被引:1,自引:0,他引:1
为了探讨高速弹丸侵彻储油容器的液固耦合作用机理,采用大型动态非线性有限元软件ABAQUS\EXPLICIT,对空载、4/5装载和满载三种装载状态下的侵彻动力学过程进行了数值模拟.通过对比分析,得到了三种装载状态下弹丸速度衰减曲线和储油箱体的损伤变形特征,并对侵彻过程不同阶段的动力学特征和损伤机理进行了分析,计算结果与相关实验和理论结果吻合较好.结果表明:燃油对高速弹丸侵彻油箱的动力学过程影响很大,其作用主要体现在吸收更多弹丸的动能并将其转化为与燃油接触箱体的变形能,这往往会带来箱体整体性的破坏,在储油容器的结构强度设计时必须加以考虑. 相似文献
37.
简要介绍了茂湛二期高速公路透层、下封层的原材料技术要求.并对项目透层、下封层施工工艺及注意事项着重进行了介绍。实践表明,茂湛高速公路透层、下封层的施工是成功的,其间所取得的经验可供其他高速公路沥青混凝土路面施工时参考。 相似文献
38.
39.
40.