富春江船闸扩建改造工程创新设计与实践

针对碍航闸坝瓶颈问题,以富春江船闸为例,全面总结已建枢纽实施船闸扩建改造工程的主要关键技术与创新设计,包括保留原船闸并紧接新建一座大尺度船闸的总体布置、船闸结构设计、新老船闸衔接输水系统、老船闸加固改造、坝下施工围堰等,达到既满足通航安全要求,又避免对大坝安全、防洪安全、电站发电等不利影响,对解决我国众多枢纽船闸碍航问题具有典型示范作用。     

关于《钢质内河船舶建造规范》(2009)总纵强度问题的探讨

本文简要阐述了影响船舶总纵强度的主要因素,并对《钢质内河船舶建造规范》（2009）中将船舯剖面处的最小剖面模数表示成型深D的表达形式提出了自己的见解,并指出了总纵弯矩与中剖面最小剖面模数计算公式中的不协调。     

桥梁深水钻孔灌注桩施工技术

随着大型跨海、跨江桥梁的相继建设,桥梁跨度越来越大,对基础的要求也越来越高,超长、大直径的钻孔灌注桩已被广泛应用于大型深水桥梁建设中。结合工程实例,介绍大型桥梁深水钻孔灌注桩施工技术及其施工过程中的关键控制要点。     

Application of new parameterizations of gas transfer velocity and their impact on regional and global marine CO2 budgets

One of the dominant sources of uncertainty in the calculation of air–sea flux of carbon dioxide on a global scale originates from the various parameterizations of the gas transfer velocity, k, that are in use. Whilst it is undisputed that most of these parameterizations have shortcomings and neglect processes which influence air–sea gas exchange and do not scale with wind speed alone, there is no general agreement about their relative accuracy.The most widely used parameterizations are based on non-linear functions of wind speed and, to a lesser extent, on sea surface temperature and salinity. Processes such as surface film damping and whitecapping are known to have an effect on air–sea exchange. More recently published parameterizations use friction velocity, sea surface roughness, and significant wave height. These new parameters can account to some extent for processes such as film damping and whitecapping and could potentially explain the spread of wind-speed based transfer velocities published in the literature.We combine some of the principles of two recently published k parameterizations [Glover, D.M., Frew, N.M., McCue, S.J. and Bock, E.J., 2002. A multiyear time series of global gas transfer velocity from the TOPEX dual frequency, normalized radar backscatter algorithm. In: Donelan, M.A., Drennan, W.M., Saltzman, E.S., and Wanninkhof, R. (Eds.), Gas Transfer at Water Surfaces, Geophys. Monograph 127. AGU,Washington, DC, 325–331; Woolf, D.K., 2005. Parameterization of gas transfer velocities and sea-state dependent wave breaking. Tellus, 57B: 87–94] to calculate k as the sum of a linear function of total mean square slope of the sea surface and a wave breaking parameter. This separates contributions from direct and bubble-mediated gas transfer as suggested by Woolf [Woolf, D.K., 2005. Parameterization of gas transfer velocities and sea-state dependent wave breaking. Tellus, 57B: 87–94] and allows us to quantify contributions from these two processes independently.We then apply our parameterization to a monthly TOPEX altimeter gridded 1.5° × 1.5° data set and compare our results to transfer velocities calculated using the popular wind-based k parameterizations by Wanninkhof [Wanninkhof, R., 1992. Relationship between wind speed and gas exchange over the ocean. J. Geophys. Res., 97: 7373–7382.] and Wanninkhof and McGillis [Wanninkhof, R. and McGillis, W., 1999. A cubic relationship between air−sea CO2 exchange and wind speed. Geophys. Res. Lett., 26(13): 1889–1892]. We show that despite good agreement of the globally averaged transfer velocities, global and regional fluxes differ by up to 100%. These discrepancies are a result of different spatio-temporal distributions of the processes involved in the parameterizations of k, indicating the importance of wave field parameters and a need for further validation.     

钦州湾湾口填海对茅尾海水交换能力的影响

以溶解态的保守物质作为示踪剂,建立茅尾海水交换平面二维数学模型,采用开边界污染物浓度梯度与内侧一致假定考虑了边界污染物回归,计算分析了钦州湾湾口两侧大范围填海工程对茅尾海纳潮量和水体半交换周期的影响情况。研究表明：龙门海峡通道顺畅是维持茅尾海纳潮量的关键因素,湾口宽度保持9.4 km以上茅尾海内纳潮量和水体半交换周期基本不受湾口填海工程影响。     

防止电力机车进入无电单元(区)的安全预警方法

针对目前计划内接触网停电时电力机车进入无电单元(区)的问题,提出了基于动态停电作业区域数据对比库语音、屏幕鼠标点击坐标和高清成像分析进行"三元素二阶段"处理对比方法,以减少人员操作失误和损失.机车/车次信息及对应机车属性先由操作人员办理接发列预告(办理闭塞)的语音识别获取,再通过TDCS/CTC终端机非上位机获取并核对...     

软土地区地铁环境振动对精密仪器的影响研究

为评估软土地区地铁环境振动对精密仪器的影响,基于环境振动分析预测有限元仿真模型,模拟实际工况下距线路不同距离上的不同楼层内地板的振动响应.模拟计算分析表明,距隧道中心线20 m、50 m、100 m 3种工况中,距隧道中心线20 m、50 m的建筑物内振动超过精密仪器对环境振动的要求限值,距隧道中心线100 m的建筑物...     

混合动力汽车通信网络研究

阐述CAN规范和SAE J1939协议;SAE J1939是适用于货车和客车的应用层协议,对于混合动力汽车却没有统一的应用层协议。本文参照SAE J1939协议格式制定出适用于混合动力汽车(HEV)的应用层协议;结合混合动力汽车的控制特点,提出了CAN总线和LIN总线并用的双总线控制方法;通过实验测试了混合动力汽车CAN总线通信性能。实验结果表明,通信网络性能满足控制的实时性要求。     

一种单片机控制的水温测试系统

由于现代多样的电子控制技术和电子控制理论的迅猛发展,高精度的机械在各类工业控制系统、生产线等方面的需求越来越大.其中以单片机为核心实现的数字控制器,因其体积小、简便易行等优点,而被广泛应用于各行各业.本文将单片机的温度控制系统作为设计核心,通过温度传感器、单片机等软件系统图,并利用软件编程,从而达到实现水温控制的目的....     

渤中稠油乳状液的流变性实验研究

此项研究的目的在于揭示含水率、压力和温度等对稠油乳状液流变特性的影响.实验结果表明,油品乳状液的反相点大约在含水率70%左右,温度对乳状液黏度和流变性影响较为明显,压力对乳状液黏度和流变性影响不大.