FRP正弦波形夹心桥面板的等效有限元模型

以FRP正弦波形夹心桥面板作为研究对象,得到等效正交各项异性实心板,通过理论分析和数值对比,证明了方法的可行性;采用该法对一实际的FRP正弦波形夹心板桥进行了模态分析。     

Determination of Critical Slip Surface of Soil Slope

A new complex method is presented considering not only the improvement upon the ＂bad ＂design point, but also the diversity of the newly generated complex, which is obtained by replacing the ＂bad ＂design point with the better design point located at the line between the ＂bad ＂design point and the ceotroid of the remaining design points of the old complex. The new complex method is applied to searching for the critical slip surface of two non-homogeneous soil slopes. The comparison of the results obtained by the new complex method with that by the basic complex method shows that the new complex method is much more likely to find the true critical surface for the randomly generated initial complex.     

基于ANN星识别算法的仿真平台

星敏感器是一种高精确度的姿态测量仪器，它通过对观测到的星点进行识别来计算姿态。为了能够较好地测试和验证星识别系统的性能，设计了一个基于ANN算法的星识别仿真平台。通过对该星识别仿真平台性能的测试，表明该仿真平台能够方便，实时地测试星识别算法的性能与正确性，因此说它是一种具有较好实用价值的星识别仿真平台。     

浅层地下水开采对高速铁路工程的影响及对策

研究目的：研究掌握浅层地下水开采引起的地面沉降特征及其对高速铁路工程的影响,提出针对性的防治对策与工程措施,供高速铁路勘测、设计及施工参考。研究方法：结合华北平原地面沉降情况,建立浅层地下水开采引起地面沉降的固结沉降模型。研制离心场中地基抽水的模拟和测量系统,进行了离心模型试验,测量抽水过程中粉土地基孔隙水压力和沉降的变化及分布规律,并对比分析了对不同型式桥梁的影响。研究结果：对浅层地下水开采引起的地面沉降机理进行初步分析,基于离心模型试验结果探讨了浅层抽水引起地基沉降的过程和特征,评价了地基不均匀沉降对特殊桥梁形式的影响,并提出了针对性的防治措施和对策。研究结论：浅层地下水开采造成的不均匀沉降对高速铁路工程的影响较大,需通过控制线路附近地下水开采、采取适宜的工程结构措施加以防治。     

地铁屏蔽门系统构成分析

文章较详细地介绍了广州地铁使用的屏蔽门系统,重点是它的机械和电气部分的组成和作用.     

Mixed analysis of shell and solid elements using the overlaying mesh method

 This article presents a mixed method of analyzing shell elements and solid elements using the overlaying mesh method. In the structural design of a ship's hull, the shell elements are used for the global model. However, the solid elements are necessary to analyze the stress concentration zones or the vicinity of a crack. In such cases, the models are analyzed using zooming analysis, in which the results of a global model analysis are transferred to a local model analysis by imposing boundary conditions. This method is more advantageous than zooming analysis in terms of the accuracy of the solution and the modeling flexibility. Some examples of a plate model with a cracked surface or with a projection are shown in order to demonstrate the effectiveness of the method. Received: August 6, 2002 / Accepted: November 25, 2002 Address correspondence to: S. Nakasumi (sumi@nasl.t.u-tokyo.ac.jp) Updated from the Japanese original, which won the 2002 SNAJ prize (J Soc Nav Archit Jpn 2001;189:219–224; and 190:655–662)     

Numerical simulation of the flow about self-propelling tanker models

A time-marching CFD simulation is performed for self-propelling ships. The flow about the hull is simulated by the finite-volume method, and the propeller action is approximated as a propeller disk for which the solution is given by a simplified propeller model. The interaction of two flow models is treated in a time-marching procedure converging towards the steady self-propelling condition. This method is applied to five tanker models, and detailed comparisons are made between the simulated results and corresponding experimental results. It is shown that the flow field in the self-propelling condition is qualitatively well reproduced in the simulation, and the estimated thrust deduction factors for the five hull forms agree well with measured ones. However, the effective wake factors are underestimated, since the Reynolds number in the simulations differs from that in the experiment.     

装配式公路钢桥承载力的有限元分析

指出装配式公路钢桥设计中所采用的简化计算方法的不足,使用大型有限元软件ANSYS对其受力情况和承载力进行了分析,并与简化计算方法作了对比,得出了一些规律性的结论,对实际应用具有指导意义。     

高桩码头梁顶裂缝原因分析及控制技术

混凝土裂缝是困扰码头外观质量的“老大难”问题,而梁顶部位面层混凝土裂缝(简称梁顶裂缝)作为高桩梁板式码头中常见的质量通病,一直是工程技术人员的攻关课题。在宁波港北仑四期集装箱码头工程建设过程中,通过分析梁顶裂缝产生的原因,采取降低混凝土强度、梁顶部位割双缝等措施基本克服了梁顶裂缝,取得了较好的效果,也为同类工程提供了借鉴。     

同步发电机参数辨识的相关方法探讨

随着电网安全及稳定运行问题的重要性日益突出,基于获得准确的系统模型和参数辨识方法,优化同步发电机相关参数将是十分有意义的。本文针对当今几种比较典型的参数辨识方法做了系统的介绍,通过比较得出何种方法对于同步电机的参数辨识是最适合的。