悬臂板在集中荷载作用下的弯矩计算方法

推导了悬臂板结构在矩形荷载、三角形荷载、圆形荷载、多边形荷载等集中荷载作用下,在规范建议的荷载有效分布宽度内的弯矩计算公式。     

基于OLC拐点的车体结构较优设计

基于OLC理论,研究了正面碰撞中车体结构设计与乘员损伤的关联性.基于56 km/h正面刚性壁障(Frontal Rigid Barrier,FRB)碰撞工况,通过二阶波简化得到一阶加速度a1、二阶加速度a2、动态位移D三个车体结构设计指标.分析了不同车体结构设计指标与OLC的关系,发现在D不变的情况下,当a1≤215....     

瞬态瑞雷波在地层勘探中的应用

根据瞬态瑞雷波的传播特性和测试原理,使用振动及动态信号采集分析系统采集分析了测试工点的瑞雷波信号,并得到了测试工点的地层分布情况和各层的物理特性.     

A second order volume of fluid （VOF） scheme for numerical simulation of 2-D breaking waves

Among all environmental forces acting on ocean structures and marine vessels, those resulting from wave impacts are likely to yield the highest loads. Being highly nonlinear, transient and complex, a theoretical analysis of their impact would be impossible without numerical simulations. In this paper, a pressure-split two-stage numerical algorithm is proposed based on Volume Of Fluid (VOF) methodology. The algorithm is characterized by introduction of two pressures at each half and full cycle time step, and thus it is a second-order accurate algorithm in time. A simplified second-order Godunov-type solver is used for the continuity equations. The method is applied to simulation of breaking waves in a 2-D water tank, and a qualitative comparison with experimental photo observations is made. Quite consistent results are observed between simulations and experiments. Commercially available software and Boundary Integral Method (BIM) have also been used to simulate the same problem. The results from present code and BIM are in good agreement with respect to breaking location and timing, while the results obtained from the commercial software which is only first-order accurate in time has clearly showed a temporal and spatial lag, verifying the need to use a higher order numerical scheme.     

Variational principles in water-wave problems (wave radiation conditions and their variational treatment)

To discuss water-wave problems in unlimited waters, it is important to know what type of wave radiation condition should be placed on a virtual surface corresponding to infinity. For this kind of problem, the Sommerfeld radiation condition is well known. In this article, the condition is extended to treat a case with an incident wave. Furthermore, a more general wave radiation condition is introduced from a different point of view. The above-mentioned wave radiation conditions are introduced into the variational principles of the Kelvin, Hellinnger–Reissner, and Dirichlet type. The Dirichlet-type variational principles are then used in numerical calculations for bending waves in a bar, and the effectiveness of the wave radiation conditions and the variational principles is shown. The numerical results for one-dimensional water-wave problems are then given. As expected, the region required for the numerical solution is reduced drastically compared with that required by the Sommerfeld-type formulation. Furthermore, the amplitude of the diverging wave is obtained in the process of reaching the variational solution. Finally, two-dimensional water-wave problems are briefly discussed. Received: August 9, 2001 / Accepted: September 17, 2001     

京唐港泥沙淤积原因分析

论述了京唐港海区的水动力条件和环境泥沙特性 ,在此基础上 ,对京唐港的泥沙淤积原因进行了分析 ,并由此得出结论 :现状下京唐港平面布局有效地抑制了泥沙的集中淤积现象 ,降低了骤淤碍航的可能性     

航海安全水池三维造波机造波特性与实际波浪模拟应用

对船研所风、浪、流水池造波机的皮特性结合具体工程试验提供一些基本测试参数和使用范围,以波谱形式给出二维不规则波模拟结果,便于今后使用时进行参考。     

波、流共存时的床面剪切力

利用边界层理论 ,导出了波、流共存时的床面剪切力 ,得出综合摩阻系数、综合速度和综合摩阻速度计算公式     

电磁馈能悬架作动器设计

为了实现电磁馈能悬架减振与能量回收的目的,将永磁直线电机作为悬架的作动器.以传统筒式减振器为试验对象,设计了一种圆筒型直线式作动器,对作动器各部分结构尺寸进行了设计,并对作动器进行了仿真分析.结果表明:设计的永磁直线作动器电磁力在均值为330N,磁场分布均匀,满足作动器设计要求.     

电动客车轮边驱动电机的转矩分配控制策略研究

轮边驱动电机采用轮毂电机,实现四轮独立驱动,方便汽车动力学性能的控制。对于电动客车,轮边电机驱动以其轻量化、传递效率高等优势正在取代中央直驱的方式,成为现在研究的热点。这种驱动方式取消了离合器和变速器等,驱动电机安装在车轮旁边,结构空间和重量得以大幅度降低电。文章以四轮独立驱动的轮毂电机电动客车为研究对象,通过驱动转矩的合理分配,保证其有最佳的动力性和经济性。