Liner shipping network design with emission control areas: A genetic algorithm-based approach

To curb emissions, containerized shipping lines face the traditional trade-off between cost and emissions (CO₂ and SO_x) reduction. This paper considers this element in the context of liner service design and proposes a mixed integer linear programming (MILP) model based on a multi-commodity pickup and delivery arc-flow formulation. The objective is to maximize the profit by selecting the ports to be visited, the sequence of port visit, the cargo flows between ports, as well as the number/operating speeds of vessels on each arc of the selected route. The problem also considers that Emission Control Areas (ECAs) exist in the liner network and accounts for the vessel carrying capacity. In addition to using the MILP solver of CPLEX, we develop in the paper a specific genetic algorithm (GA) based heuristic and show that it gives the possibility to reach an optimal solution when solving large size instances.     

Modeling free-flow speed according to different water depths—From the viewpoint of dynamic hydraulic pressure

In this paper, we propose a method of modeling free flow speed from the viewpoint of hydroplaning. First, the lift forces for different water depths were estimated using Bernoulli’s equation. Compared with the result of the experimental test performed by the Japan Automobile Research Institute, the hydrodynamic pressure coefficient was determined to be 0.03 (tf s²/m⁴). The validation of the predicted lift force is found in another published paper. A very good match is found between the computed values by the proposed numerical model and the data in other published papers. Then, the loss of contact force is considered to evaluate the hydroplaning performance of a tire. To simulate the hydroplaning speed, a tire-sliding model was utilized to obtain the traction and friction forces between the road surface and the tire. The observation data obtained in Japan in 2009 is compared with the physically computed hydroplaning speed, yielding the conclusion that the traction force at the measured desired speed is, on average, 23.4% of the traction force at hydroplaning speed. The analytical model offers a useful tool to quantitatively show that the free flow speed changes as the water depth increase.     

兰州地铁地温分布特性及其演化规律

以兰州地铁所在地区为研究对象,实测地铁隧道开挖前的地温(简称为初始地温),根据实测数据,提出地铁初始地温预测模型公式。采用非稳态传热的数值模型,分析运营条件下地铁隧道围岩温度的演化规律。结果表明:兰州地铁初始地温随环境气温和埋深的变化而变化;年变温层位于自地表至埋深12m处;年恒温层位于埋深12m及其以下,温度为15℃左右;年变温层中,1年内初始地温变化规律与环境气温变化规律相似,近似呈正弦曲线状分布,但存在相位滞后的现象;1年中初始地温的振幅随埋深的增大呈指数下降趋势。在隧道内空气与围岩之间热交换中,兰州地铁隧道围岩的温度及其梯度、热透厚度(未达到极限时)均与隧道内环境温度、热交换时间成正相关关系,但与距隧道内壁的距离成负相关关系。     

双块式轨枕外形质量快速检测系统研制及应用

SK?2型双块式混凝土轨枕是高速铁路无砟轨道结构中的重要预制件,单一生产厂日均产量达到800~1400根,但目前的人工检测方式无法满足双块式轨枕的出厂检验要求。本文提出的双块式轨枕外形质量快速检测系统可满足TB/T 3397—2015《CRTS双块式无砟轨道混凝土轨枕》的出厂检验要求,与双块式轨枕生产线相匹配,大大提高了检测效率,实现了双块式轨枕全参数、自动化、智能化检测。检测数据自动上传至生产管理平台,可对双块式轨枕生产质量进行跟踪管理。     

无线调车机车信号和监控系统实际应用中无线通信解决方案研究

在配有无线调车机车信号和监控系统(STP)的铁路车站,如果站场存在高建筑物、山体、多隧道、特长隧道等特殊情况,会使车地无线通信出现信号弱或者无信号现象。针对这些特殊站场情况,给出几种无线通信解决方案,并在实际工程项目中有效地解决信号弱或者无信号问题。     

The identification and empirical characterization of vehicular (Lagrangian) fundamental diagrams in multilane traffic flow

Traditional macroscopic traffic flow modeling framework adopts the spatial–temporal coordinate system to analyze traffic flow dynamics. With such modeling and analysis paradigm, complications arise for traffic flow data collected from mobile sensors such as probe vehicles equipped with mobile phones, Bluetooth, and Global Positioning System devices. The vehicle‐based measurement technologies call for new modeling thoughts that address the unique features of moving measurements and explore their full potential. In this paper, we look into the concept of vehicular fundamental diagram (VFD) and discuss its engineering implications. VFD corresponds to a conventional fundamental diagram (FD) in the kinematic wave (KW) theory that adopts space–time coordinates. Similar to the regular FD in the KW theory, VFD encapsulates all traffic flow dynamics. In this paper, to demonstrate the full potential of VFD in interpreting multilane traffic flow dynamics, we generalize the classical Edie's formula and propose a direct approach of reconstructing VFD from traffic measurements in the vehicular coordinates. A smoothing algorithm is proposed to effectively reduce the nonphysical fluctuation of traffic states calculated from multilane vehicle trajectories. As an example, we apply the proposed methodology to explore the next‐generation simulation datasets and identify the existence and forms of shock waves in different coordinate systems. Our findings provide empirical justifications and further insight for the Lagrangian traffic flow theory and models when applied in practice. Copyright © 2015 John Wiley & Sons, Ltd.     

高速铁路轨道的波阻抗及影响因素研究

高速铁路轨道在雷击或故障冲击电流作用下会产生暂态冲击过电压,该过电压的大小由轨道的波阻抗决定。通过建立高速铁路线路的仿真模型,分析直角冲击波在轨道上的传播与折反射过程,提出轨道的波阻抗的计算方法,研究钢轨类型、土壤电阻率、钢轨对地过渡电阻对波阻抗的影响。结果表明:P60型轨道波阻抗数值为235. 55Ω;轨道的波阻抗主要受钢轨类型和土壤电阻率的影响,高速铁路轨道的波阻抗在在210～250Ω变化;在高速铁路轨道仿真模型中,线路末端电阻等于波阻抗时,可以有效地消除折反射对仿真结果的影响,末端电阻的取值不需要考虑钢轨地过渡电阻的影响。研究给出高速铁路轨道波阻抗的范围及仿真模型中末端电阻的取值方法,可以为轨道过电压计算、分析与仿真提供理论与方法参考。     

冲压机械振动对高铁桥梁及行车动力影响分析

高速铁路桥梁的平顺性和稳定性对运营列车的平稳性和安全性有很大影响。为研究冲压机械产生的外部振动激励对高铁桥梁的影响,首先通过对此机械引起的地面振动进行实测,并结合有限元分析软件,确定最大冲击荷载作用下产生的地面振动及传播至桥墩处的振动;然后通过建立列车-轨道-桥梁耦合动力学模型,将桥墩处的地面振动作为激励输入,分析列车以不同速度通过时车辆、桥梁动力学响应。结果表明:地面冲击振动有限元模型计算结果与实测结果基本相符,验证了模型的可靠性;地面振动对桥梁响应会产生一定的影响,距振源50 m处地面振动对桥梁所产生的影响较距振源80 m处(桥墩处)的大,但对运行车辆的影响很小;随着车速由250 km/h至350 km/h,车辆及桥梁各结构的动态响应均有所增大,但都未超出安全限值。因此,冲压机械冲击作用导致的地面振动对列车-轨道-桥梁系统动态服役性能影响非常有限。     

某型汽轮机超速脱扣试验浅析

某型汽轮机的超速保护装置采用脱扣结构,文章针对该汽轮机的超速脱扣结构进行分析,总结此种超速脱扣装置的装配要求和试验方法,以利于该型汽轮机的生产。     

海上风电大直径单桩基础固有频率影响因素的数值分析

针对海上风电整机结构其低阶固有频率的控制问题,基于有限元分析技术开展小直径桩土相互作用的数值模拟分析,与试验结果、API规范计算结果进行对比,验证了数值模型的适用性,分析大直径单桩结构桩内土芯、冲刷深度、表层土置换措施对整机固有频率的影响,结果表明,基于有限元实体单元计算所得一、二阶整机固有频率要明显大于传统p-y方法计算结果;桩内土芯对一、二阶整机固有频率影响很小;在一定范围内,随着泥面冲刷深度的增加,一、二阶固有频率降低不明显,认为传统p-y方法对于大直径单桩的适用性有待研究;在实际工程设计中,桩内土芯的影响可忽略;对于大直径单桩,在一定范围内可以忽略冲刷的影响。