盾构法隧道纵向地震响应特性

采用土—结相互作用的动力有限元法,引入无长度的3自由度弹簧单元模拟纵向螺栓接头,分析行波波长、地基刚度与阻尼对盾构法隧道纵向地震响应的影响。分析结果表明:行波从水平方向输入时有突变弯矩产生,突变弯矩随波长和阻尼的增大而减小,而地基刚度系数对突变弯矩的影响相对较小;行波作用下,产生的接头最大轴力及最大弯矩值均随波长的增大而减小,而地基刚度系数及阻尼系数取值对最大弯矩值的影响较小。因此,建议在实际工程设计计算中要重视输入地震动参数的选择,且取较小的阻尼系数。     

转臂轴箱定位节点位置对机车动力学性能影响分析

利用SIMPACK建立某出口2B0机车动力学模型,分析了转臂轴箱定位节点的纵向位置对机车动力学性能的影响.研究表明节点纵向位置对机车横向稳定性有较显著影响,而对机车直线和曲线通过性能影响不大.得出了在动力学模型中,需要把转臂作为一个单独元件考虑,以减小计算误差的结论.     

钢轨焊前轨端轨腰裂纹造成焊接接头伤损的研究

通过对多起焊接接头伤损典型案例的分析研究,综合描述几种轨腰裂纹的断裂形态以及裂纹源区的断口宏观形貌、金相组织等典型特征,确定在焊接前轨端存在轨腰裂纹是导致接触焊焊接接头形成轨腰纵向、斜向裂纹和横向断裂的主要原因,并分析讨论了轨端、轨腰裂纹产生的原因。     

A review of the Effect of α/W ratio on fracture toughness （Ⅱ） experimental investigation in LEFM

In part I of this series, experimental investigation in EPFM （elastic-plastic fracture mechanics） had been discussed. In this paper, experimental investigation in LEFM （ linear elastic fracture mechanics） is given. Fracture toughness tests had been carried out on three different strength steels, using both through-cracked specimens with different α/W ratio and semi-elliptical cracked specimens with variable crack size and shape. Results show that the fracture toughness KIC increases with decreasing α/W when α/W 〈 0.3 for three-point-bend specimens, and that for α/W 〉 0.3, it is independent of α/W. Shallow crack specimens, both through-cracked and surface-cracked, gave markedly higher values than deeply notched specimens. However, the effect of crack shape on fracture toughness is negligible. Results also show that the LEFM approach to fracture is not tenable for design stresses where αc is often very small, far less than 2.5 （ KIC/σy）^2.