缓波型非粘接柔性立管的干涉敏感性

针对非粘接柔性立管在波浪和海流作用下易发生立管干涉的问题,以我国南海某油田输油立管和相邻锚链为例,分别对拖曳力系数、管道单位长度质量、外径、内部介质密度、立管抗拉弯扭刚度和悬挂角度等参数进行敏感性分析,得出不同参数的敏感性情况,并在此基础上提出一些建议供实际工程设计参考.     

液压式盾构/TBM主机平移-空推集成装置的研制

研究目的:目前,隧道掘进机平移与空推工艺多采用不同装置分步完成,装置安装耗时费力,严重影响项目施工进程,且国内外没有可同时解决掘进机主机平移和空推的工法或装置。本文研制了一种基于液压的盾构/TBM主机平移-空推集成装置,将平移与空推工序合一,可极大提高工程施工效率,实现荷载600 t盾构/TBM主机连续移位。研究结论:(1)利用液压力驱动液压马达实现装置移位和驱动轮90°转向,实现了平移与空推工艺集成;(2)多轮系和从动轮碟簧设计可优化载荷分布,从动轮选用自润滑推力关节轴承使装置可适应一定倾斜度和不平度,提升装置运行平稳性;(3) 600 t荷载下,利用聚氨酯包敷于钢轮外的复合轮设计减小了轮系与地面接触应力,降低地面要求;(4) ANSYS仿真分析表明承载台架满足强度要求;(5)目前该装置已成功应用于青岛地铁8号线项目,缩短工期20 d,填补了国内外技术空白,应用前景广阔。     

南昌地铁砾砂层渣土改良技术试验研究

随着土压平衡盾构的广泛推广和应用,其地层适应性也越来越强,但盾构机在一些特殊地层中掘进时,渣土无法满足盾构施工对渣土流塑性的要求,易造成刀盘结饼、掌子面压力不稳定、刀盘磨损严重等问题。泡沫渣土改良技术是保证施工安全、顺利进行的关键技术之一。本文针对两种工程现场常用的泡沫进行泡沫基础性能试验,并以南昌地铁3号线盾构区间为工程背景,针对该区间砾砂地层进行改良渣土坍落度试验,对不同注入率和不同发泡剂的改良效果进行分析。研究发现,两种泡沫剂的建议使用浓度为3%;渣土流动性随泡沫注入率的增大而提高。在试验所用土样条件下,建议施工时使用的泡沫注入率为20%~30%。     

深海超高压环境模拟容器裂纹评定

深海超高压环境模拟容器用于模拟水下压力环境,其容器壁上承受反复载荷,容易产生疲劳裂纹.疲劳裂纹扩展是影响其断裂的主要因素.本文旨在分析半椭圆裂纹在老化的深海超高压环境模拟容器中的扩展行为,评估容器的安全性,因此对材料20MnMoNb钢的裂纹扩展特性进行了试验研究,首先考虑三角形和梯形加载情况,通过比较两组实验结果,考察了其材料对保载时间的敏感性.采用基于统一的裂纹扩展率模型的三维有限元方法进行了疲劳裂纹扩展计算,并通过CT试样的一组数值和实验结果进行了验证,最后建立了不同初始尺寸、展弦比和倾角的裂纹有限元模型,并根据裂纹在容器内壁的容许深度准则,计算了容器的剩余寿命.其分析结果可为深海超高压环境模拟容器可靠性评估提供参考.     

Structural safety assessment procedure for membrane-type LNG CCS considering hydroelasticity effect

As environmental regulations have become more onerous, the demand for LNG and LNG carriers has increased. The LNG cargo containment system (LNG CCS) is one of the most important facilities in LNG carriers, and many membrane types of LNG CCS have been developed so far. Traditionally, sloshing model tests are performed and a series of statistical approaches are used to obtain design sloshing pressures. Then, these design loads are utilized to analyze the structural safety of LNG CCS. In the sloshing model test, the flat and almost rigid plate is used as the LNG CCS instead of a real model, and thus, the hydroelasticity effect cannot be considered. In the present research, the effect of hydroelasticity on sloshing pressure was investigated in a fluid-structure interaction simulation. A wet drop simulation was conducted, and its results subsequently were compared with wet drop experimental test results to ensure their validity. Then, two types of structure model, namely a flat-rigid plate model and a flat-flexible CCS model, were generated to investigate the effect of hydroelasticity. Also, a fluid hitting analysis model was devised to realize the sloshing phenomenon, and the two generated structure models were applied as the structure domain in the analysis. In the fluid hitting simulations, it was found that the hydroelasticity effect on sloshing pressure is significant. Thus, correction factors, which are quantitative values of the effect of hydroelasticity, were derived (and are proposed herein). Finally, a structural safety assessment procedure for consideration of the hydroelasticity effect was derived (and is suggested herein).     

隧道爆炸冲击波的危害及控制措施

目前山岭隧道施工基本以钻爆法为主,爆破过程中产生的冲击波会对隧道内的人员及机械设备安全产生较大影响,造成重大安全事故和财产损失。本文主要介绍了冲击波在隧道内传播会形成超压,且随着传播距离增加超压峰值逐渐衰减到大气压范围内;基于超压准则评估了冲击波对人体、隧道内设施及周边建筑物的危害程度;通过在隧道内安装简易的冲击波缓冲装置及加强监测、设置安全警戒线等控制措施,减弱了爆破冲击波的危害,从而达到安全快速施工的目的。     

25t轴重荷载作用下隧底脱空区域受力特性分析

为了研究在役铁路隧道在通车之后隧底脱空病害的问题,采用有限元理论,建立隧道脱空区域在围岩压力与25 t轴重列车动载作用下的数值计算模型,主要研究80 cm与40 cm脱空宽度分别距隧道中心线0,80 cm与160 cm时脱空区域的受力特性。结果表明:在围岩压力下,脱空区域中线上壁和外侧顶角混凝土中产生拉应力及内侧顶角中产生压应力,其中压应力对脱空的宽度更为敏感;同时施加列车动载作用时,脱空区域上壁出现了竖向动应力与横向拉应力,得到了脱空区域力学指标的最大响应值及其出现的具体位置,宽度的增加对脱空区上壁横向拉应力更为显著,上壁横向拉应力增幅超过200%,竖向动应力增幅达50%。因此,隧底脱空区周围应力分布复杂,拉应力与压应力在脱空区域同时存在,应力突变严重,对脱空现象应及时组织处理。     

高速铁路轨道的波阻抗及影响因素研究

高速铁路轨道在雷击或故障冲击电流作用下会产生暂态冲击过电压,该过电压的大小由轨道的波阻抗决定。通过建立高速铁路线路的仿真模型,分析直角冲击波在轨道上的传播与折反射过程,提出轨道的波阻抗的计算方法,研究钢轨类型、土壤电阻率、钢轨对地过渡电阻对波阻抗的影响。结果表明:P60型轨道波阻抗数值为235. 55Ω;轨道的波阻抗主要受钢轨类型和土壤电阻率的影响,高速铁路轨道的波阻抗在在210～250Ω变化;在高速铁路轨道仿真模型中,线路末端电阻等于波阻抗时,可以有效地消除折反射对仿真结果的影响,末端电阻的取值不需要考虑钢轨地过渡电阻的影响。研究给出高速铁路轨道波阻抗的范围及仿真模型中末端电阻的取值方法,可以为轨道过电压计算、分析与仿真提供理论与方法参考。     

复杂城市环境泥水盾构泥浆绿色处理技术分析

泥水平衡盾构法修建隧道,在施工阶段会产生大量的废浆,如果废浆没有得到科学、妥善的处理,对环境的污染是无法估计的。本文以新建京张高铁清华园隧道工程为依托,结合在城市复杂繁华地区施工场地狭小、泥浆处理难度大等工程难题,对盾构掘进产生的废弃泥浆绿色处理技术进行了适应性研究,分析了综合处理之后泥浆循环利用的应用效果。泥水处理设备、压滤设备及离心设备相结合的泥浆综合处理技术,有效地实现了盾构施工"零排放",为今后类似施工条件的工程提供了技术参考。     

A comparative life-cycle energy and emissions analysis for intercity passenger transportation in the U.S. by aviation,intercity bus,and automobile

Intercity passenger trips constitute a significant source of energy consumption, greenhouse gas emissions, and criteria pollutant emissions. The most commonly used city-to-city modes in the United States include aircraft, intercity bus, and automobile. This study applies state-of-the-practice models to assess life-cycle fuel consumption and pollutant emissions for intercity trips via aircraft, intercity bus, and automobile. The analyses compare the fuel and emissions impacts of different travel mode scenarios for intercity trips ranging from 200 to 1600 km. Because these modes operate differently with respect to engine technology, fuel type, and vehicle capacity, the modeling techniques and modeling boundaries vary significantly across modes. For aviation systems, much of the energy and emissions are associated with auxiliary equipment activities, infrastructure power supply, and terminal activities, in addition to the vehicle operations between origin/destination. Furthermore, one should not ignore the embodied energy and initial emissions from the manufacturing of the vehicles, and the construction of airports, bus stations, highways and parking lots. Passenger loading factors and travel distances also significantly influence fuel and emissions results on a per-traveler basis. The results show intercity bus is generally the most fuel-efficient mode and produced the lowest per-passenger-trip emissions for the entire range of trip distances examined. Aviation is not a fuel-efficient mode for short trips (<500 km), primarily due to the large energy impacts associated with takeoff and landing, and to some extent from the emissions of ground support equipment associated with any trip distance. However, aviation is more energy efficient and produces less emissions per-passenger-trip than low-occupancy automobiles for trip distances longer than 700–800 km. This study will help inform policy makers and transportation system operators about how differently each intercity system perform across all activities, and provides a basis for future policies designed to encourage mode shifts by range of service. The estimation procedures used in this study can serve as a reference for future analyses of transportation scenarios.