某船右主机不能正常建立滑油压力的故障排除

文章对某船右主机启动过程中,机带滑油泵不能正常建立滑油压力进行了分析,制定了针对性的排除故障措施,通过在机带滑油泵通舱管吸入口处安装吸入止回阀解决了滑油压力非正常下降的故障,实船应用证明措施合理,对同类故障排除有较好的借鉴意义。     

Did Chinese cities that implemented driving restrictions see reductions in PM10?

Imposing driving restrictions is becoming increasingly popular as a policy intended to control urban air pollution. Existing studies on this topic offer highly mixed observations, and each study tends to focus on only one city. In this paper, we used 11 Chinese cities with driving restrictions as the treatment group, and compared them to other cities that did not implement the policy. Based on a propensity score matching and difference-in-difference analysis, we found no evidence of a decrease in PM10 concentrations in cities after they implemented driving restrictions. This finding may be attributed to an increase in the number of cars in these cities after implementing driving restrictions, but we also found no evidence of an improvement in air quality for a given number of cars after implementation of the policies.     

Simulating the air quality impacts of traffic calming schemes in a dense urban neighborhood

In this study, the effects of isolated traffic calming measures and area-wide calming schemes on air quality in a dense neighborhood were estimated using a combination of microscopic traffic simulation, emission, and dispersion modeling. Results indicated that traffic calming measures did not have as large an effect on nitrogen dioxide (NO₂) concentrations as the effect observed on nitrogen oxide (NO_x) emissions. Changes in emissions resulted in highly disproportional changes in pollutant levels due to daily meteorological conditions, road geometry and orientation with respect to the wind. Average NO₂ levels increased between 0.1% and 10% with respect to the base-case while changes in NO_x emissions varied between 5% and 160%. Moreover, higher wind speeds decreased NO₂ concentrations on both sides of the roadway. Among the traffic calming measures, speed bumps produced the highest increases in NO₂ levels.     

Empirical estimation of price and income elasticities of air cargo demand: The case of Hong Kong

This paper estimates the price and income elasticities of air cargo demand and examines how they may change after the 2008 financial crisis. Using a set of time series data, we simultaneously estimate the aggregated demand and supply functions of air cargo at Hong Kong International Airport (HKIA). We find that during the entire sampling period of 2001–2013, the price elasticity for air cargo transport demand at HKIA ranges from −0.74 to −0.29, suggesting that air cargo demand in Hong Kong reacts negatively to price (as expected) but does not appear to be very sensitive to price. The income elasticity ranges from 0.29 to 1.47 and appears sensitive to seasonality adjustment approaches. However, in terms of the speed of changes, air cargo demand changes much faster than overall economy, indicating the presence of a pro-cyclical pattern of air cargo traffic with respect to the overall economy. Our analysis shows that air cargo demand becomes more sensitive to changes in both price and income after 2008.     

Airport capacity increase via the use of braking profiles

Many airports are encountering the problem of insufficient capacity, which is particularly severe in periods of increased traffic. A large number of elements influence airport capacity, but one of the most important is runway occupancy time. This time depends on many factors, including how the landing roll procedure is performed. The procedure usually does not include the objective to minimize the runway occupancy time. This paper presents an analysis which shows that the way of braking during landing roll has an essential impact on runway throughput and thus on airport capacity. For this purpose, the landing roll simulator (named ACPENSIM) was created. It uses Petri nets and is a convenient tool for dynamic analysis of aircraft movement on the runway with given input parameters and a predetermined runway exit. Simulation experiments allowed to create a set of nominal braking profiles that have different objective functions: minimizing the runway occupancy time, minimizing noise, minimizing tire wear, maximizing passenger comfort and maximizing airport capacity as a whole. The experiments show that there is great potential to increase airport capacity by optimizing the braking procedure. It has been shown that by using the proposed braking profiles it is possible to reduce the runway occupancy time even by 50%.     

钢檩条设计中的若干问题

轻型屋面钢檩条的竖向荷载、整体稳定性计算以及檩条与屋面梁、屋架的连接构造是设计的重要环节,本文结合规范和国家标准设计图的编制提出若干问题,供参考.     

软土地层盾尾注浆压力引起的地面隆起分析

目前已有盾尾注浆压力引起地面隆起的研究均假定盾尾注浆压力均匀分布,这与实际工程中盾尾注浆压力上小下大的形式不符。为更准确预测盾尾注浆压力引起的地面变形,在现有均匀注浆压力引起地面隆起分析的基础上,考虑软土地层盾构隧道施工中盾尾注浆压力上小下大的分布形式,将盾尾注浆对地层的压力效应视为半无限土体中柱形孔的扩张过程,利用镜像法和Mindlin解,推导出软土地层盾尾注浆压力引起的地面隆起计算公式,并通过工程实例,将本文解答、叶飞解答、林存刚经验公式解答、Vesic解答与数值解进行对比分析。结果表明:盾尾注浆压力引起的地面隆起横向曲线总体上呈高斯分布。在预测软土地层地面沉降时,忽视盾尾注浆压力引起的地面隆起是不合理的;用推导出的公式计算上小下大分布形式下盾尾注浆压力引起的地面沉降是可行的,Vesic公式和林存刚经验公式在应用时需要根据具体工程进行相应修正。     

土压平衡盾构施工中泡沫改良砾砂土的试验研究

为了解决土压平衡盾构在砾砂土地层掘进过程中,土体塑流性差、刀盘及螺旋输送机磨损严重和开挖面平衡不易保持等问题,通过自制泡沫发生器发泡,对砾砂土地层的泡沫改良技术进行室内试验研究,分析气液比、含水率和泡沫掺量对塑流性的影响和改良前后土样的渗透系数的变化规律,得出泡沫发生器气液比在30∶1~55∶1、含水率为5%~12.5%、泡沫掺量为20%~40%时,土体具有较好的塑流性,泡沫的"轴承效应"和泡沫剂中表面活性剂的亲水基团与水、砾砂土颗粒形成的氢键是塑流性提高的根本原因;使用泡沫剂改良砾砂土后,渗透系数大幅降低,掺泡沫后在280 min内渗透系数随时间变化较小,能达到10~(-5)cm/s,泡沫剂溶液中高分子化合物的联结和液桥力是土样具有堵水作用的原因。     

漫谈矿山法隧道技术第十四讲——隧道涌水及其控制方法

分析制定隧道控制地下水对策的基本观点:既要考虑隧道施工对地下水的影响,也要考虑地下水对隧道施工的影响。指出控制地下水的对策必须符合3个条件:1)确保施工作业安全、顺利地开展;2)不对周边环境产生有害的影响;3)以合理的工费和工期来实现。隧道涌水视其发生位置、涌水量、发生时期、涌水量的历时变化等是各种各样的,应对隧道涌水进行合理分类,以便有的放矢地采取相应的对策。介绍了日本统计的地质构造和涌水现象的分类。涌水处理应达到3个基本目标:1)确保隧道施工在无水的条件下进行,或者是在可以接受的渗漏水条件下进行,或者是在对周边环境"可接受干扰"的条件下进行;2)二次衬砌原则上不承受水压作用,不得已时把水压控制在二次衬砌容许的范围内;3)运营中的隧道洞内不能成为地下水流经的通道,隧道衬砌背后必须形成一个纵横交错的、不易堵塞的、通畅的排水系统。达到上述目标的基本方法是:充分利用和提高围岩的隔水性能,合理地处理好"排"与"堵"的关系。针对涌水处理的3个基本目标,分别介绍了国内外相应的经验和措施。1)一些国家的指南、标准对隧道的涌水量进行了分级,认为涌水量≤2.5 L/(min·m)时基本上可以认为是在无水条件下施工;一般的线状流水、经常涌水可以用自然排水法排水;而针对突发大量涌水,则需要采取特殊的地下水对策予以解决。2)按照二次衬砌是否承受水压,隧道可分为3种情况:1衬砌不承受水压,即所谓的完全排水型隧道;2衬砌承受全部水压,即所谓的非排水型(防水型)隧道;3衬砌背后设置注浆域,分担衬砌承受的水压,衬砌只承受部分容许的水压。从目前的隧道设计实际来看,在山岭隧道中多数采用方案1,在城市隧道中多数采用方案2,在高水压和突发大量涌水的极端情况下采用方案3。介绍了日本、美国的设计经验。3)我国铁路隧道采用把地下水引入隧道,再从洞内两侧边墙附近设置的排水沟排出地下水的做法是值得商榷的;特别是在可能发生冻害的地区,更不可取。在国外,日本、德国、法国等国家的铁路、公路隧道基本上是把中央排水管设置在仰拱内或仰拱下方,而在隧道两侧只留有用于排出流入隧道内的雨水或隧道清洗水的排水沟;因此,建议立项研究取消洞内排水沟,设置中央或两侧脚部排水管的问题。最后指出,实现涌水处理的3个基本目标我们尚需努力,特别是"目标"的定位问题,尚需进行基础性的研究才能解决。在隧道施工中,涌水是不可避免的、客观存在的现象,我们积累的经验非常丰富,但缺乏系统的、认真的总结和归纳。     

超高压共轨系统轨压控制策略研究

为稳定控制超高压共轨系统中的共轨腔压力并缩短轨压控制算法的开发周期,利用AMESim/Simulink联合仿真技术建立了超高压共轨系统轨压控制仿真模型,采取前馈+PID控制算法设计了轨压控制策略,并针对轨压控制中的瞬态和稳态工况进行了仿真计算,最后在试验台架上开展了轨压跟随性测试。结果表明:所制定的前馈+PID控制算法能使轨压稳定在目标轨压附近,上下波动小于3 MPa,且轨压突变时瞬态响应时间小于0.5s,控制结果能够满足超高压共轨系统对精度和速度的需求。