基于分段单孔反演的隧址区多断层地应力分布特征

目前，针对具有多个原位地应力测试钻孔的隧址区初始地应力场反演，往往一次性将全部实测值用以计算值的回归反分析，没有考虑到隧道纵向长度远超其他方向且钻孔分布较远的特点，单个钻孔表征的临近区域地应力分布特征或反演精度被其余钻孔实测值“拉低”，导致整体反演结果容易陷入局部优解。依托拉林铁路桑珠岭隧道、叙毕铁路斑竹林隧道、沿江高速火山隧道、木寨岭公路隧道等工程，采用多元线性回归法结合最小二乘法寻优准则，分析了隧址区仅有单个钻孔反演精度较高的原因，提出了对具有多个钻孔的隧址区分段并分别进行单钻孔回归反演的新方法。在此基础上，重点讨论了木寨岭公路隧道断层破碎带区域地应力分布特征。结果表明：分段单孔反演较多孔反演进一步提高了反演精度；地应力的分布在断层前后呈现出先急剧增大后急剧减小的特征；除自重应力与埋深存在一定关联外，两项水平主应力随断层间距或厚度的增大突变性加剧；断层之间间距、断层倾角、断层厚度均是影响地应力方向偏转大小的重要因素，断层之间间距或断层倾角越小、断层越厚，地应力方向偏转越显著。     

含初始变形船体加筋板有效宽度及剩余极限强度研究

为了评估舰船结构损伤后的剩余强度,对船体加筋板出现初始几何变形后,参与总纵强度的有效宽度和加筋板剩余极限强度进行研究。将加筋板受到垂直于平面压力后的变形,作为其初始几何变形,改变变形的方向和大小,利用有限元软件Ansys对加筋板结构进行线性和非线性分析。定义了板有效宽度计算方法,对不同变形方向和变形幅值时板的有效宽度和加筋板的极限强度进行对比分析,并拟合得到了计算板有效宽度和加筋板极限强度的经验公式。结果表明,初始几何变形会削弱加筋板结构的强度。在对损伤后船体结构强度进行分析和校核时,提出的经验公式可以直接用来计算板的有效宽度和加筋板的极限强度。     

海洋核动力平台全频段舱室噪声预报与降噪方案研究

随着新规范对船舶及海上工作平台提出了更高要求，舱室噪声的控制及优化设计越来越受到人们的关注。本文首先对全频段舱室噪声预报软件——VA One软件统计能量分析理论及软件概况进行了阐述，其次应用该软件对海洋核动力平台进行几何建模与仿真计算。通过对舱室仿真计算结果与标准指标要求的对比分析，在设计阶段提出了海洋核动力平台舱室空气噪声综合治理降噪方案，该措施可以缩短建造周期、降低制造成本，提高海洋核动力平台的舒适性与安全性，具有十分重要的经济效益和社会效益。     

A signal decomposition method based on repeated extraction of maximum energy component for offshore structures

Contrary to most signal decomposition methods that usually decompose an original signal into a series of components simultaneously, a novel approach based on repeated extraction of Maximum Energy Component (MEC) is proposed. The approach starts from determination of the MEC referring to the estimated Power Spectral Density (PSD) function, and then represents the MEC by employing an exponential function to fit the original signal. By defining a stopping criterion based on two adjacent estimated PSDs, each MEC can be accurately extracted with an improved performance throughout the entire signal decomposition. To verify the proposed method, a single degree-of-freedom system subject to harmonic loads has been examined. Numerical results show that the analytical response can not only be decomposed into four MECs corresponding to the excitation and the system, respectively, but also provide an accurate estimation of natural frequency and damping ratio of the system. Meanwhile, by observing results from the Ensemble Empirical Mode Decomposition (EEMD), Variational Mode Decomposition (VMD) and Prony based on state-space model (Prony-SS), an improved decomposition accuracy has been achieved from the proposed approach. Furthermore, experimental data from the Norwegian Deepwater Programme and two sets of field-test data from one fixed offshore platform and an offshore wind turbine have been used to demonstrate the correctness of the developed signal decomposition method. It is noted that divergence in results by Prony-SS can be observed when a very large model order is used, while the proposed method provides the better decomposition and reconstruction of signals.     

福州东(樟林)车辆段工艺设计实践与创新

随着铁路建设的发展,福建省境内货车保有量大幅度增长,货车检修任务量增加迅速。樟林编组站位于福州枢纽,具备良好的扣车条件,在此新建1处货车车辆段将解决整个福建省货车的定期检修工作,而且能保障列车的运行安全,节约运输成本以及货车周转时间。福州东车辆段出入段线下穿既有温福铁路,有利于行车组织、运营安全。总图因地制宜全创新提出存车线(预检预修)与修车库贯通布置方案。充分梳理预检预修与架落车工艺,提出独立设置预检预修设施。论述抛丸除锈设备独立设置、转向架单臂悬挂检修流水线等修车库与联合车库创新设计,福州东(樟林)车辆段设计实现了创新理念和工程实际的协调统一。     

散货船舱口盖剩余强度

通过对散货船舱口盖极限强度的理论分析，采用了正交各向异性板及刚塑性模型进行了理论上的推导，并对7万t散货船的1号舱的舱口盖(两块对称滚动式)，进行了ILL66及IACS URS21(1998年版与上述ILL66的88议定书中载荷的量级相当)的外载荷的比较及线性和非线性的有限元分析。本文所采用的有限元的线性及弹塑性计算对实际的舱口盖进行评估的结果证明，IACS URS21(ILL66的88议定书)的标准比ILL66的标准有所提高。采用非线性有限元法是在初始设计阶段使用的可行方法。这些结果可供规范研制工作参考。     

A new solution for two-bag air suspension system with leaf spring for heavy-duty vehicle

The design problem of a two-bag air suspension system for heavy-duty vehicles is formulated as a two-level (suspension system level and component level) optimization problem. At the suspension system level, optimal stiffness matrix of leaf spring, characteristics of damper and upper rod layout are determined by solving a multi-objective constrained optimization problem with response surface. At the component level, shape and thickness of the leaf spring are formed using cubic-spline curves to make the stiffness matrix as close to the target values cascaded from suspension system level as possible. Simulations using a vehicle model described by multi-body model and FEM of the novel leaf spring validate the suspension system thus derived.     

Time-series analysis of remote-sensed chlorophyll and environmental factors in the Santa Monica–San Pedro Basin off Southern California

The time-series of remote-sensed surface chlorophyll concentration measured by SeaWiFS radiometer from September 1997 to December 2001 and the relevant hydrological and meteorological factors (remote-sensed sea surface temperature, atmospheric precipitation, air temperature and wind stress) in Santa Monica Bay and adjacent waters off southern California were analyzed using wavelet and cross-correlation statistical methods. All parameters exhibited evident seasonal patterns of variation. Wavelet analysis revealed salient long-term variations most evident in air temperature during El Niño 1997–1998 and in wind stress during La Niña 1998–1999. Short-period (<100 days) variations of remote-sensed chlorophyll biomass were mostly typical to spring seasons. Chlorophyll biomass was significantly correlated with air temperature and wind stress: an increase of chlorophyll biomass followed with 5–6-day time lag an increase of wind stress accompanied by a simultaneous decrease of air temperature. The mechanism of these variations was an intensification of phytoplankton growth resulting from the mixing of water column by wind stress and entrainment of nutrients into the euphotic layer.     

旧水泥混凝土路面加铺沥青混凝土面层勘测设计

旧水泥混凝土路面加铺沥青混凝土面层，当没有路线设计资料时，需对旧有路线进行拟合，重新进行勘测设计，以获得与旧有路线一致的路线设计资料，为旧水泥混凝土路面加铺沥青混凝土面层提供设计依据。结合工程实践，介绍了拟合旧有路线时勘测设计的内容和方法。