粘弹性耗能材料的动态力学特性研究

本文研究介绍了粘弹性阻尼材料动态力学性能,并进行了粘弹性阻尼材料动态特性的数学模拟研究。     

Multi-objective optimization of quarter-car models with a passive or semi-active suspension system

A systematic methodology is applied in an effort to select optimum values for the suspension damping and stiffness parameters of two degrees of freedom quarter-car models, subjected to road excitation. First, models involving passive suspension dampers with constant or dual rate characteristics are considered. In addition, models with semi-active suspensions are also examined. Moreover, special emphasis is put in modeling possible temporary separations of the wheel from the ground. For all these models, appropriate methodologies are employed for capturing the motions of the vehicle resulting from passing with a constant horizontal speed over roads involving an isolated or a distributed geometric irregularity. The optimization process is based on three suitable performance criteria, related to ride comfort, suspension travel and road holding of the vehicle and yielding the most important suspension stiffness and damping parameters. As these criteria are conflicting, a suitable multi-objective optimization methodology is set up and applied. As a result, a series of diagrams with typical numerical results are presented and compared in both the corresponding objective spaces (in the form of classical Pareto fronts) and parameter spaces.     

汽车工业用磁流变液器件应用前景分析

简要介绍了磁流变液和磁流变效应，详细分析了磁流变液的性能及其影响因素，将其与电流变流进行了对比，表明磁流变液具有很多优点，在此基础上，介绍了磁流变液应用于汽车工业的结构形式，以及在制动，传动和减振降噪域应用的一些器件。对磁流变液应用于汽车的前景进行了分析并指出了存在的问题。     

舵阻摇H∞控制器的设计

舵阻摇的效果对船舶水动力参数敏感,Ｈ_∞控制器对模型不确定性具有良好的适应性。本文设计了一种基于并联控制模式的舵阻摇Ｈ_∞控制器。模拟海上航行条件的计算机仿真表明该控制器具有良好的鲁棒特性。     

斜坡式防波堤堤心石动力特性试验研究

我国现行规范规定防波堤堤心材料为重量10～100 kg之间的块石,但实际工程往往很难达到这一重量范同的标准.如果利用重量范隔更大(如:1-800 kg)的块石作为堤心石,对整个斜坡堤的正常工作影响如何,同前国内对这方面的研究较少.因此,结合深水斜坡堤的丁程实例,利用模型试验,对不同重量范围的堤心石进行动力特性方面的研究.初步结论认为,1～800 kg块石作为堤心石,其动水压强较10～100 kg的值大,而静水压强较小.     

舰船水下爆炸鞭状运动中的阻尼效应

舰船在水下爆炸气泡脉动压力作用下将产生鞭状运动冲击响应。为了掌握冲击响应的衰减规律,建立了舰船结构、设备、水舱内流体和外部流体等在振动和晃荡过程中的阻尼效应动力学模型,并编写程序对是否考虑上述阻尼效应的舰船鞭状运动响应进行了数值计算。研究结果表明,对于具有相对较大质量的内部设备和水舱的舰船来说,上述阻尼效应对舰船水下爆炸鞭状运动的衰减起到重要的作用,如不予以考虑有可能造成对舰船鞭状运动响应幅值的高估。     

How well a single-track linear model captures the lateral dynamics of long combination vehicles

ABSTRACT

The effect of centre-of-gravity heights on the high-speed performance measures of long combination vehicles including truck with double centre-axle trailers, Nordic, and A-double combination vehicles is investigated. The high fidelity three-dimensional models, used in this research, are validated against physical test data. These models are often accurate in terms of the actual dynamic behaviours of the vehicle. On the other hand, the simple yaw-plane single-track models with linear tires require less number of vehicle parameters. In this paper, it is investigated how accurate the estimations of performance measures are at high forward speeds by such single-track linear (STL) models. The influence of load height is especially studied. The high-speed performance-based standard or PBS measures considered are rearward amplifications of both lateral acceleration and yaw velocity; lateral load transfer; yaw damping and high-speed transient offtracking. The results show that tire relaxation has a large effect and it is rather easy to add to an STL model, so it is assumed to be modelled in STL. With realistically high payload and a required accuracy of PBS measures of approximately 10%, only the accuracy of rearward amplification of yaw velocity calculated by the frequency response is fulfilled by the STL. With low payload, the same statement is valid, but with around 5% in required accuracy. The roll dynamics effects are more important than the tire non-linearities.     

新能源微耕机驱动轮设计

为了填补大中型农机难以进入山区田地的缺陷,微型农机的设计研究是非常必要的,微型农机具有节约能源资源,促进农业增产,降低农民的劳动强度提高农业生产的效率的特点,目前自行走微耕机多采用履带式行走机构,该行走机构绝大多数采用整体式橡胶履带,由驱动轮带动橡胶履带板,从而实现整机得移动,前进后退及差速转弯。     

车身壁板自由阻尼层稳健性优化设计

在车身壁板自由阻尼层的优化设计中,提出了考虑阻尼材料参数不确定性波动的稳健性优化设计方法。首先,在车身防火墙、地板和顶棚等区域全敷阻尼材料;其次,以等效辐射声功率(ERP)为优化目标对阻尼层布局进行拓扑优化并验证优化效果;最后,以阻尼层厚度为随机设计变量,损耗因子和弹性模量为随机变量,质量最小为优化目标,并结合径向基函数(RBF)近似模型、蒙特卡洛模拟(MCS)和序列二次规划算法(SQP)对阻尼层进行6σ稳健性优化设计。结果表明,优化后车身自由阻尼层的总质量减少了50.45%,并且车身结构噪声性能达到了6σ质量水平,实现了保证车身轻量化要求下的阻尼层稳健性优化的目标。