成层土中粘弹性桩纵向振动分析及工程应用

为了合理解释成层土中桩的完整性测试,建立了桩端为弹性阻尼支承、桩顶在任意荷载作用下粘弹性桩与多层土共同作用的数学模型,并利用拉普拉斯变换和矩阵理论求得了该模型的振动半解析解;然后利用卷积定理和傅立叶逆变换求得瞬态半个正弦波作用下桩顶响应的振动半解析解;最后采用数值模拟分析了桩侧土阻尼因子和桩身阻尼因子对桩顶速度响应的影响主要表现在对峰值点的衰减上,而桩侧土刚度因子主要对桩顶速度响应曲线的整体形状产生影响。     

汽车轮胎结构非线性有限元分析

本文综述了轮胎力学的发展历史与现状，阐明了轮胎结构分析的几各主要方法、研究内容及其优缺点，并重点介绍了在子午三维非线性有限元结构分析方面的工作，包括轮胎的充气，竖直加载、稳态滚动、滚动阻力及温度场分析，给出了相应的算例。由于采用一些新的方法和技术，考虑了更真实的轮胎材料模型，结构和载荷，使得分析更为有效、精确，分析结果可作为轮胎的设计，试验与改进的依据。     

南京长江二桥斜拉桥施工过程稳定性分析

针对南京二桥南汊钢斜拉桥,考虑结构的非线性和构件的极限承载能力,计入施工过程的变形和应力的叠加效应,用包含梁和索单元的空间组合结构模型,进行了大桥的结构行为分析,着重研究了在施工全过程中的结构稳定性问题。     

潜艇均衡系统自流注水调节阀稳态噪声试验研究

本文模拟建立了潜艇均衡系统自流注水试验系统,对不同假海压力、不同系统流量、不同出口背压及串联2台调节阀时自流注水稳定过程振动噪声进行研究。结果表明:潜艇均衡注水振动噪声随着假海深度的增大而增大;空气噪声随流量调节阀开度的增大而增大,在流量调节阀开度为60°-70°之间,振动加速度及水动力噪声产生峰值;在出口背压为0-0.5 MPa之间时,振动噪声值均大于无背压状态,峰值为0.2 MPa;串联2台流量调节阀可大幅降低自流注水振动噪声。     

超深振捣条件下混凝土墙体模板侧压力的简化计算方法

超深振捣对混凝土成品质量有害无益,研究超深振捣引起模板侧压力增大的规律,可为规避其害提供依据。为此设计4个混凝土墙体试件,实测在浇筑过程中模板侧压力的变化情况。基于振捣液化和液体压力平衡理论,建立了超深振捣情况下混凝土模板侧压力计算模型,推导了计算公式,并与实验数据进行对比验证。研究结果表明,振捣深度是影响混凝土墙体模板侧压力的重要因素,本文提出的计算模型能很好地预测墙体结构超深振捣位置的模板侧压力。     

Comparing different contour methods with response-based methods for extreme ship response analysis

Environmental contours are often applied in probabilistic structural reliability analysis to identify extreme environmental conditions that may give rise to extreme loads and responses. They facilitate approximate long term analysis of critical structural responses in situations where computationally heavy and time-consuming response calculations makes full long-term analysis infeasible. The environmental contour method identifies extreme environmental conditions that are expected to give rise to extreme structural response of marine structures. The extreme responses can then be estimated by performing response calculations for environmental conditions along the contours.Response-based analysis is an alternative, where extreme value analysis is performed on the actual response rather than on the environmental conditions. For complex structures, this is often not practical due to computationally heavy response calculations. However, by establishing statistical emulators of the response, using machine learning techniques, one may obtain long time-series of the structural response and use this to estimate extreme responses.In this paper, various contour methods will be compared to response-based estimation of extreme vertical bending moment for a tanker. A response emulator based on Gaussian processes regression with adaptive sampling has been established based on response calculations from a hydrodynamic model. Long time-series of sea-state parameters such as significant wave height and wave period are used to construct N-year environmental contours and the extreme N-year response is estimated from numerical calculations for identified sea states. At the same time, the response emulator is applied on the time series to provide long time-series of structural response, in this case vertical bending moment of a tanker. Extreme value analysis is then performed directly on the responses to estimate the N-year extreme response. The results from either method will then be compared, and it is possible to evaluate the accuracy of the environmental contour method in estimating the response. Moreover, different contour methods will be compared.     

基于基准有限元模型的箱梁TMD振动控制研究

针对高架桥梁结构引起的振动噪声问题,研究TMD控制箱梁结构振动的特性。为了获得精准的箱梁有限元模型,首先以铁路32 m简支箱梁桥为原型,按10:1的几何相似比设计制作简支箱梁缩尺试验模型,应用ANSYS软件建立初始动力有限元模型;对有限元模型模态分析与试验模型模态测试得到的自由模态信息进行误差分析,并采用基于灵敏度分析的模型修正技术对初始动力有限元模型弹性模量和密度进行修正,得到基准有限元模型,误差确认结果显示修正后的有限元模型更精准地反应箱梁的振动特性;进一步利用基准有限元模型,开展TMD控制简支箱梁桥振动的研究,研究结果表明TMD对于抑制桥梁竖向共振有很好的效果。     

冲压机械振动对高铁桥梁及行车动力影响分析

高速铁路桥梁的平顺性和稳定性对运营列车的平稳性和安全性有很大影响。为研究冲压机械产生的外部振动激励对高铁桥梁的影响,首先通过对此机械引起的地面振动进行实测,并结合有限元分析软件,确定最大冲击荷载作用下产生的地面振动及传播至桥墩处的振动;然后通过建立列车-轨道-桥梁耦合动力学模型,将桥墩处的地面振动作为激励输入,分析列车以不同速度通过时车辆、桥梁动力学响应。结果表明:地面冲击振动有限元模型计算结果与实测结果基本相符,验证了模型的可靠性;地面振动对桥梁响应会产生一定的影响,距振源50 m处地面振动对桥梁所产生的影响较距振源80 m处(桥墩处)的大,但对运行车辆的影响很小;随着车速由250 km/h至350 km/h,车辆及桥梁各结构的动态响应均有所增大,但都未超出安全限值。因此,冲压机械冲击作用导致的地面振动对列车-轨道-桥梁系统动态服役性能影响非常有限。     

Layout optimization of an inertial energy harvester for miniature underwater mooring platforms

Comprehensive analyses of the layout influence on power performance of a low-frequency miniature horizontal-pendulum-type inertial energy harvester for underwater mooring platforms are presented in this article. The mathematical models are obtained utilizing the Newton-Euler method. The power performance is evaluated by simulations over different parameters, such as damping, excitation frequency, and layout position. Simulation results indicate that the harvester can extract energy from low-frequency excitations over the range of 0.1 Hz–0.4 Hz, and maximum output power can reach to 0.7 W under excitation frequency f = 0.4 Hz. Different layout positions influence the energy harvesting performance of the harvester dramatically. Changing the layout position to positive value can enhance and broaden the power performance. The amplitude responses with different layout positions do not show resonant characteristics, even near the natural frequency of the harvester, due to large amplitude vibrations and strong nonlinear characteristic. As excitation frequency f = 0.4 Hz, there is a zero output power point appears at layout position d = −1.3 m. Moreover, the harnessed power has a quadratic relationship with the layout position value.