冲压机械振动对高铁桥梁及行车动力影响分析

高速铁路桥梁的平顺性和稳定性对运营列车的平稳性和安全性有很大影响。为研究冲压机械产生的外部振动激励对高铁桥梁的影响,首先通过对此机械引起的地面振动进行实测,并结合有限元分析软件,确定最大冲击荷载作用下产生的地面振动及传播至桥墩处的振动;然后通过建立列车-轨道-桥梁耦合动力学模型,将桥墩处的地面振动作为激励输入,分析列车以不同速度通过时车辆、桥梁动力学响应。结果表明:地面冲击振动有限元模型计算结果与实测结果基本相符,验证了模型的可靠性;地面振动对桥梁响应会产生一定的影响,距振源50 m处地面振动对桥梁所产生的影响较距振源80 m处(桥墩处)的大,但对运行车辆的影响很小;随着车速由250 km/h至350 km/h,车辆及桥梁各结构的动态响应均有所增大,但都未超出安全限值。因此,冲压机械冲击作用导致的地面振动对列车-轨道-桥梁系统动态服役性能影响非常有限。     

Layout optimization of an inertial energy harvester for miniature underwater mooring platforms

Comprehensive analyses of the layout influence on power performance of a low-frequency miniature horizontal-pendulum-type inertial energy harvester for underwater mooring platforms are presented in this article. The mathematical models are obtained utilizing the Newton-Euler method. The power performance is evaluated by simulations over different parameters, such as damping, excitation frequency, and layout position. Simulation results indicate that the harvester can extract energy from low-frequency excitations over the range of 0.1 Hz–0.4 Hz, and maximum output power can reach to 0.7 W under excitation frequency f = 0.4 Hz. Different layout positions influence the energy harvesting performance of the harvester dramatically. Changing the layout position to positive value can enhance and broaden the power performance. The amplitude responses with different layout positions do not show resonant characteristics, even near the natural frequency of the harvester, due to large amplitude vibrations and strong nonlinear characteristic. As excitation frequency f = 0.4 Hz, there is a zero output power point appears at layout position d = −1.3 m. Moreover, the harnessed power has a quadratic relationship with the layout position value.     

频繁爆破下隧道内振动传播的数值研究

为揭示频繁爆破下隧道内振动传播衰减规律,文章以蒙华铁路段家坪隧道为工程背景,利用LS-DY NA建立了三维隧道模型,模拟分析了多次爆破下隧道内近区和中远区的振动传播规律。结果表明,质点垂向峰值振速随距离和爆破次数的增大而减小,少数振速有增大的现象;近区振动衰减较快,中远区振动衰减比近区缓慢;中远区a值比近区至少小12.5%,但整体上二者的a值随爆破作用次数的增加呈缓慢上升趋势;系数K随爆破作用次数的增加而降低,近区K值降低速率普遍大于中远区,且近区K值比中远区至少大29.1%;频繁爆破下,中远区比近区较符合萨道夫斯基经验公式。     

轨道安全监测中传感器优化配置研究

为了研究轨道结构安全监测中传感器的合理配置方法,确保城市轨道交通安全运营,通过建立桥上交叉渡线道岔模型和钢轨应变传递误差最小的目标函数,提出传感器测点选择依据和监测方案评价标准,保证监测方案的经济性、合理性。结论表明:模型数据曲线可以指导监测系统的测点位置选择;随着传感器测点数量增加,监测误差逐渐减小,但在误差比率的"拐点"后增加单位个数传感器带来的收益降低;通过建立误差最小准则的目标函数,结合误差指标可以评价和优化传感器布设方案;钢轨位移、附加力等指标的监测方案也可以通过本文方法确定。     

Subjective-utility travel time budget modeling in the stochastic traffic network assignment

ABSTRACT

In this article, we propose a new model called subjective-utility travel time budget (SU-TTB) model to capture travelers' risk-averse route choices. In the travel time budget (TTB) and mean-excess travel time (METT) model, a predefined confidence level is needed to capture the risk-aversion in route choice. Due to the day-to-day route travel time variations, the exact confidence level is hard to be predicted. With the SU-TTB model, we assume travelers' confidence level belongs to an interval that they may comply with in the route choice. The two main components of SU-TTB are the utility function and the TTB model. We can show that the SU-TTB can be reduced to the TTB and METT model with proper utility function for the confidence levels. We can also prove its equivalence with our recently proposed nonlinear-expectation route travel time (NERTT) model in some cases and give some new interpretation on the NERTT with this equivalence. Finally, we formulate the SU-TTB model as a variational inequality (VI) problem to model the risk-averse user equilibrium (RAUE), termed as generalized RAUE (GRAUE). The GRAUE is solved via a heuristic gradient projection algorithm, and the model and solution algorithm are demonstrated with the Braess's traffic network and the Nguyen and Dupuis's traffic network.     

水中悬浮隧道交通荷载模拟方法研究

为研究水中悬浮隧道交通荷载的合理模拟方法以及交通荷载对隧道结构的影响,借鉴铁路、公路交通荷载的模拟方法,综合考虑车辆轮载、路面不平度、行车速度以及外部激励荷载等影响因素的共同作用,提出水中悬浮隧道交通荷载的模拟表达式。通过数值模拟计算,分析悬浮隧道交通荷载的变化特征,并研究不同交通荷载模拟方法对悬浮隧道结构振动位移响应的影响。结果表明:文章提出的交通荷载模拟方法计算结果符合移动振动荷载的波动性和周期性特征。在对结构振动位移响应影响方面,固定均布荷载相当于静载,移动集中荷载和移动振动荷载时的位移变化幅值相对固定均布荷载时的大且影响相似,但移动振动荷载时的振幅稍大,体现了交通荷载中动荷载部分对结构振动位移响应的影响,更适合用来模拟悬浮隧道中的交通荷载。     

面向控制的SCR催化转化器温度模型

为了建立面向控制的SCR催化器温度模型,根据能量守恒和质量守恒方程并考虑热平衡中所涉及的换热过程不同,建立了4种SCR催化器温度的数学模型,并利用Matlab/Simulink构建图形化的计算模型。采用柴油机欧洲稳态循环(ESC)和欧洲瞬态循环(ETC)条件下的台架实测数据对模型进行检验,基于最大离散程度、拟合度和计算时间3个指标对模型进行评价和比较。结果表明,考虑催化器与废气和周围环境对流换热的温度模型具有良好的预测精度和实时性,更适合用于SCR控制策略。     

Singular perturbation composite control of a free-floating flexible dual-arm space robot

The Free-floating Flexible Dual-arm Space Robot is a highly nonlinear and coupled dynamics system. In this paper, the dynamic model is derived of a Free-floating Flexible Dual-arm Space Robot holding a rigid payload. Furthermore, according to the singular perturbation method, the system is separated into a slow subsystem representing rigid body motion of the robot and a fast subsystem representing the flexible link dynamics. For the slow subsystem, based on the second method of Lyapunov, using simple quantitative bounds on the model uncertainties, a robust tracking controller design is used during the trajectory tracking phase. The optimal control method is designed in the fast subsystem to guarantee the exponential stability. With the combination of the two above, the system can track the expected trajectory accurately, even though with uncertainty in model parameters, and its flexible vibration gets suppressed, too. Finally, some simulation tests have been conducted to verify the effectiveness of the proposed methods.     

低温独立液舱曲面外板加工减薄量评估

基于耐低温合金材料的非线性特性,以某液化气船的低温独立液舱曲面外板加工成形过程为研究对象,研究其塑形变形过程及机理。利用ABAQUS作为计算分析工具,建立了板材原料及上、下加工模具的分析模型,给定冲压成形的时间和初始速度,并设定时间步长,考察每个时间步长的计算结果,分析了其加工过程中的弹塑性变形过程,评估了低温合金材料在加工过程中的板厚变化情况,并与实际加工测量值进行对比,验证了模型和计算分析过程的准确性。为各类低温独立液舱的设计和材料尺寸选用提供了技术支持和指导。     

油底壳有限元模态分析及实验验证

以EQ491型发动机油底壳为研究对象,通过有限元法得到了油底壳模型的固有频率和振型,运用模态实验技术,验证了有限元模型的合理性。在原始有限元模型的基础上,对油底壳模型进行约束模态分析,验证了油底壳结构的合理性,即油底壳固有频率远大于发动机机体激振频率。