Analytical and simulation approaches to understand combined effects of transit signal priority and road-space priority measures

Transit signal priority (TSP) may be combined with road-space priority (RSP) measures to increase its effectiveness. Previous studies have investigated the combination of TSP and RSP measures, such as TSP with dedicated bus lanes (DBLs) and TSP with queue jump lanes (QJLs). However, in these studies, combined effects are usually not compared with separate effects of each measure. In addition, there is no comprehensive study dedicated to understanding combined effects of TSP and RSP measures. It remains unclear whether combining TSP and RSP measures creates an additive effect where the combined effect of TSP and RSP measures is equal to the sum of their separate effects. The existence of such an additive effect would suggest considerable benefits from combining TSP and RSP measures. This paper explores combined effects of TSP and RSP measures, including TSP with DBLs and TSP with QJLs. Analytical results based on time-space diagrams indicate that at an intersection level, the combined effect on bus delay savings is smaller than the additive effect if there is no nearside bus stop and the traffic condition in the base case is under-saturated or near-saturated. With a near-side bus stop, the combined effect on bus delay savings at an intersection level can be better than the additive effect (or over-additive effect), depending on dwell time, distance from the bus stop to the stop line, traffic demand, and cycle length. In addition, analytical results suggest that at an arterial level, the combined effect on bus delay savings can be the over-additive effect with suitable signal offsets. These results are confirmed by a micro-simulation case study. Combined effects on arterial and side-street traffic delays are also discussed.     

Investigation of tailpipe and evaporative emissions from China IV and Tier 2 passenger vehicles with different gasolines

The limited understanding of vehicular emissions in China, especially evaporative emissions, is one obstacle to establishing tighter standards. To evaluate tailpipe and evaporative emissions, two typical China IV vehicles and one Tier 2 vehicle with an onboard refuelling vapour recovery (ORVR) system were selected and tested. One of the China IV vehicles was fuelled with gasoline, E10 and M15, respectively, to investigate the effect of fuel properties on vehicular emissions. For each vehicle, cold-start tailpipe emission tests were conducted first, followed by an evaporation test. Based on the emission factors and real-world vehicle activity data, the annual tailpipe and evaporative hydrocarbon (HC) emissions of each vehicle were calculated and compared. The results show that E10 and M15 significantly reduced the tailpipe CO and particle number (PN) emissions but seriously aggravated the NOx emissions, especially for M15. The hot soak losses (HSLs) and diurnal breathing losses (DBLs) were slightly impacted by the fuel properties. The annual evaporative emissions with E10 and M15 were higher than that with gasoline. The ORVR system effectively controlled the evaporative emissions, especially for DBLs. Evaporative emissions from the China IV vehicles were 1.1–1.4 times the tailpipe HC emissions. Additionally, the evaporative emission factors of the China IV vehicles were almost 50% lower than the standard (2.0 g/test), whereas their annual evaporative emissions were almost 1.8–2.8 times higher than those from the Tier 2 vehicle. Therefore, controlling evaporative emissions currently remains a great need in China, and the ORVR might be a recommended evaporative control technology.     

A systematic analysis of multimodal transport systems with road space distribution and responsive bus service

A smart design of transport systems involves efficient use and allocation of the limited urban road capacity in the multimodal environment. This paper intends to understand the system-wide effect of dividing the road space to the private and public transport modes and how the public transport service provider responds to the space changes. To this end, the bimodal dynamic user equilibrium is formulated for separated road space. The Macroscopic Fundamental Diagram (MFD) model is employed to depict the dynamics of the automobile traffic for its state-dependent feature, its inclusion of hypercongestion, and its advantage of capturing network topology. The delay of a bus trip depends on the running speed which is in turn affected by bus lane capacity and ridership. Within the proposed bimodal framework, the steady-state equilibrium traffic characteristics and the optimal bus fare and service frequency are analytically derived. The counter-intuitive properties of traffic condition, modal split, and behavior of bus operator in the hypercongestion are identified. To understand the interaction between the transport authority (for system benefit maximization) and the bus operator (for its own benefit maximization), we examine how the bus operator responds to space changes and how the system benefit is influenced with the road space allocation. With responsive bus service, the condition, under which expanding bus lane capacity is beneficial to the system as a whole, has been analytically established. Then the model is applied to the dynamic framework where the space allocation changes with varying demand and demand-responsive bus service. We compare the optimal bus services under different economic objectives, evaluate the system performance of the bimodal network, and explore the dynamic space allocation strategy for the sake of social welfare maximization.     

Analysis of cross effect on inherent deformation during the line heating process – Part 1 – Single crossed heating lines

This paper describes the effect of previous heating on inherent deformation by a subsequent heating line, more specifically, the case of two heating lines intersecting (crossing) each other. The paper has been divided into two parts. In the first part, the case of single crossed heating lines is studied in detail. The second part of the paper, discusses the case of more than one crossed heating lines. The novelty of the work lies in revealing the cross effect and how, factors such as, for example, the heating condition and the plate geometry, influence the resulting inherent deformation of crossed heating. In addition, relationships to easily get these influences are provided. The results are suitable for a wide range of heating conditions and plate thickness.     

悬挂式单轨平面圆曲线乘客舒适度控制标准取值研究

乘客舒适度标准是确定线路平纵断面设计参数最为重要的控制指标,也是必须满足的强制性指标。为合理平衡乘客舒适度与工程建设成本之间的跷跷板关系,通过系统总结国内外各种现有制式取值标准,就悬挂式单轨乘客舒适度控制标准取值开展理论分析研究,并提出相应建议。与平面圆曲线半径相关的乘客舒适度指标为车体偏转角及未被平衡离心加速度,随着偏转角和未被平衡离心加速度数值的增加,其对最小圆曲线半径的影响逐渐减弱,恶化舒适度条件并不完全等同于工程效益的减小。悬挂式单轨最大偏转角理论上可突破传统轮轨铁路7.7°的限制,但增大偏转角对限界造成的影响不可忽略。人体可忍受的振动持续作用时间与未被平衡离心加速度大小成反比,将加速度控制在0.4～0.8 m/s~2是合理的。     

500米长轨营业线火车市场运费与概预算编制办法计算运费对比分析

随着《铁路基本建设项目投资管理办法》(铁总计统〔2017〕179号)及《关于铁路建设项目清理概算工作的通知》(发改投资电〔2019〕1号)文的出台,标志着铁路建设项目概算清理工作,将逐步交由建设单位按照不突破初步设计批复金额进行处理,因此初步设计阶段如何确保招标预算金额的准确性,体现的越来越为重要,本文通过对500米长轨营业线火车市场运费与编制办法计算运费的分析,量化两者费用存在的差异,列明差异原因,并提出相关建议。     

客运站到发线运用优化研究

为了合理编制客运站到发线运用计划,作者确定了到发线均衡性评价标准,建立了既满足到发线固定使用方案,又达到均衡使用到发线的多目标二次0-1规划模型;并以德州东站为实例,利用LINGO软件进行了求解与验证。     

Instantaneous communication throughputs of vehicular ad hoc networks

Vehicular ad hoc networks (VANETs) formed by connected vehicles in a traffic stream could be applied to improve safety, mobility, and environmental impacts of a transportation system. In this paper, we present analytical models for the instantaneous communication throughputs of VANETs to measure the efficiency of information propagation under various traffic conditions at a time instant. In particular, we define broadcast and unicast communication throughputs by the wireless channel bandwith multiplied by the average probabilities that one vehicle is a successful receiver and sender in a VAENT, respectively. With a protocol communication model, we derive formulas to determine the probabilities for an equipped vehicle to be a successful broadcast receiver and a successful unicast receiver/sender, and obtain broadcast and unicast throughputs along discrete and continuous traffic streams. We further examine the impacts on communication throughputs of the transmission range and the interference range of dedicated short range communication devices as well as the market penetration rate of equipped vehicles and the percentage of senders. Finally, we investigate the influence of shock waves on communication throughputs.     

山钢莱芜分公司专用铁路编组站改造方案研究

专用铁路编组站改造是山东钢铁股份有限公司莱芜分公司新旧动能转换项目的控制工程之一,对于铁路运输组织、站场设施管理工作的提升具有重要意义.在阐述既有莱钢编组站站场设施和运输组织现状的基础上,结合钢铁新旧动能转换工程规划,分析莱钢编组站目前存在的无贯通正线、到发线有效长不足、卸车线有效长不足、站坪坡度超限等问题,提出莱钢编...     

大型铁路客运枢纽换乘服务研究

站在运输服务设计的角度,以增强旅客换乘出行体验为目的,提出“人、行李分离”的换乘服务理念,并基于该服务理念设计铁路客运枢纽内同站和异站换乘的方案。异站换乘方案设计时,提出铁路专用车的概念,打造一种全新的换乘模式,满足旅客换乘出行的多元化需求,吸引旅客主动换乘。最后,从心理和生理舒适性两个角度对换乘服务理念进行评价,结果表明“人、行李分离”服务创造了旅客换乘出行附加价值,提高了旅客的换乘出行体验感。