低动力作用货车转向架动力性能的研究

本文探讨低动力作用货车转向架的原理及其动力性能的计算和评估方法。首先定义9项指标,作为衡量车辆对轨道动力作用的标准。然后研究这些指标的诸因素。在此基础上总结出实现低动力作用的基本途径。本文还应用这些研究成果,提出4种低动力作用货车转向架的设计方案,并通过数值计算,同国内、外主型货车转向架对比,从而论证其在我国铁路采用的可行性。     

自动闭塞区段短区间接近轨道电路的设计与研究

四显示自动闭塞区段,车站计算机联锁一般需要3个闭塞分区作为接近轨道,当两站之间距离较短,少于3个闭塞分区时,则需要对接近轨的逻辑电路进行特殊处理。以神头站至大新站短区间为例,介绍以大新站进站信号机至出站信号机之间作为神头站的1JG、大新站出站信号机至1LQG为神头站的2JG的特殊情况,详细分析接近轨道电路的原理,并对具体工程应用进行说明。     

高速铁路双块式无砟轨道路基地段结构设计与施工技术研究

为了提高双块式无砟轨道的设计和施工质量,首先对路基地段双块式无砟轨道道床板和支承层的功能定位进行分析,提出连续道床板和分块道床板两种结构设计方案的主要特点和设计要点,并对两种设计方案进行结构受力和配筋计算。然后从抗压强度、结构耐久性、疲劳强度、裂缝控制等要求研究道床板混凝土的强度等级,提出道床板混凝土强度采用C40是足够的,且强度不宜太高。最后结合目前双块式无砟轨道施工和运营经验,提出道床板和支承层在施工过程中应注意的一些问题。     

Influence of polygonal wear of railway wheels on the wheel set axle stress

The coupled vehicle/track dynamic model with the flexible wheel set was developed to investigate the effects of polygonal wear on the dynamic stresses of the wheel set axle. In the model, the railway vehicle was modelled by the rigid multibody dynamics. The wheel set was established by the finite element method to analyse the high-frequency oscillation and dynamic stress of wheel set axle induced by the polygonal wear based on the modal stress recovery method. The slab track model was taken into account in which the rail was described by the Timoshenko beam and the three-dimensional solid finite element was employed to establish the concrete slab. Furthermore, the modal superposition method was adopted to calculate the dynamic response of the track. The wheel/rail normal forces and the tangent forces were, respectively, determined by the Hertz nonlinear contact theory and the Shen–Hedrick–Elkins model. Using the coupled vehicle/track dynamic model, the dynamic stresses of wheel set axle with consideration of the ideal polygonal wear and measured polygonal wear were investigated. The results show that the amplitude of wheel/rail normal forces and the dynamic stress of wheel set axle increase as the vehicle speeds rise. Moreover, the impact loads induced by the polygonal wear could excite the resonance of wheel set axle. In the resonance region, the amplitude of the dynamic stress for the wheel set axle would increase considerably comparing with the normal conditions.     

CRTSⅡ型先导段无砟轨道底座板纵联施工技术

结合京沪高速铁路无砟轨道底座板纵联的实际,阐述了底座板纵联施工的工艺流程,探讨了底座板纵联的控制要点,以期提高底座板纵联的施工质量。     

How well a single-track linear model captures the lateral dynamics of long combination vehicles

ABSTRACT

The effect of centre-of-gravity heights on the high-speed performance measures of long combination vehicles including truck with double centre-axle trailers, Nordic, and A-double combination vehicles is investigated. The high fidelity three-dimensional models, used in this research, are validated against physical test data. These models are often accurate in terms of the actual dynamic behaviours of the vehicle. On the other hand, the simple yaw-plane single-track models with linear tires require less number of vehicle parameters. In this paper, it is investigated how accurate the estimations of performance measures are at high forward speeds by such single-track linear (STL) models. The influence of load height is especially studied. The high-speed performance-based standard or PBS measures considered are rearward amplifications of both lateral acceleration and yaw velocity; lateral load transfer; yaw damping and high-speed transient offtracking. The results show that tire relaxation has a large effect and it is rather easy to add to an STL model, so it is assumed to be modelled in STL. With realistically high payload and a required accuracy of PBS measures of approximately 10%, only the accuracy of rearward amplification of yaw velocity calculated by the frequency response is fulfilled by the STL. With low payload, the same statement is valid, but with around 5% in required accuracy. The roll dynamics effects are more important than the tire non-linearities.     

The dynamic response of rail support

This research reviews principles behind the dynamic response of rail supports, and introduces a method of analysis to find the maximum response in a realistic setting. Assuming a time-dependent, moving mass with massive wheels is essential, because the ratio of the moving mass to the rail mass is significant. However, the dynamic response of the track is not affected by dynamic properties of the train other than its unsprung mass, because the natural frequencies of the train suspension and track are significantly different. A numerical method is developed to model the dynamic response based on these principles, and applied to the Korean urban transit. The dynamic response includes multiple peaks with a large amplitude range, creating noise while the wheel passes the support. The dynamic impact factor (DIF) for the rail support depends mainly on the stiffness and damping of the rail support. The DIF for the rail moment is below the code value, whether this value is based on numerical analysis or on-site measurements. However, our numerical analysis results in a DIF for support settlement that is greater than the code value, if the damping is less than 3%.     

CRTSⅢ型路基纵连轨道板制造技术及创新

成灌铁路采用了全新的CRTSⅢ型无砟轨道结构,在路基地段敷设了CRTSⅢ型路基纵连轨道板。介绍了CRTSⅢ型路基纵连轨道板的结构特点、二雏可调钢模技术、自动调整测量系统、生产工艺及检测方法,并总结了该种轨道板的主要创新点。     

双块式无砟轨道轨枕的优化设计研究

针对目前我国双块式无砟轨道轨枕在设计、生产、运输、铺设等过程中存在的一些问题进行探讨和分析，并在此基础上对双块式轨枕进行优化设计，以供我国双块式轨枕的设计作参考。     

ZPW-2000A监测子系统

根据实际应用的情况,介绍了ZPW-2000A监测子系统的结构和技术特点,并重点介绍采集设备的采集内容和采集处理器的功能.