A copula-based approach for estimating the travel time reliability of urban arterial

Estimating the travel time reliability (TTR) of urban arterial is critical for real-time and reliable route guidance and provides theoretical bases and technical support for sophisticated traffic management and control. The state-of-art procedures for arterial TTR estimation usually assume that path travel time follows a certain distribution, with less consideration about segment correlations. However, the conventional approach is usually unrealistic because an important feature of urban arterial is the dependent structure of travel times on continuous segments. In this study, a copula-based approach that incorporates the stochastic characteristics of segments travel time is proposed to model arterial travel time distribution (TTD), which serves as a basis for TTR quantification. First, segments correlation is empirically analyzed and different types of copula models are examined. Then, fitting marginal distributions for segment TTD is conducted by parametric and non-parametric regression analysis, respectively. Based on the estimated parameters of the models, the best-fitting copula is determined in terms of the goodness-of-fit tests. Last, the model is examined at two study sites with AVI data and NGSIM trajectory data, respectively. The results of path TTD estimation demonstrate the advantage of the proposed copula-based approach, compared with the convolution model without capturing segments correlation and the empirical distribution fitting methods. Furthermore, when considering the segments correlation effect, it was found that the estimated path TTR is more accurate than that by the convolution model.     

铁路路基动态变形模量的数值模拟分析

介绍铁路路基动态变形模量理论计算公式的推导及动态变形模量的测试原理,采用有限元软件模拟动态变形模量的测试过程,分析承载板与土体接触压力、路基动态变形模量的影响因素,并计算动态变形模量的有效测试深度.结果表明:在承载板中心一定范围内,接触压力模拟结果较理论计算值大;土体的动弹性模量对接触压力影响很小,可以忽略;路基动态变形模量测试冲击荷载作用下,土体只发生弹性变形;动态变形模量与土体动弹性模量呈线性关系,路基动态变形模量的模拟结果大于理论计算值;土体的泊松比对动态变形模量影响较小;动态变形模量有效测试深度建议取0.5~0.6 m.     

Extreme hawser tension assessment for FPSO vessel during offloading operation in Bohai bay

The Floating Production Storage and Offloading Unit (FPSO) is an offshore vessel that produces and stores crude oil prior to tanker transport.Robust prediction of extreme hawser tensions during Floating Production Storage and Offloading (FPSO) operation is an important safety concern. Excessive hawser tension may occur during offloading operations, posing an operational risk. In this paper, AQWA has been used to analyze vessel response due to hydrodynamic wave loads, acting on a specific FPSO vessel under actual sea conditions. Experimental validation of numerical results has been discussed as well.This paper advocates methodology for estimating extreme response statistics, based on simulations (or measurements). The modified ACER (averaged conditional exceedance rate) method is presented in brief detail. Proposed methodology provides an accurate extreme value prediction, utilizing all available data efficiently. In this study the estimated return level values, obtained by ACER method, are compared to the corresponding return level values obtained by Gumbel method. Based on the overall performance of the proposed method, it is concluded that the improved ACER method can provide more robust and accurate prediction of the extreme hawser tension.Data declustering issue has been addressed. Paper highlights ability of ACER method to account for a set of varying sea state probabilities, as required in engineering long term statistical analysis.Described approach may be well used at the vessel design stage, while defining optimal vessel parameters that would minimize potential FPSO hawser tension.     

25t轴重荷载作用下隧底脱空区域受力特性分析

为了研究在役铁路隧道在通车之后隧底脱空病害的问题,采用有限元理论,建立隧道脱空区域在围岩压力与25 t轴重列车动载作用下的数值计算模型,主要研究80 cm与40 cm脱空宽度分别距隧道中心线0,80 cm与160 cm时脱空区域的受力特性。结果表明:在围岩压力下,脱空区域中线上壁和外侧顶角混凝土中产生拉应力及内侧顶角中产生压应力,其中压应力对脱空的宽度更为敏感;同时施加列车动载作用时,脱空区域上壁出现了竖向动应力与横向拉应力,得到了脱空区域力学指标的最大响应值及其出现的具体位置,宽度的增加对脱空区上壁横向拉应力更为显著,上壁横向拉应力增幅超过200%,竖向动应力增幅达50%。因此,隧底脱空区周围应力分布复杂,拉应力与压应力在脱空区域同时存在,应力突变严重,对脱空现象应及时组织处理。     

考虑空车调配协调的货物列车开行方案优化研究

为实现空车调配与货物列车开行方案协调优化，结合基本运行图架构与车流径路，构建货运时空服务拓展网络。考虑配空与装卸取送、集编发等环节的时间接续要求，节点与区段不对流空车要求，以重车流全程运送与空车配送等广义总费用最少为目标，建立整数规划弧路模型。针对既有算法设计局限性，结合重车或空车配空的时间接续要求，提出将不同的 k 短路重车流方案与空车配空方案相关联的改进可行解构造方法，设计混合差分进化求解算法。实例研究表明，考虑空车调配进行重车、空车流组织协调优化，能够减少空车走行费用，及时满足装车需求，有效保证作业车流配合中转车流集结编组及时挂线，提高方案可实施性。     

基于隧道检测钢筋分布不均状况下判定衬砌结构安全性应用研究

近年来隧道内出现的越来越多的质量安全事故,引起各方高度重视,相应的最适宜隧道主体工程衬砌质量控制的地质雷达无损检测方法被广泛应用。通过雷达无损检测可揭露出衬砌内欠厚、脱空、钢筋分布不均等大量各类型缺陷,针对欠厚脱空等缺陷制定的注浆或开窗等治理措施是目前工程中常见的整改闭合工序,但钢筋分布不均对结构安全影响如何判定,怎么界定处理尚无成熟方案与规定。本文针对隧道项目中实际检测出的钢筋分布不均缺陷,在不宜大范围扰动结构及围岩进行整治的情况下,以及在避免其他问题共存等不利因素的前提下,应用有限元数值模拟计算分析强度安全系数,并结合现场外观等综合因素对衬砌结构安全性进行分析判定研究。     

On the variance of recurrent traffic flow for statistical traffic assignment

This paper generalizes and extends classical traffic assignment models to characterize the statistical features of Origin-Destination (O-D) demands, link/path flow and link/path costs, all of which vary from day to day. The generalized statistical traffic assignment (GESTA) model has a clear multi-level variance structure. Flow variance is analytically decomposed into three sources, O-D demands, route choices and measurement errors. Consequently, optimal decisions on roadway design, maintenance, operations and planning can be made using estimated probability distributions of link/path flow and system performance. The statistical equilibrium in GESTA is mathematically defined. Its multi-level statistical structure well fits large-scale data mining techniques. The embedded route choice model is consistent with the settings of O-D demands considering link costs that vary from day to day. We propose a Method of Successive Averages (MSA) based solution algorithm to solve for GESTA. Its convergence and computational complexity are analyzed. Three example networks including a large-scale network are solved to provide insights for decision making and to demonstrate computational efficiency.     

现代大学生公寓电气设计浅析

文章采用文献资料、归纳与综合、专家访谈等研究方法,对现代大学生公寓电气设计进行了系统研究,主要内容包括配电系统、负荷系统、防雷接地、消防系统和智能化五个方面,旨为大学生公寓的电气设计提供有益资讯．     

高速公路中收费和清分的动态解决方案

在高速公路收费和清分过程中,由于新增的高速公路和收费站点特别是环型路段的增加使得原有的静态算法已经不适宜于现实情况。本文提出了高速公路中基于最短路径和环型路段的动态收费和清分解决方案,并给出了详细的基于环型路段的动态算法。环型路段问题解决后,可以判知车辆实际行车路线,从而大幅提高收费及清分的准确性和效率。