重载货车摩擦缓冲器阻抗特性的数值模拟

为预测摩擦缓冲器的实际工作状态,从几何特征和作用原理的角度,建立详细的MT-2型缓冲器理论模型。首先,通过对缓冲器内部各摩擦元件的运动学和静力学分析,推导出缓冲器在准静态下的阻抗特性;其次,引入附加摩擦系数量化各摩擦元件之间动静态摩擦过渡时的黏滞补偿,并模拟出缓冲器在动态下的阻抗特性;最后,利用C80型货车冲击试验数据对该缓冲器的理论模型进行验证。验证结果表明:总体上,数值模拟和现场试验下的缓冲器示功曲线基本吻合,说明模型的正确性;局部上数值模拟中缓冲器从加载Ⅰ阶段过渡至加载Ⅱ阶段的突变现象在冲击试验中表现的并不明显,还有待进一步完善。     

A signal-based fault detection and classification method for heavy haul wagons

This paper proposes a signal-based fault detection and isolation (FDI) system for heavy haul wagons considering the special requirements of low cost and robustness. The sensor network of the proposed system consists of just two accelerometers mounted on the front left and rear right of the carbody. Seven fault indicators (FIs) are proposed based on the cross-correlation analyses of the sensor-collected acceleration signals. Bolster spring fault conditions are focused on in this paper, including two different levels (small faults and moderate faults) and two locations (faults in the left and right bolster springs of the first bogie). A fully detailed dynamic model of a typical 40t axle load heavy haul wagon is developed to evaluate the deterioration of dynamic behaviour under proposed fault conditions and demonstrate the detectability of the proposed FDI method. Even though the fault conditions considered in this paper did not deteriorate the wagon dynamic behaviour dramatically, the proposed FIs show great sensitivity to the bolster spring faults. The most effective and efficient FIs are chosen for fault detection and classification. Analysis results indicate that it is possible to detect changes in bolster stiffness of ±25% and identify the fault location.     

Influence of AC system design on the realisation of tractive efforts by high adhesion locomotives

The main task for heavy haul railway operators is to reduce the cost of exported minerals and enhance the long-term viability of rail transport operations through increasing productivity by running longer and heavier trains. The common opinion is that this is achievable by means of implementation of high adhesion locomotives with advanced AC traction technologies. Modern AC high adhesion locomotives are very complex mechatronic systems and can be designed with two alternative traction topologies of either bogie or individual axle controls. This paper describes a modelling approach for these two types of AC traction systems with the application of an advanced co-simulation methodology, where an electrical system and a traction algorithm are modelled in Matlab/Simulink, and a mechanical system is modelled in a multibody software package. Although the paper concentrates on the analysis of the functioning for these two types of traction control systems, the choice of reference slip values also has an influence on the performance of both systems. All these design variations and issues have been simulated for various adhesion conditions at the wheel–rail interface and their influence on the high traction performance of a locomotive equipped with two three-axle bogies has been discussed.     

浅谈工程设计对公路建设投资的影响和相应对策

通过工程设计对公路建设投资影响的分析,阐明了工程设计是影响建设投资的主要因素之一,并通过实例证明了合理选择设计方案和采用技术标准等办法是控制投资的一条有效途径,而合理选择设计方案和技术标准又受到各种因素的影响和限制,对影响合理选择设计方案的原因进行了具体分析,并就此提出了几点相应对策,供同行们参考.     

公路隧道下穿饮用水水池的爆破控制

本项目是新建隧道下穿原有饮用水水池,因直线距离较小、且水池安全要求较高,无法使用传统爆破开挖,为保证水池正常使用,施工时严格控制同一段雷管起爆装药量,使爆破振动速度降低到安全范围内,并对爆破震动速度进行监测,确保在水池附近的振动处于可控。     

沉船油舱抽油加热过程的热力学分析

本文对沉船倾斜油舱抽油过程进行了数值模拟研究,在相同的蒸汽加热功率,不同的加热位置条件下,分析了油舱内重质燃油和原油的加热过程,分别取得了在不同时刻油舱内重质燃油和原油的温度分布情况,以及油温随加热时间的变化规律。     

浅谈设备大修与更新阶段的成本控制

在设备日常管理中应该以主动维护代替大修,尽量降低修理级别,并将设备大修及技术改造与设备更新结合起来,充分发挥设备效能,降低综合管理成本,实现企业利润最大化.     

使用有限元分析以改善重载运输车轴

分析了北美铁路货运发生的车轴故障,介绍了使用有限元对F级和K级车轴进行应力分析计算,研究车轴尺寸变化对应力的影响,并提出了改善重载车轴设计的建议.     

计及导向摆臂约束的重型货车驾驶室俯仰平面动力学模型

传统的重型货车驾驶室俯仰平面动力学模型没有考虑悬置导向机构的影响,仅能粗略计算驾驶室垂向和俯仰响应,无法计算驾驶室质心的纵向振动特性,因而其仿真精度较低,且在实际工程应用中受到了限制.为提高模型精度并拓宽其工程应用范围,创建了考虑导向摆臂约束作用的驾驶室俯仰平面动力学模型,分析了摆臂导向机构的约束特性.在此基础上,通过...     

长江干线航道整治建筑物技术状况时空特征分析*

随长江干线航道基础设施体系的逐步完善,航道整治建筑物养护问题受到广泛关注。以长江干线航道养护数据为基础,通过泰尔指数、莫兰指数、标准距离等计算分析,研究航道整治建筑物技术状况时空特征。结果表明：航道整治建筑物数量及技术状况总体上逐年提升,2019年是泰尔指数转折发生年份;丁坝和护滩带等整治建筑物的养护需要重点关注;长江干线航道整治建筑物技术状况分布呈现显著的集聚效应,上游航道整治建筑物技术状况分布相较中、下游更集中。