Simulating the air quality impacts of traffic calming schemes in a dense urban neighborhood

In this study, the effects of isolated traffic calming measures and area-wide calming schemes on air quality in a dense neighborhood were estimated using a combination of microscopic traffic simulation, emission, and dispersion modeling. Results indicated that traffic calming measures did not have as large an effect on nitrogen dioxide (NO₂) concentrations as the effect observed on nitrogen oxide (NO_x) emissions. Changes in emissions resulted in highly disproportional changes in pollutant levels due to daily meteorological conditions, road geometry and orientation with respect to the wind. Average NO₂ levels increased between 0.1% and 10% with respect to the base-case while changes in NO_x emissions varied between 5% and 160%. Moreover, higher wind speeds decreased NO₂ concentrations on both sides of the roadway. Among the traffic calming measures, speed bumps produced the highest increases in NO₂ levels.     

Modeling the impacts of mandatory and discretionary lane-changing maneuvers

In this paper, a novel mesoscopic multilane model is proposed to enable simultaneous simulation of mandatory and discretionary lane-changing behaviors to realistically capture multilane traffic dynamics. The model considers lane specific fundamental diagrams to simulate dynamic heterogeneous lane flow distributions on expressways. Moreover, different priority levels are identified according to different lane-changing motivations and the corresponding levels of urgency. Then, an algorithm is proposed to estimate the dynamic mandatory and discretionary lane-changing demands. Finally, the lane flow propagation is defined by the reaction law of the demand–supply functions, which can be regarded as an extension of the Incremental-Transfer and/or Priority Incremental-Transfer principles. The proposed mesoscopic multilane cell transmission model is calibrated and validated on a complex weaving section of the State Route 241 freeway in Orange County, California, showing both the positive and negative impact of lane changing maneuvers, e.g., balancing effect and capacity drop, respectively. Moreover, the empirical study verifies that the model requires no additional data other than the cell transmission model does. Thus, the proposed model can be deployed as a simple simulation tool for accessing dynamic mesoscopic multilane traffic state from data available to most management centers, and also the potential application in predicting the impact of traffic incident or lane control strategy.     

Heterogeneous hazard model of PEV users charging intervals: Analysis of four year charging transactions data

Public charging infrastructure represents a key success factor in the promotion of plug-in electric vehicles (PEV). Given that a large initial investment is required for the widespread adoption of PEV, many studies have addressed the location choice problem for charging infrastructure using a priori simple assumptions. Ideally, however, identifying optimal locations of charging stations necessitates an understanding of charging behavior. Limited market penetration of PEV makes it difficult to grasp any regularities in charging behavior. Using a Dutch data set about four-years of charging transactions, this study presents a detailed analysis of inter-charging times. Recognizing that PEV users may exhibit different charging behavior, this study estimates a latent class hazard duration model, which accommodates duration dependence, unobserved heterogeneity and the effects of time-varying covariates. PEV users are endogenously classified into regular and random users by treating charging regularity as a latent variable. The paper provides valuable insights into the dynamics of charging behavior at public charging stations, and which strategies can be successfully used to improve the performance of public charging infrastructure.     

Evaluating sustainability of supply chains by two-stage range directional measure in the presence of negative data

Assessing sustainability of supply chains is a critical and increasingly complex problem. In recent years sustainability has received more attention in supply chain management (SCM) literature with triple bottom lines including social, environmental, and economic factors. Conventional data envelopment analysis (DEA) models consider decision making units (DMUs) as black boxes that consume a set of inputs to produce a set of outputs and do not take into consideration internal interactions of DMUs. Two-stage DEA models deal with such DMUs. However, existing two-stage DEA models are applicable only in technologies characterized by positive inputs/outputs. This paper aims to build and present a new two-stage DEA model considering negative input-intermediate-output data. Some numerical examples along with some theorems and properties are given to show capability of proposed method. The proposed ideas are used in a case study where 29 Iranian supply chains producing equipment of expendable medical devices are evaluated in terms of sustainability.     

A carbon footprint-based closed-loop supply chain model under uncertainty with risk analysis: A case study

The management of products’ end-of-life and the recovery of used products has gained significant importance in recent years. In this paper, we address the carbon footprint-based problem that arises in a closed-loop supply chain where returned products are collected from customers. These returned products can either be disposed of or be remanufactured to be resold as new ones. Given this environment, an optimization model for a closed-loop supply chain (CLSC) in which carbon emission is expressed in terms of environmental constraints, i.e., carbon emission constraints, is developed. These constraints aim to limit the carbon emission per unit of product supplied with different transportation modes. Here, we design a closed-loop network where capacity limits, single-item management and uncertainty on product demands and returns are considered. First, fuzzy mathematical programming is introduced for uncertain modeling. Then, the statistical approach to the possibility to synthesize fuzzy information is utilized. Therefore, using a defined possibilistic mean and variance, we transform the proposed fuzzy mathematical model into a crisp form to facilitate efficient computation and analysis. Finally, the risk caused by violating the estimated resource constraints is analyzed so that decision makers (DMs) can trade off between the expected cost savings and the expected risk. We utilize data from a company located in Iran.     

Integrating mesoscopic dynamic traffic assignment with agent-based travel behavior models for cumulative land development impact analysis

A number of approaches have been developed to evaluate the impact of land development on transportation infrastructure. While traditional approaches are either limited to static modeling of traffic performance or lack a strong travel behavior foundation, today’s advanced computational technology makes it feasible to model an individual traveler’s response to land development. This study integrates dynamic traffic assignment (DTA) with a positive agent-based microsimulation travel behavior model for cumulative land development impact studies. The integrated model not only enhances the behavioral implementation of DTA, but also captures traffic dynamics. It provides an advanced yet practical approach to understanding the impact of a single or series of land development projects on an individual driver’s behavior, as well as the aggregated impacts on the demand pattern and time-dependent traffic conditions. A simulation-based optimization (SBO) approach is proposed for the calibration of the modeling system. The SBO calibration approach enhances the transferability of this integrated model to other study areas. Using a case study that focuses on the cumulative land development impact along a congested corridor in Maryland, various regional and local travel behavior changes are discussed to show the capability of this tool for behavior side estimations and the corresponding traffic impacts.     

Validation of an extended discrete first-order model with variable speed limits

This paper validates the prediction model embedded in a model predictive controller (MPC) of variable speed limits (VSLs). The MPC controller was designed based on an extended discrete first-order model with a triangular fundamental diagram. In our previous work, the extended discrete first-order model was designed to reproduce the capacity drop and the propagation of jam waves, and it was validated with reasonable accuracy without the presence of VSLs. As VSLs influence traffic dynamics, the dynamics including VSLs needs to be validated, before it can be applied as a prediction model in MPC. For conceptual illustrations, we use two synthetic examples to show how the model reproduces the key mechanisms of VSLs that are applied by existing VSL control approaches. Furthermore, the model is calibrated by use of real traffic data from Dutch freeway A12, where the field test of a speed limit control algorithm (SPECIALIST) was conducted. In the calibration, the original model is extended by using a quadrangular fundamental diagram which keeps the linear feature of the model and represents traffic states at the under-critical branch more accurately. The resulting model is validated using various traffic data sets. The accuracy of the model is compared with a second-order traffic flow model. The performance of two models is comparable: both models reproduce accurate results matching with real data. Flow errors of the calibration and validation are around 10%. The extended discrete first-order model-based MPC controller has been demonstrated to resolve freeway jam waves efficiently by synthetic cases. It has a higher computation speed comparing to the second-order model-based MPC.     

基于传播模型的非机动车违规过街行为研究

为研究信号交叉口非机动车违规过街行为，选取西安市的7个信号交叉口，通过视频拍摄获取资料，应用复杂网络来分析非机动车网络的结构特征和演化规律.建立了交叉口非机动车网络，基于SI模型的基本思想，提出了非机动车违规过街行为的传播模型.并通过python程序进行模拟分析，在不同的网络结构和不同的传播率下，获取了非机动车违规过街的行为趋势.结果表明：随着等待时间的增加，一旦有骑行者闯红灯，更多的骑行者将加入到违规过街的行列；在内向度和外向度方面，电动自行车均高于普通自行车；非机动车违规行为随着传播率及非机动车流量的增加而增加.     

高速公路沥青路面施工质量控制分析

无接缝、平整、行车舒适、噪音低以及振动小、易于养护等优点,使沥青混凝土路面成为我国国内公路面层普遍采用的一种比较好的结构形式。但是如果施工中不能按照施工工艺严格的进行施工质量控制,则很容易导致路面的一系列质量问题,这不仅影响使用功能,还影响影响其社会效益。