集美大学教学实习船“育德”轮总体设计

"育德"轮是上海船舶研究设计院为集美大学设计的用于航海专业教学实习、科学研究兼顾货物运输的教学实习船。该船是目前世界吨位最大的教学实习船,配备了功能齐全的教学设施、先进的科研设备以及舒适的学习生活环境。该船还具有安全性高、绿色环保和经济性优异等特点。     

A real-time adaptive signal control in a connected vehicle environment

The state of the practice traffic signal control strategies mainly rely on infrastructure based vehicle detector data as the input for the control logic. The infrastructure based detectors are generally point detectors which cannot directly provide measurement of vehicle location and speed. With the advances in wireless communication technology, vehicles are able to communicate with each other and with the infrastructure in the emerging connected vehicle system. Data collected from connected vehicles provides a much more complete picture of the traffic states near an intersection and can be utilized for signal control. This paper presents a real-time adaptive signal phase allocation algorithm using connected vehicle data. The proposed algorithm optimizes the phase sequence and duration by solving a two-level optimization problem. Two objective functions are considered: minimization of total vehicle delay and minimization of queue length. Due to the low penetration rate of the connected vehicles, an algorithm that estimates the states of unequipped vehicle based on connected vehicle data is developed to construct a complete arrival table for the phase allocation algorithm. A real-world intersection is modeled in VISSIM to validate the algorithms. Results with a variety of connected vehicle market penetration rates and demand levels are compared to well-tuned fully actuated control. In general, the proposed control algorithm outperforms actuated control by reducing total delay by as much as 16.33% in a high penetration rate case and similar delay in a low penetration rate case. Different objective functions result in different behaviors of signal timing. The minimization of total vehicle delay usually generates lower total vehicle delay, while minimization of queue length serves all phases in a more balanced way.     

有轨电车交叉口交通组织及控制方案优化

有轨电车在运行过程中,易在交叉口处产生瓶颈,导致有轨电车通行速度降低、乘客舒适度下降。从有轨电车交叉口信号优先控制、现状交叉口交通管理与控制优化、公共交通组织优化、慢行交通组织优化4个方面提出了相应的优化措施。以武汉市有轨电车作为实例,提出了一系列改善措施,并利用VISSIM软件仿真模拟了实施效果,仿真结果验证了优化方案的科学性和有效性。     

基于GOOSE机制的城市轨道交通中压环网继电保护方案优化

针对目前城市轨道交通中压环网继电保护存在的问题,提出了基于GOOSE(面向通用对象的变电站事件)机制的中压环网的继电保护优化方案,有效地解决了传统过流保护级差配合困难的问题.该方案是以GOOSE光纤以太网为基础,以闭锁逻辑为核心的数字通信电流保护方案.将GOOSE信号进行分类,并对中压供电环网系统各种可能出现的故障进行动作行为分析.最后,通过RTDS(动态数字仿真系统)仿真试验,证明该方案在各种故障情况下,都能保证继电保护的选择性、速动性、灵敏性和可靠性.     

废弃泥浆在盾构壁后注浆中的应用

在泥水盾构施工过程中不可避免地会产生大量的废弃泥浆,处理泥浆一是需要较高的资金投入,二是可能会对环境造成严重污染。利用废弃泥浆配制壁后注浆砂浆,利用盾构弃浆代替砂浆中的膨润土和水,研究弃浆对壁后注浆砂浆工程性能的影响。结果表明:1)相对体积质量为1.16、黏度为22 s的泥浆配制壁后注浆材料可得到较好的流动性和稠度,并且泌水率优于原配比;2)相对体积质量为1.27、黏度为24 s的泥浆会明显降低砂浆的流动度,对砂浆可泵送能力有一定的影响;3)适当调整水胶比和泥浆相对体积质量,配制壁后注浆材料各方面性能均能达到壁后注浆材料的要求;4)废弃泥浆配制砂浆是一种既经济又环保的弃浆处理回收再利用的工艺工法。     

复杂地形条件下桥隧相连隧道洞口结构设计研究

蒙华铁路坪桥1号隧道进口洞顶基岩外凸、洞顶以下岩面高且直立、洞顶上部地形偏压高陡,地形条件极其复杂。营盘山大桥与坪桥1号隧道进口紧密相连,存在桥台与隧道洞门结构相互干扰以及边坡防护、隧道出洞和洞口场地布置等一系列难题,设计难度极大。为解决这些难题,通过对现场实际地形、地质情况进行研究,对比分析"整体式"与"分离式"桥隧相连结构的优缺点,提出桥台与隧道相结合的"整体式"桥隧相连结构方案;同时,针对地形偏压高陡,提出非对称结构设计方案,实现了隧道"零"仰坡出洞,解决了洞口边坡防护的难题;最后,提出架立临时贝雷梁的方案,解决了隧道出洞及洞口场地布置的难题。     

A signal-based fault detection and classification method for heavy haul wagons

This paper proposes a signal-based fault detection and isolation (FDI) system for heavy haul wagons considering the special requirements of low cost and robustness. The sensor network of the proposed system consists of just two accelerometers mounted on the front left and rear right of the carbody. Seven fault indicators (FIs) are proposed based on the cross-correlation analyses of the sensor-collected acceleration signals. Bolster spring fault conditions are focused on in this paper, including two different levels (small faults and moderate faults) and two locations (faults in the left and right bolster springs of the first bogie). A fully detailed dynamic model of a typical 40t axle load heavy haul wagon is developed to evaluate the deterioration of dynamic behaviour under proposed fault conditions and demonstrate the detectability of the proposed FDI method. Even though the fault conditions considered in this paper did not deteriorate the wagon dynamic behaviour dramatically, the proposed FIs show great sensitivity to the bolster spring faults. The most effective and efficient FIs are chosen for fault detection and classification. Analysis results indicate that it is possible to detect changes in bolster stiffness of ±25% and identify the fault location.     

信息化战争交通重点目标防护的对策

针对信息化战争条件下战场透明化和打击精确化的特点,从建立和完善"综合集成" 的防护体系、完善伪装防护技术手段、适时做好交通保障器材的储备和更新等方面,提出了交通重点目标防护应采取的技术措施和应对精确打击的相关对策.     

公路建设中的环境问题探讨

对公路建设环境保护作了比较深入地分析与探讨,总结归纳了公路施工环境保护工作的重点与措施。