双孔平行地铁顺穿桥梁对桥梁桩基础影响研究

利用有限元分析软件建立桥梁基础及双孔地铁的模型,模拟地铁盾构的施工工况。研究盾构施工前后地铁隧道、周边土体变形趋势及其对地铁顺穿桥梁的桩基础轴力、弯矩、水平变形及沉降的影响。分析结果表明:隧道施工造成隧道上部土体沉降,下部土体隆起,隧道呈现椭圆形;其顺穿桥梁桩基轴力、弯矩增加幅度较大,桩基在地铁隧道深度以上竖向沉降,在隧道深度下局部桩体隆起,桩身位移呈现“3”字形,最大位移位于隧道中心标高与隧道底标高之间。     

Fatigue damage calculation for oil tanker and container ship structures

The fatigue behaviour of longitudinal stiffeners of oil tankers and container ships, subjected to dynamic loads, is analysed. The following dynamic load components are considered: hull girder vertical wave bending moment, alone and combined with the horizontal wave bending moment, hydrodynamic pressure and inertial forces caused by cargo acceleration.

The spectral method was selected to calculate the fatigue damage, based on S—N curves and Miner's rule. Following this approach, the fatigue damage may be calculated as a function of a stress parameter Ω_p, which represents the cumulative effect of wave induced loads in the unit of time and incorporates the combined effects of stress level and its occurring frequency.

Simple formulas for Ω_p of oil tankers and container ships are given, obtained from the results of hydrodynamic analyses performed on several ships, in different wave environments.

Several examples show the applicability of the methods to real ship structures. The method, however, still needs to be calibrated because of the simplifying hypotheses introduced in the loading conditions.     

砂卵石地层台阶法施工隧道围岩-支护结构应力应变特性三维离散元分析

为了解砂卵石地层隧道围岩和支护结构的应力应变特性，以青海循隆高速公伯峡隧道为依托，借助PFC3D离散元软件对公伯峡隧道穿越砂卵石地层进行三维模拟，重点研究以密排短管棚预支护为根本前提，以三台阶预留核心土为施工方法的砂卵石地层围岩和支护结构的应力应变特性，并与现场实测进行对比分析。研究结果表明： 隧道台阶开挖时，围岩应力集中范围逐渐从拱顶过渡到拱腰，直到拱脚，对应的塑性区范围不断扩大，且密排短管棚对塑性区的发展有一定的“遮拦效应”； 围岩横纵向变形规律一致，主要是向隧道临空面产生收敛变形，且密排短管棚形成的梁拱效应限制了掌子面前方位移发展； 2种方法得到的初期支护变形规律一致，均呈阶段性变化，拱顶下沉累计值大于周边收敛累计值，且两者的最终变形量均满足规范限值要求。     

回填土区深层搅拌桩和高压旋喷桩复合地基的静承载性能

结合实际工程现场静载试验,采用有限元计算方法研究了桩长和桩土模量比对深层搅拌桩和高压旋喷桩复合地基在回填土中的桩体承载特性、荷载传递及复合地基变形特性的影响。结果表明,在回填土区,深层搅拌桩以桩体上部破坏为主,增加桩长不能有效地提高复合地基承载力,增加桩体强度尤其是上部桩体的强度则能够较大地提高复合地基承载力,高压旋喷桩可有效增强回填土地基的承载力。提出的桩体弹性模量取值范围可供设计参考。     

高填深切路段装配式预制通涵的受力分析和加固处理

以某高速公路建设中高填深切路段的新工艺（装配式预制通涵）为对象，介绍分析其整体受力情况和加固处理措施，其内容可作为同类工程的参考。     

苏州中心地下空间超长结构温度应力分析

苏州中心建筑平面尺寸巨大,因超长产生的温度应力对结构的影响较为显著。通过分析地下结构从施工到投入正常使用全过程中可能受到的温度荷栽的类型,利用线性分布法计算作用在建筑物上温度荷栽.总结出确定温度作用的计算工况。并以苏州中心地下空间结构为例,介绍了温度应力的计算方法。实际计算表明,降温荷载在框架梁和楼板中产生较大拉应力.楼板开洞部位拉应力集中,温度作用在框架柱中产生剪力和弯矩,在工程设计时必须充分考虑。     

城市管道对于软土地基沥青路面影响分析

该文针对软土地区城市道路地下管道对于沥青路面的不利影响进行分析,采用有限元方法分析了管道周边和上部土基的模量对于沥青面层内部剪应力的影响,并与容许剪切强度进行了对比.提出必须采取合理措施增加管道周边的土基强度,从而有效地避免沥青路面的剪切破坏.     

Multiaxial stress creep rupture mechanisms of AZ31 magnesium alloy

The maximum principal stresses, von Mises effective stresses and principal facet stresses at the time of creep rupture were compared in uniaxial, biaxial, and triaxial stress states for AZ31 magnesium alloy. The creep rupture of this alloy was experimentally controlled by cavitation, which was the result of a low damage tolerance, λ. Creep deformation could be correlated with the von Mises effective stress parameter. The failure-mechanism control parameter governing the stress state coincided with the experimental results of the rupture of the materials under multiaxial stress states. Finally, the theoretical prediction based on constrained cavity growth and continuous nucleation agreed with the experimental rupture data to within a factor of three.     

Influence of polygonal wear of railway wheels on the wheel set axle stress

The coupled vehicle/track dynamic model with the flexible wheel set was developed to investigate the effects of polygonal wear on the dynamic stresses of the wheel set axle. In the model, the railway vehicle was modelled by the rigid multibody dynamics. The wheel set was established by the finite element method to analyse the high-frequency oscillation and dynamic stress of wheel set axle induced by the polygonal wear based on the modal stress recovery method. The slab track model was taken into account in which the rail was described by the Timoshenko beam and the three-dimensional solid finite element was employed to establish the concrete slab. Furthermore, the modal superposition method was adopted to calculate the dynamic response of the track. The wheel/rail normal forces and the tangent forces were, respectively, determined by the Hertz nonlinear contact theory and the Shen–Hedrick–Elkins model. Using the coupled vehicle/track dynamic model, the dynamic stresses of wheel set axle with consideration of the ideal polygonal wear and measured polygonal wear were investigated. The results show that the amplitude of wheel/rail normal forces and the dynamic stress of wheel set axle increase as the vehicle speeds rise. Moreover, the impact loads induced by the polygonal wear could excite the resonance of wheel set axle. In the resonance region, the amplitude of the dynamic stress for the wheel set axle would increase considerably comparing with the normal conditions.     

潜艇耐压结构泵水和下潜状态应力分析

基于求解环肋柱壳的传统方法和有限元法,对潜艇耐压船体在受到内压和外压时应力状态进行了研究。根据传统理论和数值计算结果,对两种状态下的应力进行了详细的对比分析,可以得出受到内压状态时应力要小,并且随着设计潜深的加大两者的偏差也会加大。研究对正确理解泵水和下潜状态下应力之间的关系以及对潜艇结构设计都有重要意义。