轨道交通信号控制系统LCC估算方法研究与应用

从产品全生命周期成本概念出发,阐述了轨道交通信号控制系统生命周期的特点和成本构成;从企业视角提出了一种轨道交通信号控制系统的LCC估算方法;通过企业项目成本管理信息化系统统计产晶LCC的各项数据,结合财务数据进行归一化估算,并定期进行回归迭代,规范化实施分析与评价,从而得出产話的LCC改进建议,为公司战略决策提供了重要参考依据。     

A real-time adaptive signal control in a connected vehicle environment

The state of the practice traffic signal control strategies mainly rely on infrastructure based vehicle detector data as the input for the control logic. The infrastructure based detectors are generally point detectors which cannot directly provide measurement of vehicle location and speed. With the advances in wireless communication technology, vehicles are able to communicate with each other and with the infrastructure in the emerging connected vehicle system. Data collected from connected vehicles provides a much more complete picture of the traffic states near an intersection and can be utilized for signal control. This paper presents a real-time adaptive signal phase allocation algorithm using connected vehicle data. The proposed algorithm optimizes the phase sequence and duration by solving a two-level optimization problem. Two objective functions are considered: minimization of total vehicle delay and minimization of queue length. Due to the low penetration rate of the connected vehicles, an algorithm that estimates the states of unequipped vehicle based on connected vehicle data is developed to construct a complete arrival table for the phase allocation algorithm. A real-world intersection is modeled in VISSIM to validate the algorithms. Results with a variety of connected vehicle market penetration rates and demand levels are compared to well-tuned fully actuated control. In general, the proposed control algorithm outperforms actuated control by reducing total delay by as much as 16.33% in a high penetration rate case and similar delay in a low penetration rate case. Different objective functions result in different behaviors of signal timing. The minimization of total vehicle delay usually generates lower total vehicle delay, while minimization of queue length serves all phases in a more balanced way.     

A signal-based fault detection and classification method for heavy haul wagons

This paper proposes a signal-based fault detection and isolation (FDI) system for heavy haul wagons considering the special requirements of low cost and robustness. The sensor network of the proposed system consists of just two accelerometers mounted on the front left and rear right of the carbody. Seven fault indicators (FIs) are proposed based on the cross-correlation analyses of the sensor-collected acceleration signals. Bolster spring fault conditions are focused on in this paper, including two different levels (small faults and moderate faults) and two locations (faults in the left and right bolster springs of the first bogie). A fully detailed dynamic model of a typical 40t axle load heavy haul wagon is developed to evaluate the deterioration of dynamic behaviour under proposed fault conditions and demonstrate the detectability of the proposed FDI method. Even though the fault conditions considered in this paper did not deteriorate the wagon dynamic behaviour dramatically, the proposed FIs show great sensitivity to the bolster spring faults. The most effective and efficient FIs are chosen for fault detection and classification. Analysis results indicate that it is possible to detect changes in bolster stiffness of ±25% and identify the fault location.     

轨道交通信号设备实训课程体系的研究

高职院校以"服务为宗旨、就业为导向",与地方经济发展相结合,积极探索实践教学的方法,搭建技能型人才培养实践教学体系推动行业与自身的可持续发展。以此为出发点,建立一个完整而完善的信号设备实训课程体系,不仅有利于专业自身的发展,同时也对其他院校有着一定的借鉴意义。从而减少一些重复的工作,推动省内院校轨道信号相关专业整体水平的提升。     

定距桨直联稳频型轴带发电机系统

定距桨直联稳频型轴带发电机系统是在定距桨船舶上,通过双速比或多速比齿轮箱与自励无刷同步发电机相联接而成。其通过在主机遥控系统、主机控制与安保系统、电站管理系统、齿轮箱控制系统之间建立起复杂的逻辑关系,使相关控制、报警信号在不同系统中有序合理传递和反馈,从而达到建立一套低成本、硬件结构简单、电源品质高、能满足CCS、DNVGL等各大船级社无人机舱要求的新型定距桨直联稳频型轴带发电机系统FPP-DL-FSSG。文章介绍了该系统的作用、软硬件的构成和特点,分析了其优缺点并提出使用时的注意事项。对航运企业实行低成本运营以及节能减排具有重要意义。     

海上水声信号处理算法中的物理特性仿真研究

通过研究海上水声信号的产生和海上水声信号定位系统的构成,设计水声信号处理系统流程,指出陆地上的主控中心与水中的基站如何进行信号数据传递,以及环境噪声、传输损耗、多径传输、多普勒效应等物理特性对信号偏移产生何种影响。最后通过实验验证加入消除滤波器后可以有效地控制多普勒效应产生的频率偏移。     

一种基于MUSIC改进算法的宽带水声信号DOA估计

提出一种适用于水声宽带信号的DOA估计算法。该方法首先将时域宽带信号变换到频域,然后划分子带,在每个子带上进行不同的加权得到信号的DOA估计。同时子带算法采用改进的MUSIC算法,降低了DOA高分辨力估计所需要的信噪比。计算机仿真对比了MUSIC算法和改进后算法的空域分辨力,同时也对比了不同信噪比下2种算法的性能。仿真结果表明,改进后的算法无论在适用信噪比条件还是分辨能力上均有较大提高。最后采用某型水下航行器的实航数据对算法进行验证,验证结果表明该算法可在实际应用环境中获得良好的DOA估计。     

有轨电车氢燃料电池系统通风散热方法研究

为解决有轨电车氢燃料电池系统的散热问题,文章提出一种新型车载氢燃料电池系统通风散热方法,分析了该方法的散热原理和控制策略,并对通风散热结构进行了详细介绍.该车载氢燃料电池系统通风散热方法提高了系统散热效率,降低了散热风机能耗.     

基于VHDL有限状态机的交通信号灯控制系统设计

交叉路口交通灯控制的现状,对交通顺畅十分重要.以可编程逻辑器件(CPLD)为核心,应用VDHL语言和有限状态机的方法设计交通信号灯控制系统,在MAX+PLUS Ⅱ环境下进行了仿真实验,结果显示该设计符合设计要求,通过实验,验证了设计的正确性.