江苏省交通事故时间分布分析

根据江苏省有关交通事故数据,利用统计方法对交通事故发生的时间特征进行分析。通过分析交通事故年时间分布规律的波峰曲线,得出江苏省交通事故发生数量开始振荡变化,逐年上升的势头有望于近期遏制。通过分析交通事故、月、周、小时时间分布曲线,得出交通事故高峰小时出现在交通量高峰小时之后的9~12h、14~16h,两者不重合。死亡高峰时段(危险时段)多发生在18~21h的3h内。研究结论对不同时间内如何采取不同的安全对策来降低江苏省交通事故具有指导作用。     

城市高架桥之高独柱墩横向位移探讨

结合城市高架高独柱墩顶部发生横向位移这一现象,对高独柱墩顶部横向荷载产生的原因进行初步分析,并应用三维非线性屈曲分析,阐述组合荷载所引起的大变形及混凝土徐变效应与墩顶横向位移之间的关系,提出了设计、施工类似结构时应注意的事项。     

挂篮底模纵梁受力简化计算方法及承重分配系数

以一桥梁施工工程实例为依托,采用有限元软件ANSYS对桥梁悬臂施工中使用的菱形挂篮进行仿真分析.提出3种简化模式计算底模纵梁的承重分配,对比发现将底模纵梁承受的外荷载简化为集中荷载,并分配至挂篮下前后横梁的方法是最优简化计算方法.在此基础上对挂篮底模纵梁承重分配系数进行优化,从而简化了繁琐的挂篮底模纵梁受力分析计算,保证了挂篮结构设计和施工的安全.     

Simulation on progressive collapse behaviour of whole ship model under extreme waves using idealized structural unit method

To ensure the safety of navigating ship, working loads and structural load-carrying capacity are two important aspects. In the present paper, a total simulation system combing load calculation and structural collapse analysis is applied to simulate progressive collapse behaviour of a single-hull Kamsarmax type bulk carrier. A three dimensional singularity distribution method is adopted to calculate pressure distribution with time history. A mixed structural model, collapse part simulated by ISUM elements and remaining part by elastic FEM elements with relative coarse mesh, is proposed for collapse analysis. Progressive collapse behaviour obtained by ISUM is good agreement with that by nonlinear software package, MARC. However, the calculation time of ISUM analysis is about 1/70 of MARC analysis. The applicability to structure system, high accuracy and sufficient efficiency of ISUM had been demonstrated.     

内压载荷下X80管道裂纹应力分布规律研究

为了研究内压作用下管道裂纹应力场分布规律,以含有表面裂纹的X80管道为研究对象,对不同形状、不同方向、不同内压、不同尺寸的含裂纹管道进行仿真分析和实验验证。结果表明:裂纹尖端处应力远大于裂纹中心应力。裂纹形状对应力影响作用较小,随着裂纹方向与管道轴向夹角增大,裂纹尖端应力先增大后减小,随着管道内压、裂纹深度、裂纹长度的增大,裂纹尖端处应力随之线性增大。其中,裂纹长度对裂纹尖端应力的影响小于管道内压和裂纹深度。     

格拉斯磁环匀强磁场分析

以毕奥-萨伐尔定律为基础,建立亥姆霍兹线圈以及格拉斯磁环中心磁场分布模型,并计算了它们内部的轴向磁感应强度分布,绘出了空间分布图,分析了轴向磁感应强度与x、y坐标的关系,分析结果得到了亥姆霍兹线圈和格拉斯磁环内部匀强磁场分布区域,通过比较得到格拉斯磁环内部的匀强磁场区域比亥姆霍兹线圈内部的匀强磁场分布区域更大的结论。     

A copula-based approach for estimating the travel time reliability of urban arterial

Estimating the travel time reliability (TTR) of urban arterial is critical for real-time and reliable route guidance and provides theoretical bases and technical support for sophisticated traffic management and control. The state-of-art procedures for arterial TTR estimation usually assume that path travel time follows a certain distribution, with less consideration about segment correlations. However, the conventional approach is usually unrealistic because an important feature of urban arterial is the dependent structure of travel times on continuous segments. In this study, a copula-based approach that incorporates the stochastic characteristics of segments travel time is proposed to model arterial travel time distribution (TTD), which serves as a basis for TTR quantification. First, segments correlation is empirically analyzed and different types of copula models are examined. Then, fitting marginal distributions for segment TTD is conducted by parametric and non-parametric regression analysis, respectively. Based on the estimated parameters of the models, the best-fitting copula is determined in terms of the goodness-of-fit tests. Last, the model is examined at two study sites with AVI data and NGSIM trajectory data, respectively. The results of path TTD estimation demonstrate the advantage of the proposed copula-based approach, compared with the convolution model without capturing segments correlation and the empirical distribution fitting methods. Furthermore, when considering the segments correlation effect, it was found that the estimated path TTR is more accurate than that by the convolution model.     

Extreme hawser tension assessment for FPSO vessel during offloading operation in Bohai bay

The Floating Production Storage and Offloading Unit (FPSO) is an offshore vessel that produces and stores crude oil prior to tanker transport.Robust prediction of extreme hawser tensions during Floating Production Storage and Offloading (FPSO) operation is an important safety concern. Excessive hawser tension may occur during offloading operations, posing an operational risk. In this paper, AQWA has been used to analyze vessel response due to hydrodynamic wave loads, acting on a specific FPSO vessel under actual sea conditions. Experimental validation of numerical results has been discussed as well.This paper advocates methodology for estimating extreme response statistics, based on simulations (or measurements). The modified ACER (averaged conditional exceedance rate) method is presented in brief detail. Proposed methodology provides an accurate extreme value prediction, utilizing all available data efficiently. In this study the estimated return level values, obtained by ACER method, are compared to the corresponding return level values obtained by Gumbel method. Based on the overall performance of the proposed method, it is concluded that the improved ACER method can provide more robust and accurate prediction of the extreme hawser tension.Data declustering issue has been addressed. Paper highlights ability of ACER method to account for a set of varying sea state probabilities, as required in engineering long term statistical analysis.Described approach may be well used at the vessel design stage, while defining optimal vessel parameters that would minimize potential FPSO hawser tension.     

轨道复合不平顺对无缝线路横向变形的影响分析

轨道复合不平顺会对行车的安全及稳定性产生较大影响,也是影响无缝线路横向变形的一个重要因素。为研究轨道复合不平顺对无缝线路的具体影响,通过构建三维轨道框架非线性有限元模型,采用轨道框架单点(或多点)位置发生横向及竖向位移来模拟复合不平顺状态,通过计算获取节点位移变化规律,进而分析轨道复合不平顺对无缝线路横向变形的影响作用。研究结果表明,轨道的复合不平顺会对无缝线路的横向变形产生显著的影响;当线路出现三角坑等类似病害时,其节点位移变化更为显著,在无缝线路的日常养护维修中应尤为注意。