桥梁挖孔灌注桩施工技术

挖孔灌注桩具有成孔速度快、机械设备要求低，作业面广等优点。     

预防喷油器针阀卡滞的五条小经验

1．在维修喷油器时，应将全部零件分解后作认真清洗。不可只清洗喷油器偶件，而将喷油器调压弹簧、弹簧螺母、调整螺钉及挺杆等零件置之不管。若这些零件上粘附的污物不能清除，将会通过挺杆窜至针阀上部。而针阀在高频率的上下运动时，污物将会随之窜入针阀体和针阀之间，将针阀卡滞。有鉴于此，所用清洗油一定要清洁，零件一定要清洗干净，清洗与安装等工作均应在清洁的室内进行。     

某矿区生态环境治理工程中的爆破削坡技术

本文介绍了矿区生态环境治理工程中的爆破削坡及清坡工程。详细阐述了预裂爆破中的钻孔参数、爆破参数的选取和计算,并且计算出了爆破飞石安全距离,确定警戒清场范围和一般应急措施。为削坡清坡工程中的爆破工程提供参考依据。     

哈尔滨绕城公路滨北铁路跨线桥布孔方案设计

介绍哈尔滨绕城公路连续跨越滨北铁路、既有道路、规划道路的桥梁布孔和桥型选用设计。     

Convective Heat Transfer Characteristics of the Elliptic Cylinder with Axis Ratio 4：1 in Crossflow

The heat transfer features around the elliptic cylinder of axis ratio 4：1 in crossflow were investigated experimentally within a wide range of Reynolds number. By means of heat-mass transfer analogy and the naphthalene sublimation technique, the local heat transfer distribution and the mean heat transfer coefficient are clarified.The result shows that the mean heat transfer coefficient is higher than that of a circular cylinder in most Reynolds number range regarded, and this superiority turns to be more significant with the increase of flow speed. Moreover, the effect of axis ratio on mean heat transfer coefficient was investigated tentatively. The oil-lampblack technique was employed to enable visualization of the flow pattern around the cylinder and on the cylinder wall.     

后桥壳主差速器连接孔内螺纹孔扩孔后的修复

检查的具体方法是喷油器安装在试验器上后,先将喷油器的压力调至比规定的压力高8～10MPa,然后摇动泵油手柄,使实验器压力升至比上述压力值低4～5MPa,此时记录压力表读数下降2MPa所需要的时间.