Optimum routing of battery electric vehicles: Insights using empirical data and microsimulation

This study investigates the energy consumption impact of route selection on battery electric vehicles (BEVs) using empirical second-by-second Global Positioning System (GPS) commute data and traffic micro-simulation data. Drivers typically choose routes that reduce travel time and therefore travel cost. However, BEVs’ limited driving range makes energy efficient route selection of particular concern to BEV drivers. In addition, BEVs’ regenerative braking systems allow for the recovery of energy while braking, which is affected by route choices. State-of-the-art BEV energy consumption models consider a simplified constant regenerative braking energy efficiency or average speed dependent regenerative braking factors. To overcome these limitations, this study adopted a microscopic BEV energy consumption model, which captures the effect of transient behavior on BEV energy consumption and recovery while braking in a congested network. The study found that BEVs and conventional internal combustion engine vehicles (ICEVs) had different fuel/energy-optimized traffic assignments, suggesting that different routings be recommended for electric vehicles. For the specific case study, simulation results indicate that a faster route could actually increase BEV energy consumption, and that significant energy savings were observed when BEVs utilized a longer travel time route because energy is regenerated. Finally, the study found that regenerated energy was greatly affected by facility types and congestion levels and also BEVs’ energy efficiency could be significantly influenced by regenerated energy.     

Impacts of replacement of engine powered vehicles by electric vehicles on energy consumption and CO2 emissions

This paper evaluates the impacts on energy consumption and carbon dioxide (CO₂) emissions from the introduction of electric vehicles into a smart grid, as a case study. The AVL Cruise software was used to simulate two vehicles, one electric and the other engine-powered, both operating under the New European Driving Cycle (NEDC), in order to calculate carbon dioxide (CO₂) emissions, fuel consumption and energy efficiency. Available carbon dioxide data from electric power generation in Brazil were used for comparison with the simulated results. In addition, scenarios of gradual introduction of electric vehicles in a taxi fleet operating with a smart grid system in Sete Lagoas city, MG, Brazil, were made to evaluate their impacts. The results demonstrate that CO₂ emissions from the electric vehicle fleet can be from 10 to 26 times lower than that of the engine-powered vehicle fleet. In addition, the scenarios indicate that even with high factors of CO₂ emissions from energy generation, significant reductions of annual emissions are obtained with the introduction of electric vehicles in the fleet.     

What drives people to accept automated vehicles? Findings from a field experiment

This field study aims at understanding the influence of direct experience of an automated vehicle (AV, Level 3) and explaining and predicting public acceptance of AVs through a psychological model. The model includes behavioral intention (BI) to use self-driving vehicles (SDVs, Level 5), willingness to re-ride (WTR) in our AV (Level 3), and their four potential determinants, namely perceived usefulness (PU), perceived ease of use (PEU), trust related to SDVs, and perceived safety (PS) while riding in our AV. The last two determinants are largely ignored, but we consider them critical in the context of AVs. Three-hundred students were invited as participants (passengers) to experience the AV. The trust, PU, PEU, and BI of the participants were recorded prior to their experiencing the AV; after this experience, all the constructs of the psychological model were recorded. The participants’ experience with the AV was found to increase their trust, PU and PEU (but not BI), the consistency between PU/PEU and BI, and the explanatory power of BI. The model explained 55% of the variance in BI and 40% in WTR. PU, trust, and PS were found to be steady and direct predictors of both the acceptance measures; PEU predicted BI only after the participants’ AV experience. Mediation analysis showed that trust also can indirectly affect AV acceptance through other determinants. Out-of-sample prediction confirmed the model’s predictive capability for AV acceptance. The theoretical contributions and practical implications of the findings are discussed.     

A framework for user- and system-oriented optimisation of fuel efficiency and traffic flow in Adaptive Cruise Control

Fully automated vehicles could have a significant share of the road network traffic in the near future. Several commercial vehicles with full-range Adaptive Cruise Control (ACC) systems or semi-autonomous functionalities are already available on the market. Many research studies aim at leveraging the potential of automated driving in order to improve the fuel efficiency of vehicles. However, in the vast majority of those, fuel efficiency is isolated to the driving dynamics between a single follower-leader pair, hence overlooking the complex nature of traffic. Consequently fuel efficiency and the efficient use of the roadway capacity are framed as conflicting objectives, leading to fuel-economy control models that adopt highly conservative driving styles.This formulation of the problem could be seen as a user-optimal approach, where in spite of delivering savings for individual vehicles, there is the side-effect of the deterioration of traffic flow. An important point that is overlooked is that the inefficient use of roadway capacity gives rise to congested traffic and traffic breakdowns, which in return increases energy costs within the system. The optimisation methods used in these studies entail high computational costs and, therefore, impose a strict constraint on the scope of problem.In this study, the use of car-following models and the limitation of the search space of optimal strategies to the parameter space of these is proposed. The proposed framework enables performing much more comprehensive optimisations and conducting more extensive tests on the collective impacts of fuel-economy driving strategies. The results show that, as conjectured, a “short-sighted” user-optimal approach is unable to deliver overall fuel efficiency. Conversely, a system-optimal formulation for fuel efficient driving is presented, and it is shown that the objectives of fuel efficiency and traffic flow are in fact not only non-conflicting, but also that they could be viewed as one when the global benefits to the network are considered.     

Infrastructure assisted adaptive driving to stabilise heterogeneous vehicle strings

Literature has shown potentials of Connected/Cooperative Automated Vehicles (CAVs) in improving highway operations, especially on roadway capacity and flow stability. However, benefits were also shown to be negligible at low market penetration rates. This work develops a novel adaptive driving strategy for CAVs to stabilise heterogeneous vehicle strings by controlling one CAV under vehicle-to-infrastructure (V2I) communications. Assumed is a roadside system with V2I communications, which receives control parameters of the CAV in the string and estimates parameters imperfectly of non-connected automated vehicles. It determines the adaptive control parameters (e.g. desired time gap and feedback gains) of the CAV if a downstream disturbance is identified and sends them to the CAV. The CAV changes its behaviour based on the adaptive parameters commanded by the roadside system to suppress the disturbance.The proposed adaptive driving strategy is based on string stability analysis of heterogeneous vehicle strings. To this end, linearised vehicle dynamics model and control law are used in the controller parametrisation and Laplace transform of the speed and gap error dynamics in time domain to frequency domain enables the determination of sufficient string stability criteria of heterogeneous strings. The analytical string stability conditions give new insights into automated vehicular string stability properties in relation to the system properties of time delays and controller design parameters of feedback gains and desired time gap. It further allows the quantification of a stability margin, which is subsequently used to adapt the feedback control gains and desired time gap of the CAV to suppress the amplification of gap and speed errors through the string.Analytical results are verified via systematic simulation of both homogeneous and heterogeneous strings. Simulation demonstrates the predictive power of the analytical string stability conditions. The performance of the adaptive driving strategy under V2I cooperation is tested in simulation. Results show that even the estimation of control parameters of non-connected automated vehicles are imperfect and there is mismatch between the model used in analytical derivation and that in simulation, the proposed adaptive driving strategy suppresses disturbances in a wide range of situations.     

How to assess the benefits of connected vehicles? A simulation framework for the design of cooperative traffic management strategies

Advances in Information and Communication Technologies (ICT) allow the transportation community to foresee dramatic improvements for the incoming years in terms of a more efficient, environmental friendly and safe traffic management. In that context, new ITS paradigms like Cooperative Systems (C-ITS) enable an efficient traffic state estimation and traffic control. C-ITS refers to three levels of cooperation between vehicles and infrastructure: (i) equipped vehicles with Advanced Driver Assistance Systems (ADAS) adjusting their motion to surrounding traffic conditions; (ii) information exchange with the infrastructure; (iii) vehicle-to-vehicle communication. Therefore, C-ITS makes it possible to go a step further in providing real time information and tailored control strategies to specific drivers. As a response to an expected increasing penetration rate of these systems, traffic managers and researchers have to come up with new methodologies that override the classic methods of traffic modeling and control. In this paper, we discuss some potentialities of C-ITS for traffic management with the methodological issues following the expansion of such systems. Cooperative traffic models are introduced into an open-source traffic simulator. The resulting simulation framework is robust and able to assess potential benefits of cooperative traffic control strategies in different traffic configurations.     

Preferences of travellers for using automated vehicles as last mile public transport of multimodal train trips

In the recent years many developments took place regarding automated vehicles (AVs) technology. It is however unknown to which extent the share of the existing transport modes will change as result of AVs introduction as another public transport option. This study is the first where detailed traveller preferences for AVs are explored and compared to existing modes. Its main objective is to position AVs in the transportation market and understand the sensitivity of travellers towards some of their attributes, focusing particularly on the use of these vehicles as egress mode of train trips. Because fully-automated vehicles are not yet a reality and they entail a potentially high disruptive way on how we use automobiles today, we apply a stated preference experiment where the role of attitudes in perceiving the utility of AVs is particularly explored in addition to the classical instrumental variables and several socio-economic variables. The estimated discrete choice model shows that first class train travellers on average prefer the use of AVs as egress mode, compared to the use of bicycle or bus/tram/metro as egress. We therefore conclude that AVs as last mile transport between the train station and the final destination have most potential for first class train travellers. Results show that in-vehicle time in AVs is experienced more negatively than in-vehicle time in manually driven cars. This suggests that travellers do not perceive the theoretical advantage of being able to perform other tasks during the trip in an automated vehicle, at least not yet. Results also show that travellers’ attitudes regarding trust and sustainability of AVs are playing an important role in AVs attractiveness, which leads to uncertainty on how people will react when AVs are introduced in practice. We therefore state the importance of paying sufficient attention to these psychological factors, next to classic instrumental attributes like travel time and costs, before and during the implementation process of AVs as a public transport alternative. We recommend the extension of this research to revealed preference studies, thereby using the results of field studies.     

Shared versus private mobility: Modeling public interest in autonomous vehicles accounting for latent attitudes

Emerging autonomous vehicles (AVs) and shared mobility systems per se will transform urban passenger transportation. Coupled together, shared AVs (SAVs) can facilitate widespread use of shared mobility services by providing flexible public travel modes comparable to private AV. Hence, it may be conjectured that future urban mobility is likely an on-demand service and AV private ownership is unappealing. Nonetheless, it is still unclear what observable and latent factors will drive public interest in (S)AVs, the answer to which will have important implications on transportation system performance. This paper aims to jointly model public interest in private AVs and multiple SAV configurations (carsharing, ridesourcing, ridesharing, and access/egress mode) in daily and commute travels with explicit treatment of the correlations across the (S)AV types. To this end, multivariate ordered outcome models with latent variables are employed, whereby latent attitudes and preferences describing traveler safety concern about AV, green travel pattern, and mobility-on-demand savviness are accounted for using structural and measurement equations. Drawing from a stated preference survey in the State of Washington, important insights are gained into the potential user groups based on the socio-economic, built environment, and daily/commute travel behavior attributes. Key policies are also offered to promote public interest in (S)AVs by scrutinizing the marginal effects of the latent variables.     

Distributed model predictive control for vessel train formations of cooperative multi-vessel systems

Recently, the cooperative control of multiple vessels has been gaining increasing attention because of the potential robustness, reliability and efficiency of multi-agent systems. In this paper, we propose the concept of Cooperative Multi-Vessel Systems (CMVSs) consisting of multiple coordinated autonomous vessels. We in particular focus on the so-called Vessel Train Formation (VTF) problem. The VTF problem considers not only cooperative collision avoidance, but also grouping of vessels. An MPC-based approach is proposed for addressing the VTF problem. A centralized and a distributed formulation based on the Alternating Direction of Multipliers Method (ADMM) are investigated. The distributed formulation adopts a single-layer serial iterative architecture, which gains the benefits of reduced communication requirements and robustness against failures. The impacts of information updating sequences and responsibility parameters are discussed. We furthermore analyze the scalability of the proposed method. Simulation experiments of a CMVS navigating from different terminals in the Port of Rotterdam to inland waterways are carried out to illustrate the effectiveness of our method. The proposed method successfully steers the vessels from different origins to form a vessel train. Due to the effective communication, vessels can timely respond to the velocity changes that others make. After the formation is formed, the distances between vessels become constant. The results show the potential to use CMVSs for inland shipping with enhanced safety.     

An empirical investigation on consumers’ intentions towards autonomous driving

Major steps towards implementation of autonomous and connected transport are being taken nowadays. The trend of automation technology being used in vehicles by the most important vehicle manufacturing industries is expected to move closer to high or fully Autonomous Vehicles (AVs) through technological advancements in sectors of robotics and artificial intelligence. Vehicles with autonomous driving capabilities are planning to be available on market, in full scale, in the next years. In the longer term substantial benefits are mainly expected for accessibility to transport, safety, traffic flow, emissions, fuel use and comfort. All these potential societal benefits will not be achieved unless AVs are accepted and used by a critical mass of people. Addressing these challenges, this paper: (a) proposes a technology acceptance modelling process by extending the original Technology Acceptance Model (TAM) to explain and predict consumers’ intensions towards AVs, (b) based on the proposed TAM-extended framework, a 30-question survey was conducted in order to investigate the factors influencing consumers’ intensions to use and accept AVs. Results show that the constructs of perceived usefulness, perceived ease to use, perceived trust and social influence, are all useful predictors of behavioral intentions to have or use AVs, with perceived usefulness having the strongest impact. The insights derived from this study could significantly contribute to ongoing research related to technology acceptance of AVs and are expected to allow automobile industries to improve their design and technology.