钢管混凝土拱桥空间地震反应谱分析

对一座钢管混凝土拱桥,进行了空间有限元模拟分析,应用大型通用有限元程序ANSYS对大桥建立了模型,解决了桥梁细部诸如支座、刚臂等细节的处理;最后对大桥的有限元模型进行了动力特性计算,得到了振型、频率的数据,可以对大桥的动力性能做出评价,有助于今后建立大桥的档案和健康诊断评估。     

车辆超载作用对路面的影响分析

利用Matlab软件编制程序,对车辆超载问题进行了仿真,分析了由于路面不平整度引起的车辆动荷载和动荷载系数变化规律,得到车辆超载率与车辆动荷载和动荷载系数之间的关系。为路面设计和车辆与路面之间的相互作用提供了理论基础。     

沉管隧道基槽爆破开挖作用下邻近地铁隧道力学响应

为确保邻近地铁隧道在沉管隧道基槽爆破开挖过程的安全性,通过现场实测评价地铁隧道运营现状,借助数值分析法探索地铁隧道对沉管基槽爆破开挖的力学响应特征,并制定既有隧道结构的安全判据和沉管基槽爆破振动安全距离。研究表明： 既有地铁区间隧道现状累计最大沉降为1.89 mm,近半年最大沉降速率为0.01 mm/d,均小于规范规定的控制值,隧道结构现状处于稳定状态;沉管隧道基槽爆破振动引起的地铁隧道结构最大振速为0.359 cm/s,远小于振速安全阈值（2.0 cm/s）,说明地铁结构受爆破振动影响较小,且爆破振动的安全距离为25 m; 基槽开挖应力扰动后引起的地铁隧道累计最大沉降为3.16 mm,小于位移预警值,隧道结构处于稳定状态。     

利用Cruise软件进行整车动力性和燃油经济性仿真分析

本文论述了利用CRUISE软件进行汽车建模的过程,并对某重型商用车的动力性和燃油经济性进行了仿真分析。     

基于车辆平顺性分析的橡胶衬套动态特性建模

橡胶衬套的动态特性与载荷的激振频率、幅值等因素相关,其模型的准确性影响车辆平顺性的仿真精度。建立了包含材料弹性、粘弹性与弹塑性的橡胶衬套动态模型,分别采用多项式、分数导数与Bouc-wen模型描述橡胶衬套的弹性、频率相关性及振幅相关性。通过参数辨识确定衬套模型参数并进行仿真,验证了所建模型的准确性。     

准饱和土中单桩竖向荷载作用下的动力响应

根据Biot饱和多孔连续介质波动方程,基于Bardet对准饱和土的假设,提出了准饱和土二相介质波动方程;运用Helmholtz矢量分解和传递、透射矩阵法(TRM)推导出准饱和土中层状半空间受竖向荷载作用下的动力响应表达式;利用Muki虚拟桩法,在层状半空间建立了桩和准饱和土相互作用的第二类Fredholm积分方程,通过离散的数值积分方法求解积分方程,讨论了准饱和土中单桩竖向动力响应问题.算例分析表明,准饱和土中桩顶竖向阻抗随饱和度的减少而增大,与饱和土地基相比,明显偏大;桩侧孔压随饱和度的减小而增大,并沿着桩长迅速衰减;桩顶位移幅值在频率较小时变化明显,饱和度越小,位移峰值越大,当频率较大时,饱和度的变化对振幅的影响不大.     

增压汽油机不同排气歧管长度下的压力波动特性

利用台架试验数据校准了增压直喷汽油机一维性能仿真模型,应用校准后的模型研究了低速(1 500r/min)全负荷工况不同排气歧管长度下排气阀口与涡轮机入口处的压力波动特性,并对压力波动形态与低速增压压力的建立、瞬态响应、缸内充气效率等的关联性进行了深入分析。研究结果表明:在现有排气歧管结构形式下,在低转速宜采用较短歧管,从而有望获得更高的增压压力和扭矩;相继工作的气缸不宜在涡轮机前共用一根排气总管,否则容易引起废气倒流,而且歧管越短倒流越严重;排气歧管中的压力波在传向涡轮机入口过程中被"均值化",不能充分应用排气压力波动效应来提高低速扭矩和改善增压延迟。     

Experimental study on the nonlinear pressure acting on a high-speed vessel in regular waves

It is well known that the hydrodynamic responses of a high-speed vessel traveling in regular head waves of even moderate wave height can show significant nonlinear behavior, and so linear statistical techniques become insufficient for predicting the statistics of responses in irregular waves. On the other hand, it has been shown that an approximate third-order Volterra model is applicable to handling the statistics of some nonlinear seakeeping problems, such as motions and vertical hull girder loads. In the present study, the focus is on the nonlinear behavior of the pressure responses of the hull surface, especially on the pressures acting on alternately wet and dry areas near the waterline and on the bow zone with high deadrise angles that may be subject to slight impact and water pile-up effects. To clarify the validity of applying Volterra modeling to this problem, a series of experiments in regular and irregular head waves were carried out, and approximate third-order and fifth-order Volterra models with the proposed algorithm for finding frequency response functions (FRFs) were applied as a means of validation. In the present article, the first part of the validation was performed using experimental data in regular waves. It was confirmed that the third-order Volterra model has adequate accuracy to simulate deterministically the variation of pressure responses in regular waves of different wave steepness up to a wave amplitude to wavelength ratio of 0.01 even for the highly nonlinear pressures acting on the above-mentioned areas of the hull surface.     

A consideration of the structural design of a large-scale floating structure

The land area of Japan, especially flat land, is very small compared with its economic size. Large-scale floating structures are one solution to satisfy the demand for space by utilizing the ocean. This paper presents a general view of the dynamic response characteristics of large-scale floating structures, pontoons and semi-submersibles. For example, it is shown that the natural frequencies of eigenmodes are higher than the natural frequency of heaving motion. The response of the outer framework of a structure is shown to be generally larger than the response of the central part. Within the limits of our present understanding of the general dynamic response characteristics of such structures, the design and analysis of semi-submersible, large-scale floating structures is discussed. For a pontoon-type large-scale floating structure, a type whose perimeter structure has been modified to become lighter and more rigid is proposed. With this modification, the dynamic response of the whole structure is imporved.     

集装箱船振动及响应分析

介绍了模态频率响应有限元计算方法的基本理论,以多用途集装箱船为目标船,通过建立全船三维有限元模型,用频率响应法得到船体结构的振动响应.文中还讨论了激励与响应关系、水动质量、阻尼、频率响应计算有效频率数选取等问题,以精确预报船体结构振动及响应.本文采用的分析计算方法对目标船结构振动及响应预报值,与实船试验数据具有很好的一致性.