鸭绿江河口潮流泥沙数值模拟

在分析鸭绿江河口实测水文泥沙资料的基础上,采用MIKE21 FM模块建立了基于多重嵌套网格模式的河口潮流场和泥沙场数学模型,模型范围为上游丹东市的江桥至河口江海分界线以外6~7 m等深线附近,并对2个潮位站、15个流速流向和含沙量测站进行了验证,对现状条件下的河口水域流场和泥沙场进行了数值模拟与分析。研究结果表明:落潮流速一般大于涨潮,沿程变化上浪头港以下2 km附近及斗流浦航槽内平均流速较大,至河口段水面逐渐放宽,致使落潮水流流速有减小趋势;含沙量沿程呈递增趋势,最大含沙量出现在各分汊水道的上口,即斗流浦水域。     

郁江口及羊栏滩汇流段船舶对会条件改善措施研究

长洲枢纽建成后只能渠化其上游159 km航道,水浅流急的羊栏滩处于水库脱水段。在贵港至梧州二级航道整治工程中对羊栏滩进行了整治,但未根本改善回水末端的郁江口及羊栏滩河段的船舶双向通航条件,按照《航道整治工程技术规范》(JTJ312-2003),加宽后的设计方案航道尺度根本无法满足设计船队的双线通航要求,严重影响航道的通过能力。文章分析了郁江口汇流段及羊栏滩河床形态和通航水流条件的特殊性,通过物理模型试验和自航船模试验相结合的方法,提出并研究了满足船舶对会的工程方案,并对现行规范中弯道双向航道尺度的计算方法提出了建议。     

船舶制造企业质量信息管理系统框架模型研究

针对船舶制造企业质量信息管理普遍存在的质量管理体系与实际生产不一致、质量信息断层和信息孤岛等问题,本文提出了一种面向产品全生命周期的质量信息管理集成方案,以质量过程控制为基础,通过规范质量信息的内容和信息传递的渠道,将大量纵横交错汇聚在产品建造过程中的既离散又相关的质量信息有机地联系起来,实现各相关部门（船东、企业内部、供应商）质量信息的透明．     

舰舰导弹对敌水面舰艇突防能力评估模型初探

舰舰导弹是对水面舰艇攻击的主要武器之一,导弹突防能力是评价导弹性能的重要指标.根据反导武器系统的特点,建立了单发和多发导弹对敌舰攻击的突防能力模型.     

潜艇非稳态流场计算流体力学不确定度分析

依照ITTC推荐规程对美国DARPA潜艇模型SUBOFF光体在不考虑自由表面情况下的CFD计算进行不确定度分析。选取中间尺度的时间步长,验证中采用细、中、粗三套网格。在最精细的网格上进行不同时间步长的研究。最后对潜艇表面压力计算进行确认。     

风浪流联合作用下RMFC码头运动性能试验研究

RMFC码头作为连岸设施,周围布置有锚泊系统,其工作海域水深很浅,深度随距海岸线距离而变化。由于利用多刚体水动力学的计算分析难以保证结果的正确性,因此,采用试验方法研究RMFC码头的运动性能。假定单元间的接头和系泊系统可有效承担风、浪、流诱导产生的载荷,通过试验研究RMFC码头典型单元六自由度运动,以验证此种RMFC码头布置形式的有效性。     

全回转起重船多系统耦合运动响应仿真分析

根据运动学基本原理,计入船-吊物、船-锚链耦合影响以及起重船自身受到的外环境载荷,建立船舶多系统运动模型。利用MATLAB/Simulink软件进行仿真,对多系统耦合作用下的船舶运动进行数值分析。分别在不同的遭遇浪向角和不同的吊臂回转角下,对船舶在各自由度上的位移进行比较,得到其对船舶运动参数的影响规律。结果表明:起重船运动过程中因计入多系统耦合影响,自身运动也表现出更为符合实际的运动特性,为准确预报全回转起重船多系统的运动响应提供了更为科学的理论依据。     

Mechanism of Tunnel Water Inflow Caused by Bending Failure of a Waterproof Dike Based on a Circular Thin Plate Mechanical Model北大核心CSCD

Water bursts during tunnel construction endanger construction, and it is therefore necessary to reserve a waterproof dike with the required thickness to avoid water bursts and to take reinforcement of the dike and treatment of the structure liable to trigger a water burst. Using the water burst at K5+398 of the Mingyueshan tunnel of the Shanghai-Chengdu expressway as an example, and considering the type of tunnel section and the upright mudstone of the dike, the waterproof dike at the work face is simplified as a round thin plate. A formula for the calculation of a minimum safety thickness for the critical waterproof dike is deduced by analyzing the force applied on the water-proof dike, and the minimum safety thickness for the water burst section at K5+398 of the Mingyueshan tunnel is cal-culated. The numerical simulation analysis demonstrates the critical thickness of waterproof dike at K5+398 of the Mingyueshan tunnel is 1.4-1.55 m, and the calculated water inflow and water burst basically agree with the actual condition. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Emission rates of intermodal rail/road and road-only transportation in Europe: A comprehensive simulation study

Intermodal rail/road transportation combines advantages of both modes of transport and is often seen as an effective approach for reducing the environmental impact of freight transportation. This is because it is often expected that rail transportation emits less greenhouse gases than road transportation. However, the actual emissions of both modes of transport depend on various factors like vehicle type, traction type, fuel emission factors, payload utilization, slope profile or traffic conditions. Still, comprehensive experimental results for estimating emission rates from heavy and voluminous goods in large-scale transportation systems are hardly available so far. This study describes an intermodal rail/road network model that covers the majority of European countries. Using this network model, we estimate emission rates with a mesoscopic model within and between the considered countries by conducting a large-scale simulation of road-only transports and intermodal transports. We show that there are high variations of emission rates for both road-only transportation and intermodal rail/road transportation over the different transport relations in Europe. We found that intermodal routing is more eco-friendly than road-only routing for more than 90% of the simulated shipments. Again, this value varies strongly among country pairs.     

The role of volume-delay functions in forecasting and evaluating congestion charging schemes: the Stockholm case

This paper uses observations from before and during the Stockkholm congestion charging trial in order to validate and improve a transportation model for Stockholm. The model overestimates the impact of the charges on traffic volumes while at the same time it substantially underestimates the impact on travel times. These forecast errors lead to considerable underestimation of economic benefits which are dominated by travel time savings. The source of error lies in the static assignment that is used in the model. Making the volume-delay functions (VDFs) steeper only marginally improves the quality of forecast but strongly impacts the result of benefit calculations. We therefore conclude that the dynamic assignment is crucial for an informed decision on introducing measures aimed at relieving congestion. However, in the absence of such a calibrated dynamic model for a city, we recommend that at least a sensitivity analysis with respect to the slope of VDFs is performed.