从太旧路维修浅析路面早期损坏成因

我国的沥青路面结构及设计方法经历了一个相当长的演变过程,但基本是按照"强基、薄面、稳土基"的理论基础进行路面结构设计,近年来,采用"半刚性基层"建设的高速公路,路面均不同程度地发生了早期破坏,长的2～3年,短的几个月,不得不进行维修,早期修建的一些高速公路,大多没有达到设计使用年限便早早开始了大修。从太旧路发生损坏的内因、外因进行了全面分析,对目前设计的主流思想提出了质疑,并从太旧路的实践中根据损坏原因进行了有的放矢的维修,取得了良好的效果。     

长沙南湖路湘江隧道通风方案初探

基于我国的经济技术发展现状及趋势,借鉴公路隧道通风的相关设计理论、原则以及国内已建类似工程的经验,针对长沙市南湖路湘江隧道的工程特点,探讨并分析影响该隧道通风方案确立的因素,提出既满足隧道内的行车安全和洞外环保要求,又有利于降低工程造价和减少运营费用的通风方案。     

Mechanism of Tunnel Water Inflow Caused by Bending Failure of a Waterproof Dike Based on a Circular Thin Plate Mechanical Model北大核心CSCD

Water bursts during tunnel construction endanger construction, and it is therefore necessary to reserve a waterproof dike with the required thickness to avoid water bursts and to take reinforcement of the dike and treatment of the structure liable to trigger a water burst. Using the water burst at K5+398 of the Mingyueshan tunnel of the Shanghai-Chengdu expressway as an example, and considering the type of tunnel section and the upright mudstone of the dike, the waterproof dike at the work face is simplified as a round thin plate. A formula for the calculation of a minimum safety thickness for the critical waterproof dike is deduced by analyzing the force applied on the water-proof dike, and the minimum safety thickness for the water burst section at K5+398 of the Mingyueshan tunnel is cal-culated. The numerical simulation analysis demonstrates the critical thickness of waterproof dike at K5+398 of the Mingyueshan tunnel is 1.4-1.55 m, and the calculated water inflow and water burst basically agree with the actual condition. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Analysis on the Characteristics and Development Trends of the Support Technology of High Ground Stress Tunnels in China北大核心CSCD

Combining the present situation and development trend of different tunnel support technologies at home and abroad, this paper analyzes the problems of rockburst in hard rock tunnels and large deformation in soft rock tunnels caused by high ground stress. It is concluded that: 1) regarding the rockburst problem, the current support technology is mainly influenced by the rock burst mechanism which is dominated by static factors, and so the used support components are generally of smaller deformation performance and "passive support" properties; 2) as the rockburst is the result of dynamic-static stress coupling, and only the anchor bolt has the "active support" attribute in the current "shotcrete+anchor bolt+wire net" support system, so the best support system should have the two functions of active support and energy release in terms of the rockburst problem, and the key focus of the research and development is anchorage members; 3) there are three main support types for large deformation in soft rock tunnels, e.g. the heavy support, layered support and yielding support. Among them, the heavy support system in underground cavern with large deformation is easy to induce excessive surrounding rock pressure, and so the applicable conditions are limited. The layered support system is still not the best choice due to its immature theoretical study, difficult determination of the thickness value and the installation time of each support layer and the interference to construction progress. With the characteristics of timely support and yielding while supporting, the yielding support system can give full play to the performance values of surrounding rocks and supporting materials, and make both of them reach the optimal state, so it is the best choice for supporting the soft rock tunnels with large deformations. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Numerical Simulation of Advanced Geological Forecasting Based on Multi- Source Seismic Interferometry北大核心CSCD

For existing advanced geological forecasting, the forecast distance is short and the test frequency is high, increasing test and construction risks. Since various methods have different requirements for the test environ-ment, preparation work can be tedious and result in a long construction time thereby affecting normal construction.A new advanced geological forecast technique based on multi-source seismic interferometry for tunnels is proposed.This technique uses the blast at one end of tunnel as a centrum and receives the signal at the other end of the tun-nel, therefore allowing advanced geological forecasting of the unexcavated tunnel part by relative processing and im-aging. A numerical simulation of this kind of geological forecasting using the finite difference method to simulate two kinds of unfavorable geological bodies (karst and a fault) predicted them accurately and verified the effective-ness and accuracy of this geological forecasting method. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

A Study of Prevention Techniques for Tunnel Lining Defects北大核心CSCD

Defects of tunnel lining, such as inadequate thickness, voids, cracks, rock falling and water leakage etc., endanger the safety of railway tunnel operation. Based on the site construction, an analysis of the reasons for lining defects was conducted; technical measures against lining defects were proposed and tests were carried out at site. The results show that these measures are reliable and effective, and the purposes of prevention and treatment are re⁃ alized. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

穿越古滑坡川主寺隧道围岩破坏特征及稳定性研究

文章以川主寺隧道所处的工程地质条件为基础,通过现场调研分析了隧道围岩变形破坏形式主要为坍塌、掉块以及剥落.围岩稳定性三维有限元数值模拟结果显示,碎裂围岩自稳能力差,围岩变形以弹塑性变形、松弛变形为主;H型钢拱架支护结构对碎裂围岩稳定性起到积极的作用,并通过典型洞段现场位移监测数据分析结果得以证实.     

偏压连拱隧道施工方法研究

文章采川三维有限元数值模拟研究了偏压连拱隧道不同施工顺序下拱顶下沉、中墙稳定性及初期支护受力特征.研究结果表明,先开挖浅埋侧时,拱顶沉降较小,中墙在施工中的稳定安全系数较大、弯矩较小,初期支护受力较大;对于浅埋偏压连拱隧道,围岩变形及中墙在施工中的稳定性控制更为重要.所以,从有利于围岩变形、中墙稳定性控制以及中墙受力的角度出发,宜采用先开挖浅埋侧的施工方法.     

浅埋偏压段隧道洞口地表沉降变形控制分析

文章对岜肯隧道浅埋偏压段洞口施工中出现的塌方及初衬开裂情况进行客观分析,结合施工实际提出了地表加固及平衡土体偏压措施,有效地控制了地表变形及隧道沉降开裂,保证了隧道施工安全、顺利进行。     

广西高速公路生态环境保护对策研究

文章针对广西高速公路生态环境现状,分析当前高速公路环境保护工作中存在的问题,从生态学角度提出了高速公路沿线生态环境建设和保护对策。