Ecologically based hybrid life cycle analysis of continuously reinforced concrete and hot-mix asphalt pavements

An ecologically-based hybrid life cycle assessment model is used to evaluate the resource consumption and atmospheric emissions of continuously reinforced concrete and a hot-mix asphalt pavements. The cumulative mass and ecological resource consumption values are lower for continuously reinforced concrete, but the median values of cumulative energy and industrial energy consumption were lower for hot-mix asphalt. In addition, the use of reclaimed asphalt pavement results in a higher sensitivity for the ecological resource consumption of hot-mix asphalt compared to that of fly ash when use on the natural capital utilization of continuously reinforced concrete pavement. The cumulative and industrial exergy consumption values are significantly reduced with increases in reclaimed asphalt pavement and fly ash, and the use of low fuel transportation modes.     

结构分割转换工法在地下空间开发中的应用及设想

为了更加快速、安全、高效地完成城市地下空间开发,以结构分割转换工法（CC工法）为研究内容,从工法内涵、工程实践和应用推广3个角度展开研究。首先,基于ＣＣ工法的最新研究成果,从结构分割、建造方案及节点处理3个方面详细介绍CC工法的核心内容;然后,结合工程实践对该工法进行验证性研究,重点比较跨中设缝与柱顶设缝方案的优缺点,介绍该工程地下结构分割、转换的过程,最终证实CC工法建造地下空间的合理性、灵活性及适用性;最后,进行CC工法在富水地层中应用的可行性研究,通过对CC工法与明挖法、暗挖法、型钢混凝土、地面预制装配式结构等技术进行结合应用研究,得出在特定的工程条件下,CC工法也具有与其他先进工法结合应用的价值。     

浅埋小间距矩形顶管掘进姿态控制技术探讨

为解决采用结构分割转换工法（CC工法）建造的某地下停车场小间距隧道群矩形顶管施工中顶管机出现栽头及掘进姿态控制困难的问题,结合项目施工过程的姿态监控数据,对产生栽头及姿态偏差的原因进行理论分析,提出相应的控制技术,并采取现场试验的方法进行效果验证。结果表明： 1）顶管机栽头现象的原因主要有顶管机体重心偏差、漏浆、姿态预留不够、后靠不稳; 2）通过设备和管节定位处理、洞门密封处理、增加始发姿态预留量、后靠稳定性控制等措施可有效防止顶管机栽头; 3）始发阶段采取洞门预留、破除等控制措施,掘进阶段控制掘进速度并辅以“E”型导向槽进行轴线控制等措施,可有效控制顶管机顶进姿态; 4）通过采取调整铰接油缸行程差、主推油缸行程差及姿态偏差方向的土压等姿态纠偏技术措施,取得了良好的施工效果。     

压气条件下泥膜进气值测量试验研究

在压气条件下,进气是泥膜透气失效的起始点。为测量并研究泥膜在气压下的进气压力值（进气值）,通过自制的试验装置,在不同压气条件下对3种泥膜进行进气值测量试验。试验结果表明： 1)由闭气排水与固结排水的差值可以辨别泥膜是否进气,得到泥膜进气值; 2)采用泥膜特征孔径D90/2代入推导公式可近似计算泥膜进气值; 3)泥膜在不同压气条件下进气值不同,增压速率越低,泥膜进气值越大; 4)在较快和较慢的增压速率下存在进气值变化趋于稳定的现象,最大进气值为最小值的2倍以上。     

管线敷设与风机室布置对综合管廊通风阻力影响研究

为准确估算管线敷设与风机室内气流相互作用对压降损失的影响,基于武汉市江夏区谭鑫培路地下综合管廊项目建立典型数值分析模型与分析流程。通过建立典型管线布置的GIL舱、高压舱与综合舱的计算流体动力学三维模型,分别对入口段与稳定段进行分析,并使用循环边界条件来考虑稳定段流体的充分发展,得到阻力系数随流量的变化规律;通过建立GIL舱典型排风口三维模型,分析风机室中不同风机的压降损失,并与规范估算值进行比较。研究结果表明： 管线敷设对压降损失的影响不可忽视;风机室风机相互作用显著,规范不能准确估算该相互作用导致的压降损失。     

地下交通转换平台射流通风特性及风流组织方式研究

为探究地下交通转换平台内通风系统的合理布局,采用比尺模型试验和CFD模拟相结合的方法,研究射流风机和通风组织对地下交通转换平台内气流运动的影响。结果表明： 1）当联络通道内风机射流朝向敞开段时,为使风机升压系数Kj最大,630 mm、900 mm、1 120 mm射流风机的布设位置应距离敞开段分别大于40、50、65 m; 2）大口径射流风机具有更大的Kj,但占用的断面空间更大,且射流诱导段更长,应根据联络通道长度和高度合理选择射流风机口径; 3）地下交通转换平台的通风组织不宜采用同侧开启方式,采用对角抽吸方式时,联络通道内的污染物混入比最低、通风效率最高。     

Sustainability and interactivity between cities and ports: a two-stage data envelopment analysis (DEA) approach

Ports and cities are intrinsically linked. Port city, which serves as a link between the local and global economy, is an integration of both urban and port systems. Constrained by different regional structures, port cities have developed various formulations over time. Using a two-stage data envelopment analysis (DEA) approach, this paper proposes a new method for measuring the sustainable development of different port city systems. While the previous empirical studies often separate the port system and the urban system, this paper assesses the two systems in an integrated way. Moreover, this paper develops a systematic methodology for measurement of sustainability. Twenty world-leading container port cities are selected for this study using contemporary data. The DEA results display their relative differences in levels of sustainable development, which reveal the effectiveness of the prevailing policies in them. Eventually, recommendations are drawn for other port cities by referring to the best practices.     

基于HMM-SVR的船舶动力设备故障模式识别与状态预测研究

船舶动力设备因故障监测信号样本少、变化缓慢且数据特征呈非线性,使得设备故障模式的准确识别和状态预测比较难。鉴于此,文章研究了基于隐马尔科夫模型的故障模式识别方法,利用该模型将微弱变化的信号特征转换为变化较大的对数似然概率对故障模式实现有效识别。在此基础上进一步提出基于HMM-SVR的设备状态预测模型,将遗传算法用于支持向量回归模型参数寻优,并结合隐马尔科夫模型,实现对设备状态的预测。对船用柴油机进行仿真,结果表明上述模型具有较高的识别率,能准确预测船舶动力设备的当前状态。     

考虑螺旋桨体积力的水下机器人水动力特性仿真

为在初步设计时预测ROV的水动力性能,使用CFD技术进行分析,以ROV模型为例,最大程度地保留ROV内部的构件,使模型更加接近真实状况。分别计算ROV在不同工况下的阻力、不同漂角下的横向力和转艏力矩以及添加体积力模型之后的螺旋桨流场状况,很好地模拟出ROV周围的流场,并与已有的试验数据进行对比。结果验证了CFD水动力仿真的可行性和准确性,并还可预测ROV在螺旋桨作用下的进速等,对ROV设计具有实际的参考价值和指导意义。     

Situation analysis forecasting: the case of European maritime clusters

Within the literature concerned with aspects of competitiveness, innovation and strategic management of industrial clusters, the body regarding forecasting of strategic management is still nascent. This work aspires to render a contribution within the domain of strategic management forecasting, through the indicative case of European maritime clusters. For this end, a two-tier model is formulated. A quantitative strengths, weaknesses, opportunities, and threats (SWOT) methodology that derives from the fusion of a quondam situation analysis and crosstabs’ theory is generated. This leads to the utilization of the crosstab’s conditional probabilities as transition probabilities; the latter are called to compile the transition matrix of a Markov chain. Through this methodology, and the successive Markov chain’s transition matrices, strategic forecasts are extracted for a devised European maritime cluster case. This work relinquishes a novel application with respect to strategic management forecasting, that provides a dichotomy of practical interpretations and scenarios for quantitative situation analysis. Thus, it may enable effective real-time decision-making for strategic management and/or policy drafting. The situation analysis forecasting model may find applicability in a plethora of practical and theoretical cases, wherein forecasting may be desirable. It may as well pertain to an intrinsic methodology for situation analysis forecasting of maritime clusters.