具有模块化结构的汽车动力学仿真模型的初步研究

初步探讨了面向开发型驾驶模拟器的具有模块化结构的汽车动力学仿真模型建立方法，从而可以在此基础上进一步建立一套通用的面向结构的汽车动力学仿真程序，便捷地在开发型驾驶模拟器上实现对不同类型或同类型不同结构车辆性能的仿真。     

城市公交客车发展趋势

本文从未来十年城市社会经济和文化发展的角度分析了公交客车发展的趋势:即动力设计环保化、形体设计大型化、技术配置多样化、性能选择人本化、信息沟通智能化、外观设计艺术化、操作系统自动化、应急设置可靠化、总成寿命同步缩短化、车身结构轻型化。     

发动机排气有源消声技术研究进展及发展趋势

简要介绍了发动机排气噪声的特点及其有源消声治理方法;就发动机排气有源消声技术的关键环节及其最新研究情况作了详尽的归纳和总结。评述了目前研究中尚存的问题与不足,并预测了其研究发展趋势。     

GZ机油添加剂对发动机环保性能影响的试验研究

通过对各种汽油机、柴油机进行的有无GZ添加剂时的对比试验,证明了GZ机油添加剂能降低发动机的机械噪声,减少柴油机排气烟度和汽油机的怠速有害排放,改善发动机的环保性能。     

Bosch VDC系统的控制原理及展望

VDC系统(Vehicle Dynamics Control、车辆动力学控制系统，在美日等国称为VDC，而在欧洲称为ESP，Electronic Stability Program，即电子稳定程序)是Bosch公司1995年推出的用于改善车辆操纵稳定性的一种车辆动力学控制系统。VDC系统包括两个控制回路：控制车辆运动的主控制回路，控制制动和驱动滑移的副控制回路。文中详细介绍了这两个回路的工作原理，并给出了改善车辆操纵稳定性的实例。最后，指出了VDC系统的发展趋势。     

电动助力转向系对汽车角输入响应影响的仿真

详细地分析和推导出了具有不同控制方式的EPS系统的传递函数，在Matlab环境中进行了仿真计算并对结果进行了分析，定性地说明了EPS系统的控制方式和结构参数对汽车转向盘角阶跃输入下的稳态、瞬态和频率响应特性的影响。     

桑塔纳汽车后桥强度有限元分析及改进方案

根据桑塔纳2000汽车后桥的实际结构，利用通用有限元软件ANSYS，对后桥进行了弹塑性静态结构有限元分析。主要研究了结构焊接处强度、横梁破坏处在半个周期载荷波内应力状态变化；给出了在最大剪应变幅平面上，影响疲劳强度及寿命的基本参量的计算结果；提出了提高后桥强度的改进方案。     

Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

汽车车身结构碰撞性能的试验研究

为了在碰撞事故中有效地保护乘员的生命安全，汽车首先必须具备安全车身，以确保事故中乘员的生存空间及缓和冲击，其后应配置合理的乘员约束条件，以避免或减缓乘员与车内结构二次碰撞造成的灾害。详细介绍了车身构件碰撞性能的试验方法和研究结果。     

汽车操纵动力学十八自由度模型仿真研究

本文介绍了根据多刚体动力学中的凯恩方法建立的一般两轴汽车的十八自由度数学模型。