块石基床爆夯技术在重力式码头的应用及质量控制

爆夯技术近年在重力式码头抛石基床上得到广泛应用,本文结合福建某重力式码头基床、地基及水文的实际情况,总结块石基床水下爆炸夯实技术的设计、施工工艺、质量控制及爆破的安全控制,以供类似工程参考。     

运输船舶在波浪中失速的近似估算

如何准确、快速、简便地估算船舶在波浪中的失速,已成为船舶研究、设计人员及航运界有关人员共同关心的一个重要课题。文中给出了近似估算运输船舶在波浪中失速的2个方法。对处于初步设计阶段且尚未做过静水快速性能模型试验的运输船舶,可直接应用第2个方法。该方法提出的近似估算公式应用方便,也不用编程便可直接人工计算,且与模型试验结果相当吻合。     

船舶辅机直流调速系统失磁故障的分析及研究

分析了船舶辅机直流晶闸管调速系统各种控制方案失磁的原因,提出了解决失磁问题的方法,设计出了相关的检测电路,并给出了电路参数及调试时应注意的问题.     

挖泥船产量计密度测量精度分析及放射源核素、活度选择研究

通过理论分析结合长江武汉航道工程局挖泥船施工现场情况提出以清水计数率作为密度测量精度的评价指标,在此基础上推导出针对不同排泥管径所需放射源活度的计算公式,据此结合现场条件建立放射源核素及活度的选择条件,为提高设备的有效性提供依据。     

烟台某工程循环水取、排水工程压水试验

为确定烟台某工程地基基岩的渗透特性,阐述水上岩体压水试验的主要操作过程、试验数据处理和试验结果分析评价方法．测定区域内的各岩层的透水率和渗透系数,给出不同风化程度岩层的渗透性评价,为设计提供防渗设计所需参数。     

山区高速公路弃土场的综合设计探讨

针对山区高速公路建设过程中弃土场大量出现的实际情况,结合安徽省山区高速公路的具体设计工作,对弃土场进行价值分析,提出了综合设计思路,有助于推动弃土场设计的发展。     

城市轨道交通中压网络供电分区的划分

以主变电所集中供电的中压网络为基础,从建设、运营经济性、过补偿和继电保护设置配合方面,分析供电分区划分应考虑的问题;网络构成及供电分区的划分位置应考虑与运行交路的结合,最大限度地满足车辆的运行,不因网络局部故障造成全线车辆停运.供电分区的划分在满足规范要求电压损失的前提下,尽可能减少供电分区的数量,以使工程具有较好的经济性.提出在满足继电保护要求等的前提下,线路电压损失要求是中压网络供电分区划分从建设和运营经济性考虑的合理结合点.     

铁道车辆运行安全评判的轮对爬轨脱轨准则

为了掌握车辆爬轨脱轨机理及主要影响因素,分析了轮对的三维空间受力,推导了轮轨横向力和垂向力比值的一般表示式,假设车轮在达到最大轮缘接触角时为脱轨的临界状态,并认为这时轮轨间出现完全摩擦滑动,导出了不考虑轮对摇头角的临界脱轨判别的二维准则与考虑轮对摇头角和轮轨蠕滑率效应的三维脱轨判别准则,给出了轮轴脱轨系数的定义,采用轮轴脱轨系数和轮重减载率进行脱轨的判别。仿真计算结果表明:二维脱轨判别准则与三维准则相比偏于保守;摇头角越小甚至变负,越有利于防止脱轨,摇头角越大,三维准则的临界脱轨曲线越接近于二维准则的;减小轮轨摩擦系数与增大轮缘角均有利于防止脱轨的发生。     

Corrosion rate measurements in steel sheet pile walls in a marine environment

Corrosion of steel structures in the marine environment is a major problem. The deterioration of this kind of structures is costly and difficult to predict both when designing new structures and when estimating the remaining service life time for existing structures. The aim of this investigation was to find indicative values for the corrosion rate of steel sheet piles on the Swedish west coast. Such corrosion rates (mm/year) can be used both when designing new structures by oversizing the steel thickness and when estimating the bearing capacity of existing sheet pile structures. Earlier investigations on the corrosion rates along the Swedish east coast – with salinity from about 0.2% to 0.8% – are still used today as guidelines for the corrosion rate of all steel structures in the Swedish maritime environment even though the salinity on the west coast can be as high as 3.0%.Steel sheet pile wharfs located in the port of Halmstad on the Swedish west coast were inspected by ultrasonic measurements. Three wharf structures with a total length of about 700 m were inspected. None of the inspected wharfs had or have had cathodic protection. The thickness measurements of the steel sheet pile structures were performed by divers.The age of the three inspected sheet pile structures ranged from 36 to 51 years. The dimensions of the original sheet pile sections are known. One of the quay structures is located along a river. The salinity at all wharfs varied from low values at the surface to approx. 2% at the bottom (also in the river outflow).The measured average corrosion rates were in the same order as the design values in the European code. However, the results indicate increased corrosion rates about 1 m below the mean water surface and at the level of the propellers from the ships berthing the most frequented of the inspected wharfs, 3–6 m below water surface.The tolerances of steel sheet thicknesses – usually in the order of ±6% – are often neglected when investigating the remaining thickness in steel sheet piles. A simple calculation model shows that the sheet pile must be almost 50 years of age before an accurate estimation on the corrosion rate can be made, considering the tolerances, if the true original sheet pile thickness is not known.     

沥青路面运营初期平整度竣工验收标准研究

采用数理统计原理,运用SPSS软件对陕西省7条高速公路交-竣工平整度数据进行分析,得出了陕南、关中和陕北地区路面平整度衰变幅度均值分别为0.39m/km、0.28m/km和0.24m/km,这也将作为计算竣工验收推荐值的依据;再基于交-竣工平整度变化规律,建立了平整度竣工验收推荐值的计算公式:IRIju=IRIji+IRIs,可为今后平整度竣工验收标准提供有效的理论依据。