非港湾式公交停车对道路交通流的影响分析

公交车进出站点不仅影响本身,也给其他车辆运行带来很大干扰。文章首先比较全面地分析非港湾式公交停车影响下道路交通流特征,然后借助于EXCEL软件,构建关于公交停车频率、公交停车时间、最大公交停车长度及其存在时间、道路流量的车速和车头时距多元线性模型,并进行了严格的数学检验。该研究为合理分析路段交通流状况、正确计算区间行驶车速与车头时距提供了依据。     

Experimental and empirical investigations of traffic flow instability

Traffic instability is an important but undesirable feature of traffic flow. This paper reports our experimental and empirical studies on traffic flow instability. We have carried out a large scale experiment to study the car-following behavior in a 51-car-platoon. The experiment has reproduced the phenomena and confirmed the findings in our previous 25-car-platoon experiment, i.e., standard deviation of vehicle speeds increases in a concave way along the platoon. Based on our experimental results, we argue that traffic speed rather than vehicle spacing (or density) might be a better indicator of traffic instability, because vehicles can have different spacing under the same speed. For these drivers, there exists a critical speed between 30 km/h and 40 km/h, above which the standard deviation of car velocity is almost saturated (flat) along the 51-car-platoon, indicating that the traffic flow is likely to be stable. In contrast, below this critical speed, traffic flow is unstable and can lead to the formation of traffic jams. Traffic data from the Nanjing Airport Highway support the experimental observation of existence of a critical speed. Based on these findings, we propose an alternative mechanism of traffic instability: the competition between stochastic factors and the so-called speed adaptation effect, which can better explain the concave growth of speed standard deviation in traffic flow.     

潜艇均衡系统自流注水调节阀稳态噪声试验研究

本文模拟建立了潜艇均衡系统自流注水试验系统,对不同假海压力、不同系统流量、不同出口背压及串联2台调节阀时自流注水稳定过程振动噪声进行研究。结果表明:潜艇均衡注水振动噪声随着假海深度的增大而增大;空气噪声随流量调节阀开度的增大而增大,在流量调节阀开度为60°-70°之间,振动加速度及水动力噪声产生峰值;在出口背压为0-0.5 MPa之间时,振动噪声值均大于无背压状态,峰值为0.2 MPa;串联2台流量调节阀可大幅降低自流注水振动噪声。     

鱼雷发动机三组元比例控制器数值模拟

利用计算流体力学软件Pumplinx模拟鱼雷发动机中三组元比例控制器的内部流场,分析计算中不同压差情况下对比例控制器性能的影响,以及叶片与定子间间隙大小对于比例控制器性能的影响,同时对不同叶片数目下性能进行对比。计算结果表明:由于比例控制器为被动旋转马达结构,其转速和流量均随时间呈周期性脉动变化,随着工作压差增大,转速脉动幅度基本保持不变,而流量和扭矩脉动幅值增加;随着间隙增大,泄漏量增大,但流量、扭矩、转速脉动幅值大幅降低,出口流量较为平稳;叶片数目增多后比例控制器转速降低、排量降低。由计算结果推断出目前比例控制器的最优叶片数目为4。本文可为进一步研究比例控制器精度问题提供参考。     

Continuum theory for pedestrian traffic flow: Local route choice modelling and its implications

This contribution puts forward a novel multi-class continuum model that captures some of the key dynamic features of pedestrian flows. It considers route choice behaviour on both the strategic (pre-trip) and tactical (en-route) level. To achieve this, we put forward a class-specific equilibrium direction relation of the pedestrians, which is governed by two parts: one part describing the global route choice, which is pre-determined based on the expectations of the pedestrians, and one part describing the local route choice, which is a density-gradient dependent term that reflects local adaptations based on prevailing flow conditions.Including the local route choice term in the multi-class model causes first of all dispersion of the flow: pedestrians will move away from high density areas in order to reduce their overall walking costs. Second of all, for the crossing flow and bi-directional flow cases, local route choice causes well known self-organised patterns to emerge (i.e. diagonal stripes and bi-directional lanes). We study under which demand conditions self-organisation occurs and fails, as well as what the impact is of the choices of the different model parameters. In particular, the differences in the weights reflecting the impact of the own and the other classes appear to have a very strong impact on the self-organisation process.     

Tuning of transfer functions for analysis of wave–ship interactions

Transfer functions are often used together with a wave spectrum for analysis of wave–ship interactions, where one application addresses the prediction of wave-induced motions or other types of global responses. This paper presents a simple and practical method which can be used to tune the transfer function of such responses to facilitate improved prediction capability. The input to the method consists of a measured response, i.e. time series sequences from a given sensor, the 2D wave spectrum characterising the seaway in which the measurements are taken, and an initial estimate of the transfer function for the response in study. The paper presents results obtained using data from an in-service container ship. The 2D wave spectra are taken from the ERA5 database, while the transfer function is computed by a simple closed-form expression. The paper shows that the application of the tuned transfer function leads to predictions which are significantly improved compared to using the transfer function without tuning.     

基于ANN的船舶撞击高桩码头群桩损伤位置预测

本文采用有限元软件ABAQUS建立了船舶撞击高桩码头群桩的空间有限元模型。通过计算评估了撞击力、桩体刚度、撞击位置和撞击角度下对群桩结构损伤位置的影响。基于人工神经网络(ANN)方法,对不同参数组合下的群桩结构损伤位置进行了预测,并对ANN方法的可行性进行了评估。     

Closed-form multiclass cell transmission model enhanced with overtaking,lane-changing,and first-in first-out properties

A novel multiclass macroscopic model is proposed in this article. In order to enhance first-in, first-out property (FIFO) and transmission function in the multiclass traffic modeling, a new multiclass cell transmission model with FIFO property (herein called FM-CTM) is extended from its prior multiclass cell transmission model (M-CTM). Also, to enhance its analytical compactness and resultant computational convenience, FM-CTM is formulated in this paper as a set of closed-form matrix equations. The objective is to improve the accuracy of traffic state estimation by enforcing FIFO property when a fast vehicle cannot overtake a slow vehicle due to a limitation of a single-lane road. Moreover, the proposed model takes into account a different priority for vehicles of each class to move forward through congested road conditions, and that makes the flow calculation independent from their free-flow speeds. Some hypothetical and real-world freeway networks with a constant or varying number of lanes are selected to verify FM-CTM by comparing with M-CTM and the conventional CTM. Observed densities of VISSIM and real-world dataset of I-80 are selected to compare with the simulated densities from the three CTMs. The numerical results show that FM-CTM outperforms the other two models by 15% of accuracy measures in most cases. Therefore, the proposed model is expected to be well applicable to the road network with a mixed traffic and varying number of lanes.     

Towards a model of hydrodynamic damping for a circular cylinder with helical strakes at low KC

This paper investigates the hydrodynamic damping of a circular cylinder with helical strakes at Keulegan-Carpenter (KC) number from 0.07 to 3 in the presence of steady currents. Experiments were performed with a straked cylinder oscillating in either in-line or cross currents over Reynolds number (based on the oscillating velocity amplitude) varying from 1260 to 54,000. With in-line current being present, the measured drag coefficients of the straked cylinder are found to depend on the ratio between the oscillating velocity amplitude and the steady current velocity. This phenomenon is further confirmed by computational fluid dynamics using large-eddy simulations. The drag coefficients obtained from the numerical simulations agree well with the experimentally determined values. Similar phenomenon is observed for the cases with cross background current. Based on the experimental data, empirical formulae are proposed to evaluate drag coefficients. These results are of importance in estimating the resonant motion and the fatigue life of risers, e.g. water intake risers, in the flow regime of low KC. Finally, recommendations are provided for fatigue analysis of risers with helical strakes from the perspective of engineering practice.