疏浚饱和密实粉土剪胀特性及其对耙齿切削阻力的影响

针对黄骅港区饱和密实粉土,通过三轴剪切试验以及原型耙齿切削试验,研究饱和密实粉土剪胀特性及其对耙齿切削阻力的影响。三轴试验结果表明,黄骅地区饱和密实粉土在剪切过程中表现为应变软化性状,偏应力峰值与围压之间基本呈线性关系。在剪切过程中,土体先剪缩后剪胀,随着围压的增大,剪缩性状体现得越来越明显,应力应变性状可划分为4个不同阶段。原型耙齿切削试验结果表明,饱和土较非饱和土切削阻力增长得更快;饱和土切削阻力最大值为非饱和土切削阻力最大值的2.7~3.3倍;对于饱和土,切削阻力达到稳定值后,其波动幅度较非饱和土要大。上述试验结果均表明,土的剪胀性对于耙齿切削阻力的影响十分显著,须采取相应的措施来降低土的剪胀性对于耙齿切削阻力的影响。     

饱和地基下桩柱结构地震响应

通过建立两相饱和地基下桩-土耦合系统的动力分析有限元数值模型,对饱和自由场地基以及桩柱结构在地震作用下的动力响应进行数值模拟研究。结果表明:在地震作用下超孔隙水压沿深度方向呈现出指数衰减趋势,在地表处更易导致地基液化从而散失承载能力。随着超孔隙水压的上升土体强度降低后,饱和地基土层对地震波的高频成分有明显的选择性滤波作用。在桩柱结构地震响应分析中,受桩土间动力耦合作用的影响,桩侧土体比远场地基土更易液化。随着地基承载力的降低,导致桩柱动力以及弯矩响应上升。研究结果与已有桩基础震害经验相符,其方法和结论可对饱和可液化地基抗震工程提供参考。     

多体浮式防波堤消波特性数值模拟

多体浮式防波堤消波特性是决定其应用价值的重要因素,基于三维势流理论,通过使用Ansys Workbench软件和AQWA Graphical Supervisor(AGS)图像后处理软件,对多体浮式防波堤在不同入射角和浮筒吃水深度下的消波效果展开研究。结果表明,在入射角度为90°时,多浮筒浮式防波堤能够最大程度地消减波浪。同时,透射系数随吃水深度的增加而不断减小,但结构稳定性会下降。因此,实际工程中应尽量保证浮式防波堤的迎浪面与波浪的来波方向垂直,这样可以获得较好的消波效果,同时应尽量避免选择吃水深度过大的浮式防波堤。     

妈祖经贸园外围海堤施工监测与安全性分析

新建海堤工程区域内存在淤泥质土,含水量高,承载力低。为保证施工过程中地基和结构的安全稳定,设置表层沉降、深层水平位移、分层沉降、孔隙水压力等观测项目对围堤施工进行监测,合理控制施工进度,防止地基出现剪切破坏。结果表明：施工前期沉降大,监控参数指标处于可控范围内;后期沉降速率变缓,地基固结度提高,堤体压缩变形趋于稳定,施工期间围堤是稳定安全的。     

水上抛石施工工艺在潮间带区域的应用

以通州湾腰沙围垦一期通道工程B标抛石组织实施为例,通过开展规划临时航线、设置临时倒驳点、制定倒驳与抛设方案等一系列探索和研究,形成了针对浅海潮间带区域安全有效地组织水上抛石施工的专项技术方案,并描述了施工中应关注和优化的事项。     

Mechanism of Tunnel Water Inflow Caused by Bending Failure of a Waterproof Dike Based on a Circular Thin Plate Mechanical Model北大核心CSCD

Water bursts during tunnel construction endanger construction, and it is therefore necessary to reserve a waterproof dike with the required thickness to avoid water bursts and to take reinforcement of the dike and treatment of the structure liable to trigger a water burst. Using the water burst at K5+398 of the Mingyueshan tunnel of the Shanghai-Chengdu expressway as an example, and considering the type of tunnel section and the upright mudstone of the dike, the waterproof dike at the work face is simplified as a round thin plate. A formula for the calculation of a minimum safety thickness for the critical waterproof dike is deduced by analyzing the force applied on the water-proof dike, and the minimum safety thickness for the water burst section at K5+398 of the Mingyueshan tunnel is cal-culated. The numerical simulation analysis demonstrates the critical thickness of waterproof dike at K5+398 of the Mingyueshan tunnel is 1.4-1.55 m, and the calculated water inflow and water burst basically agree with the actual condition. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Model Test on Grouting Law in Dynamic Water-Rich Sand Layers by the Electric Resistance Method北大核心CSCD

In order to study the diffusion law of grouting slurry in the water-rich sand layer under flowing water conditions, a grouting test model consisting of a main test system, a grouting system, and a measurement system was developed. And for detecting the diffusion scope of the grouts, a new resistivity method was proposed. It is found that the relationship between grouting pressure and grouting rate during the test is strong. Under hydrodynamic conditions, the grouting slurry diffuses elliptically. Due to gravity and the effect of the upper water flow, the center of gravity of the ellipsoid is below the grouting outlet, and the grouting effectively improves the physical and mechanical properties of water-rich sand bodies. At the same time, the resistivity method has a good application effect on the detection of grouting diffusion range. The range of slurry diffusion obtained by the resistivity method is basically consistent with the boundary of the stone body after excavation, indicating that the resistivity method is reliable for detection of grouting range in dynamic water-rich sand layer. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

Effect of Explosion in a Gas Pipeline Compartment of a Utility Tunnel on Neighboring Metro Tunnels北大核心CSCD

In this paper the numerical simulation analysis of the effect of explosion in the gas pipeline compartment of a utility tunnel on neighboring metro tunnels was conducted using the software AUTODYN. The results show that the TNT equivalent in a fireproof partition with length of 200 m is 41.6 kg when the gas concentration in the gas pipeline compartment reaches 10%; the blast wave has much effect on the crown and arch waist of the round metro tunnel and it’s necessary to take some protective measures in both areas; when the surrounding soil is sand, the utili- ty tunnel is above the round metro tunnel and their alignments are in the same direction, the greater the vertical spacing between the utility tunnel and the metro tunnel, the smaller the effect of the blast wave on the metro tunnel; when the vertical spacing is 7.2 m, the maximum dynamic tensile stress is 1.86 MPa (including the static stress value of 1 MPa in the tunnel segment) and it is slightly smaller than the designed tensile strength of metro tunnel (about 1.89 MPa). The maximum vibration velocity and the maximum displacement meet the structural stability require- ments, so it is suggested the vertical spacing between the utility tunnel and metro tunnel shall not be less than 7.2 m. © 2018, Editorial Office of "Modern Tunnelling Technology". All right reserved.     

整体推进式桩基码头结构设计与施工

针对在拉美和非洲地区部分码头建设中,存在大型船机设备缺乏和长周期波较为明显、常规打桩船作业和预制构件安装困难的问题,基于一般桩基码头结构,在设计和施工两个方面进行优化,采用桩顶施工行走平台方法施工,利用桩基自身作为支撑结构,大量采用叠合式上部结构,实现将海上施工转化为陆上施工的创新,形成整体推进式桩基码头结构,规避大型船机设备缺乏和长周期波较为明显的问题,具有良好的经济性和对强震区的适应性。     

蜀山泵站枢纽船闸输水系统水力学模型试验

蜀山泵站枢纽船闸对引江济淮工程航运至关重要,是连通长江与淮河,确保引江济淮航运干线畅通的控制性工程,其闸室规模大、工作水头高、输水能量高,输水过程水力学问题是船闸设计的关键环节。结合工程地质和结构设计,船闸拟采用形式最为简单的闸墙长廊道侧支孔输水系统,输水过程船舶与船闸自身安全能否满足相关要求需要开展细致研究。通过比尺为1∶25的物理模型试验,对其输水过程船舶停泊条件、水力特性及引航道水流条件开展研究。结果表明:在推荐的输水系统布置和阀门开启方式下,各项水力指标均能满足规范和设计要求。