排序方式: 共有40条查询结果,搜索用时 0 毫秒
1.
J. H. Yoon B. J. Choi I. H. Yang J. E. Oh 《International Journal of Automotive Technology》2011,12(1):59-66
T-Hypoid gears are commonly used in rear-drive and 4WD (4 Wheel Drive) vehicle axles. Investigating their sensitivity to deflections
is one of the most important aspects of their design and optimization procedures. Therefore, a deflection test was performed
in this study in the actual gear mounting using completely processed gear. This test covered the full operating range of gear
loads from “no load” to “peak load”. Under peak load, the contact pattern extended to the tooth boundaries without showing
a concentration of the contact pattern at any point on the tooth surface. The transmission error was tested under an axle
assembly triaxial-real-car-load condition. 相似文献
2.
T. Y. Shin S. Y. Kim J. Y. Choi K. S. Yoon M. H. Lee 《International Journal of Automotive Technology》2011,12(1):103-110
This paper presents a modified lateral control method for an autonomous vehicle with both look-ahead and look-down sensing
systems. To cope with sensor noise and modeling uncertainty in the lateral control of the vehicle, a modified LMI-based H
lateral controller was proposed, which uses the look-ahead information of the lateral offset error measured at the front of
vehicle and the look-down information of the vehicle yaw angle error between the reference lane and the centerline of the
vehicle. To verify the safety and the performance of the lateral control, a scaled-down vehicle was developed, and the positioning
of the vehicle was estimated with USAT. The proposed controller, which uses both look-ahead and look-down information, was
tested for lane changing and reference lane tracking with both simulation and experiment. The simulation and experimental
results show that the proposed controller has better tracking and handling performance compared with a controller that uses
only the look-ahead information of the target heading angle error. 相似文献
3.
S. J. Kim C. Song K. -S. Kim Y. -S. Yoon 《International Journal of Automotive Technology》2014,15(1):125-134
Conventional geared transmissions use some kinds of clutches to control the power flow from an internal combustion engine to the driveline while shifting gears. However, the shifting performance is seriously affected by the clutch engagement and an unavoidable drop in the torque may occur when the clutch is disconnected. Moreover, wear of the clutch, the need for hydraulic equipment, and the load limit may together aggravate the limits of the clutch system. For this reason, as a novel transmission without a clutch, the clutchless geared smart transmission (henceforth CGST) is proposed by our research team. The CGST controls the power flow in a multiple-input gear-train by controlling the electric motor attached to the planetary gear system. However, no CGST has been realized in an actual vehicle thus far, and the performance has been predicted only theoretically. In this research, we analyzed the achievable performance based on a developed CGST dynamic model with a typical CGST structure. In addition, a CGST gear-shifting algorithm is proposed for use with the dynamic model. From the simulation results, the CGST does not show an abrupt drop in its torque or oscillation while shifting gears due to the absence of a discontinuous power flow. The developed dynamic model can serve as a performance reference for the CGST. Moreover, it can be used as a simulation tool for developing a gear-shifting control logic scheme. 相似文献
4.
B. J. Yoon J. Y. Lee J. H. Kim C. S. Han 《International Journal of Automotive Technology》2011,12(1):111-118
A navigation algorithm is indispensable for Unmanned Ground Vehicles (UGVs). During driving, UGVs follow a global path. In
this study, we propose a navigation algorithm using Real Time Kinematic (RTK)-Differential Global Positioning System (DGPS)
units and encoders to complement global path planning. Sometimes GPS systems lose their signals and receive inaccurate position
data due to many factors, such as edifice and barrier obstructions. This paper shows that GPS deviations can be solved using
a Dead Reckoning (DR) navigation method with encoders and that position errors can be decreased through the use of RTK-DGPS
units. In addition to this method, we will introduce a new waypoint update algorithm and a steering algorithm using RTK-DGPS
units. 相似文献
5.
Prediction of fatigue life and estimation of its reliability on the parts of an air suspension system 总被引:1,自引:0,他引:1
K. J. Jun T. W. Park S. H. Lee S. P. Jung J. W. Yoon 《International Journal of Automotive Technology》2008,9(6):741-747
Air suspension systems have been implemented in various commercial vehicles, such as buses and special purpose trucks, because
of the comfortable ride and easy height control. An evaluation of the durability of vehicle parts has been required for service
life and safety starting in the early stages of design. The cyclic load applied to the vehicle can cause fatigue failure of
parts, such as the suspension frame. This paper presents a method to predict the fatigue life of the suspension frame at the
design stage of the air suspension system used in a heavy-duty vehicle. To estimate the fatigue life using the SN method,
the Dynamic Stress Time History (DSTH) is necessary for the part of interest. DSTH can be obtained from the results of the
flexible body dynamic analysis using the Belgian road simulation and the Modal Stress Recovery (MSR) method. Furthermore,
the reliability of the predicted fatigue life can be evaluated by considering the variations in material properties. The probability
and distribution of the expected life cycle can be obtained using experimental design with a minimum number of simulations.
The advantage of using statistical methods to evaluate the life cycle is the ability to predict replacement time and the probability
of failure of mass-produced parts. This paper proposes a rapid and simple method that can be effectively applied to the design
of vehicle parts. 相似文献
6.
Walking has been highlighted as an independent transportation mode as well as an access/egress mode to/from public transit to encourage the use of more sustainable transport systems. However, walking does not seem to have priority over other transportation modes, especially in areas where various modes of movement are in conflict. The pedestrian push-button system seems to be a solution to distribute the right of way. The focus of this study is on the performance issue of the pedestrian push-button. Specifically, this study deals with issues related to mid-block crossings and attempts to answer two questions: whose waiting time is longer at pre-timed and push-button crossings, pedestrians, or vehicles? and which system – pre-timed or push-button – is better in terms of total waiting time? According to our simulation analyses, if the pedestrian flow rate is less than 120, 85, and 70 ped/h for two-, three-, and four-lane roads, respectively, the push-button system is recommended. 相似文献
7.
Fault detection method for electric parking brake (EPB) systems with sensorless estimation using current ripples 总被引:1,自引:0,他引:1
C. W. Lee H. B. Chung Y. O. Lee C. C. Chung Y. S. Son P. Yoon 《International Journal of Automotive Technology》2010,11(3):387-394
A fault detection method with parity equations is proposed in this paper. Due to its low cost implementation, the velocity
of the motor is not measurable in electric parking brake (EPB) systems. Therefore, residuals are not reliable when estimating
the motor velocity with a low-resolution encoder. In this paper, we propose a fault detection method with sensorless estimation
using current ripples that estimates the position and velocity of the motor by detecting periodical oscillations of the armature
current caused by rotor slots. In addition, this method can estimate the position and velocity of the motor with less computational
effort than a state observer. Moreover, the method is less sensitive to motor parameters than model-based estimation methods.
The effectiveness of this method is validated with experimental data, and the simulation results show that various faults
have their own residual patterns. Therefore, we can detect the presence of faults by monitoring the residual signals. 相似文献
8.
Most hybrid vehicles employ the continuously variable transmission (CVT or eCVT) currently as their choice of the transmissions. Recently, an automated geared transmission (AGT) or dual clutch transmission (DCT) is being tried for some hybrid vehicles for the better fuel economy than the CVT hybrid. However, this AGT or DCT is using automated clutches which require the hydraulic power in addition to the slippage in the clutch plate invoking some energy loss as well as wear. Also, they require a motor with significant power to match to the engine power. The clutchless geared smart transmission (CGST) has no clutch and the clutch function is performed by a planetary gear system controlled by a motor-generator. The hybrid vehicles proposed here using CGST may have some merits in durability, fuel efficiency, and cost since they do not have clutches. The motor used for the clutch function can be also working for power merge with the engine in propelling the vehicle. The proposed hybrid system can be either mild hybrid or full hybrid by adopting a different capacity of battery with much smaller motor-generator due to the planetary gear system compared to the other type hybrid vehicles. In this study, the prospects of newly proposed CGST hybrid system are examined in practical aspects compared with AGT hybrid or DCT hybrid systems. 相似文献
9.
Jee In Yoon Gerard T. Kyle Carena J. van Riper Stephen G. Sutton 《Coastal management》2013,41(6):457-469
This study explores the relationship between Australian's attitudes toward climate change impacts on the Great Barrier Reef (GBR) and environmentally responsible behavior (ERB). We hypothesize that general attitudes toward climate change, subjective norms, and perceived behavioral control predict intended and reported behavior, and that attitude negatively influences constraints on adopting ERB. The moderating effect of residential condition (urban vs. rural contexts) was tested across these hypothesized relationships. We randomly selected 200 individuals from eight regions: Five within 50 km of the GBR Coastline and three from the Statistical Metropolitan Areas in Australia. We yielded 1,623 surveys by telephone interviews. Findings confirm our hypotheses and suggest the most important predictor of intentions is perceived behavioral control. The two groups of respondents (urban vs. rural) illustrate different relationships. This study offers insight on how managers of the GBR can effectively shape residents' behavioral tendencies that minimize human impacts on the natural environment. 相似文献
10.
Urea-SCR system optimization with various combinations of mixer types and decomposition pipe lengths
Y. S. Cho S. W. Lee W. C. Choi Y. B. Yoon 《International Journal of Automotive Technology》2014,15(5):723-731
The demand for NOx after-treatment system has increased dramatically due to the stricter NOx emission regulations for diesel vehicles. The urea-SCR system is one of the NOx after-treatment methods found to be quite effective to meet the regulation requirement enforced by various authorities including the Euro-6. In order to develop an effective urea-SCR system, it is critical to establish an even distribution of reductant over the catalyst surface since this favorable distribution can increase reduction reaction and in turn, improve NOx conversion efficiencies. In the current study, a number of design variations of the urea-SCR system which included two mixer types and three decomposition pipe lengths, were evaluated systematically using CFD analysis and experimental measurements. The purpose of the CFD analysis was to estimate the distribution of reductant within the urea-SCR system with a specific configuration and the purpose of the engine emission test was to measure the amount of NOx reduction, respectively. The results from the systematic analysis revealed the relation between the reductant distribution over the SCR and the performance of the NOx reduction. 相似文献