Development and prospects of initial alignment method for strap-down inertial navigation system北大核心CSCD

Initial alignment technology is directly related to the navigation accuracy and startup time of the strap-down inertial navigation system (SINS), and has always been regarded as a challenging focal point in the research field of inertial navigation. This paper makes a comprehensive survey of SINS initial alignment technology, briefly introduces the basic principles of initial alignment without latitude, coarse alignment with known latitude and precise alignment, and points out their advantages, disadvantages and applicable conditions. The research and effects of existing initial alignment error suppression techniques are then analyzed and discussed. Finally, according to the problems of existing initial alignment methods and the development requirements of the carrier, the future research direction of SINS initial alignment technology is predicted. © 2022 Journal of Clinical Hepatology. All rights reserved.     

Influence of initial heeling angle on ship roll motion response北大核心CSCD

[目的]系统地研究初始横倾角对随机横浪下船舶横摇运动响应的影响。[方法]以路径积分法为基础,通过数值求解控制横摇运动微分方程概率属性的Fokker-Planck方程,得到横摇运动响应的概率分布。[结果]结果显示,初始横倾角对船舶横摇运动响应谱的影响有限,但对横摇角概率分布以及横摇运动响应极值分布的影响十分明显,且会造成船舶安全性的显著恶化。[结论]路径积分法可作为研究随机海浪下船舶横摇运动特性的有效数值方法。     

基于核磁共振与无侧限抗压试验对纤维加固红黏土的宏微观特性研究

红黏土因其具有孔隙比大、易压缩等不良工程特性,常在工程建设中引起一列工程问题.为此,采用聚丙烯纤维对红黏土进行加固,并采用核磁共振(NMR)技术和无侧限抗压强度试验对不同含量纤维加固后土体的宏微观特性进行测试,得到以下结论:1)不同含量纤维加固后红黏土的T2谱形态基本保持一致,均在弛豫时间为1 ms附近出现峰值,且纤维含量为0.2％时,试样内部信号最强;不同含量纤维加筋土内部的孔径主要分布在0.01μm到0.05μm之间,且0.02μm孔径所占比例最大;试样的孔隙度和T2谱峰值面积随纤维含量的增加表现出先增加后减小的趋势,且均在纤维含量为0.2％时到达最大值;2)纤维能够明显增加红黏土的抗压强度,加筋土的抗压强度与纤维含量保持良好的线性增加关系;且随着纤维含量的增加,试样由脆性破坏逐渐表现为韧性破坏特征.3)纤维在土体中起到加筋作用,显著增加了土体间的连接力,且纤维相互交叉连接形成了空间网状结构,限制了土体的变形,使得加筋土抗压强度增加并表现出韧性破坏特征.     

Costs of air pollutants from shipping: a meta-regression analysis

ABSTRACT

This study estimated the external cost of air pollution from shipping by means of a meta-regression analysis, which has not been made before. Three pollutants, which were included in most of the primary studies, were considered: nitrogen oxides (NO_x), sulphur dioxides (SO₂) and particulate matters with a diameter of max 2.5 micrometres (PM_2.5). All primary studies included damages of health and a majority added impacts on agriculture and estimated the cost of air pollutants by transferring cost estimates from studies on costs of air emissions from transports in Europe. Different regression models and estimators were used and robust results were found of statistically significant emission elasticities of below one, i.e. total external costs increase by less than 1% when emissions increase by 1%. There was a small variation between the pollutants, with the highest elasticity for PM_2.5 and lowest for NO_x. Calculations of the marginal external cost of the pollutants showed the same pattern, with this cost being approximately six times higher for PM_2.5 than for the other pollutants. Common to all pollutants was that the marginal external cost decreases when emission increases. Another robust result was a significant increase in the cost of studies published in journals compared with other publication outlets. These findings point out some caution when transferring constant external unit cost of air pollutant from shipping, which is much applied in the literature, and the cost functions estimated in this study could thus provide a complementary transfer mechanism.     

基于减价拍卖的高速铁路票价研究

为了实现高铁运营单位与旅客之间的利益均衡性,让旅客积极参与到高铁票价的制定过程中,使高铁票价更具合理性和普遍性.通过分析不同运输方式的时效性和模型的适用性,以时效票价率为依据,建立拍卖过程中的叫价策略和应价策略.并给出虚拟条件下的拍卖流程,实例验证得到能反映客运市场供需关系的动态定价策略.研究结果表明:成交价格、收益率、上座率及成交期望趋于稳定时,应价方对拍卖方的降价幅度具有较高的接受度,成交价格随着收益率偏好系数的增大而增大,而随着上座率偏好系数的增大而减小,这说明合理的成交价格应当是收益率和上座率综合的结果;相较于目前研究,该模型让旅客参与定价,更加符合现实场景中的动态定价,为高铁运营单位定价提供了相应的决策支持.     

沈大高速公路路面平整度的控制

结合沈大高速公路改扩建工程简述了SMA路面平整度的影响因素和控制方法。     

Transit assignment under crowded conditions

This paper presents a transit assignment algorithm for crowded networks. Both congestion in vehicles and queuing at stations are explicitly taken into account in predicting passenger flows for a fixed pattern of origin-destination trip demands. The overflow effects due to insufficient capacity of transit lines are considered to be concentrated at transit stations, while the in-vehicle congestion effects (or discomforts) are considered to be dependent on in-vehicle passenger volume. Overflow delay at a transit station is dependent on the number of excess passengers required to wait for the next transit car. We use a logit model to determine the split between passengers that chose to wait for the next transit car and passengers that chose to board on the alternative transit lines. The proposed algorithm predicts how passenger will choose their optimal routes under both queuing and crowded conditions.     

Active Roll Control for Passenger Cars

The development of a mathematical model of a limited bandwidth hydro-pneumatic suspension that is incorporated into a vehicle handling model is described. The combined model is used to evaluate a suitable control strategy for eliminating body roll during a cornering manoeuvre. The philosophy behind the roll control strategy has been to use feedback measurements of the body motions which do not compromise the ride control. A study of the influence of the position of the body motion feedback transducer on the effectiveness of the system to reduce the body roll is presented. Non-linear modelling of the suspension components for a 0.8g cornering manoeuvre has revealed performance limitations. Conclusions are drawn as to the effectiveness of the control scheme.     

A study of passenger discomfort measures at the Hong Kong mass transit railway system

This note investigates the important attributes relating to the crowding effects at the Mass Transit Railway (MTR) stations in Hong Kong. Data was collected at two sets of three MTR stations to study the responses of the passengers due to the discomfort at crowded vehicles and platforms. Stated preference surveys were used to study the effects of passenger discomfort measures.     

The role of professional associations in shipping

This article is in three parts. The first covers the historical development of qualifying associations. The second covers the particular role of maritime institutions that include The Royal Institution of Naval Architects, The Institute of Marine Engineering Science and Technology and The Nautical Institute. The third and final section considers the future for maritime professional associations in the context of international shipping.