Remote sensing technique was applied to estimate suspended sediment concentration (SSC) and to understand transportation, distribution and deposition of suspended sediment in the estuary and throughout the coastal sea, off the Ganges–Brahmaputra River mouth. During low river discharge period, zone of turbidity maximum is inferred in the estuary near the shore. SSC map shows that maximum SSC reaches 1050 mg/l in this period. Magnitude of SSC is mainly owing to resuspension of the bottom surface sediments induced by tidal currents flowing over shallow water depths. The influence of depth on resuspension is farther revealed from the distribution and magnitude of SSC along the head of Swatch of No Ground (SNG) submarine canyon. During high river discharge period, huge river outflow pushed the salt wedge and flashes away the suspended sediments in the coastal sea off the river mouth. Zone of turbidity maximum is inferred in the coastal water approximately within 5–10 m depth of water, where the maximum SSC reaches 1700 mg/l. In this period, huge fluvial input of the suspended sediments including the resuspended bottom sediments and the particles remaining in suspension for longer period of time since their initial entry control mainly the magnitude of SSC. In the estuary near the shore, seasonal variation in the magnitude of SSC is not evident. In the coastal sea (>5 m water depth), seasonal influence in the magnitude of SSC could be concluded from the discrepancy between SSC values of two different seasons. Transportation and deposition of suspended sediments also experiences seasonal variations. At present, suspended sediments are being accumulated on the shallow shelf (between 5 and 10 m water depth) in low discharge period and on the mid-shelf (between 10 and 75 m water depth) during high discharge period. An empirical (exponential) relationship was found between gradual settle down of suspended sediments in the coastal sea and its lateral distance from the turbidity maximum. 相似文献
This study investigates the roll decay of a fishing vessel by experiments and computational fluid dynamics(CFD)simulations. A fishing vessel roll decay is tested experimentally for different initial roll angles. The roll decay is also simulated numerically by CFD simulations and is validated against the experimental results. It shows that the roll damping could be obtained by CFD with high level of accuracy. The linear and nonlinear damping terms are extracted from the CFD roll decay results and... 相似文献
This study develops a new comprehensive pattern recognition modeling framework that leverages activity data to derive clusters of homogeneous daily activity patterns, for use in activity-based travel demand modeling. The pattern recognition model is applied to time use data from the large Halifax STAR household travel diary survey. Several machine learning techniques not previously employed in travel behavior analysis are used within the pattern recognition modeling framework. Pattern complexity of activity sequences in the dataset was recognized using the FCM algorithm, and resulted in identification of twelve unique clusters of homogeneous daily activity patterns. We then analysed inter-dependencies in each identified cluster and characterized the cluster memberships through their socio-demographic attributes using the CART classifier. Based on the socio-demographic characteristics of individuals we were able to correctly identify which cluster individuals belonged to, and also predict various information related to their activities, such as start time, duration, travel distance, and travel mode, for use in activity-based travel demand modeling. To execute the pattern recognition model, the 24-h activity patterns are split into 288 three dimensional 5 min intervals. Each interval includes information on activity types, duration, start time, location, and travel mode if applicable. Results from aggregated statistical evaluation and Kolmogorov–Smirnov tests indicate that there is heterogeneous diversity among identified clusters in terms of temporal distribution, and substantial differences in a variety of socio-demographic variables. The homogeneous clusters identified in this study may be used to more accurately predict the scheduling behavior of specific population groups in activity-based modeling, and hence to improve prediction of the times and locations of their travel demands. Finally, the results of this study are expected to be implemented within the activity-based travel demand model, Scheduler for Activities, Locations, and Travel (SALT).
In this paper, towing tank experiments are conducted to study the behavior of flow on a model of the underwater vehicle with various shapes of bows, i.e. tango and standard bows in free surface motion ... 相似文献
This paper examines the activity engagement, sequencing and timing of activities for student, faculty and staff commuter groups at the largest university in the Maritime Provinces of Canada. The daily activity patterns of all university community groups are modeled using the classification and regression tree classifier algorithm. The data used for this study are derived from the Environmentally Aware Travel Diary Survey (EnACT) conducted in spring 2016 at Dalhousie University, Nova Scotia. Results show that there are significant differences in activity and travel behavior between university population segments and the general population in the region, and between campus groups. For example, students participate in more recreation activities compared to faculty and staff. They also take more trips to and from campus, and are more flexible in their scheduling of trips. The insights gained from this study will provide helpful information for promoting sustainability across university campuses, and for development of campus-based travel demand management strategies. 相似文献
Response spectra of fixed offshore structures impacted by extreme waves are investigated based on the higher order components of the nonlinear drag force. In this way, steel jacket platforms are simplified as a mass attached to a light cantilever cylinder and their corresponding deformation response spectra are estimated by utilizing a generalized single degree of freedom system. Based on the wave data recorded in the Persian Gulf region, extreme wave loading conditions corresponding to different return periods are exerted on the offshore structures. Accordingly, the effect of the higher order components of the drag force is considered and compared to the linearized state for different sea surface levels. When the fundamental period of the offshore structure is about one third of the main period of wave loading, the results indicate the linearized drag term is not capable of achieving a reliable deformation response spectrum. 相似文献
This article presents a model for solving solid-fluid interactions in vehicles carrying liquids. A tractor-semitrailer model is developed by incorporating suspension systems and tire dynamics. Owing to the solid-fluid interaction, equations of motion for the vehicle system are coupled. To simplify the complicated solution procedure, the coupled equations are solved separately using two different codes. Each code is analyzed separately; but as the parameters of the two codes depend on each other, the codes must be connected at the end of each time step. To determine the dynamic behavior of the system, different braking moments are applied. As the braking moments increase, braking time decreases. However, it turns out that increasing the braking moment to more than a certain level produces no significant results. It is also shown that vehicles carrying fluids need a greater amount of braking moments in comparison to vehicles carrying solids during braking. In addition, as the level of the fluid inside the tanker increases, from one-third to two-third of the tanker's volume, the sloshing forces applied to the tanker's walls increase. It was also concluded that the strategy used in this article to solve for the solid-fluid interaction by incorporating vehicle dynamic effects represents an effective method for determining the dynamic behavior of vehicles carrying fluids in other critical maneuvers. 相似文献
This paper presents the results of complementary numerical study done in the continuation of the activities carried out by the Committee III.1 “Ultimate Strength” of ISSC'2003 (Ref. [28] ).The main focus of the paper concerns the post-buckling behaviour and strength characteristics of the aluminium multi-stiffened panels under combined axial compression and lateral pressure.The finite element model proposed by the Committee III.1 “Ultimate Strength” of ISSC'2003 is used in the present investigation. Material is aluminium alloy AA6082-T6 and the multi-stiffened panel is a triple-span structure. Stiffeners are of either extruded or non-extruded angle-bar profiles. An initial deflection is imposed on the model in a procedure similar to that applied by the Committee III.1. General purpose finite element code ANSYS is used for non-linear elastic–plastic analyses.Main objectives are to study the influence of initial deflections and also HAZ on the post-buckling behaviour and collapse characteristics of aluminium stiffened panels under combined axial compression and lateral pressure. Different values of lateral pressure are exerted on the model in a systematic manner to simulate various levels of lateral pressure loading on multi-stiffened aluminium panels used in the construction of high-speed crafts. 相似文献
In this paper, a predictive model is formulated to describe the frictional forces between the tyre and road. The model is based on an inverted-boat normal pressure distribution. The determination of the input parameters is simplified by the suggested stationary point approach for calculation of the frictional coefficients, which are analytically obtained. The verification of the established model shows that the predicted values are in a good agreement with measured data. A sensitivity study of the shape factors demonstrates that it is necessary to take the unsymmetric normal pressure distribution proposed in this paper into consideration to accurately predict frictional forces. 相似文献