Development and prospects of initial alignment method for strap-down inertial navigation system北大核心CSCD

Initial alignment technology is directly related to the navigation accuracy and startup time of the strap-down inertial navigation system (SINS), and has always been regarded as a challenging focal point in the research field of inertial navigation. This paper makes a comprehensive survey of SINS initial alignment technology, briefly introduces the basic principles of initial alignment without latitude, coarse alignment with known latitude and precise alignment, and points out their advantages, disadvantages and applicable conditions. The research and effects of existing initial alignment error suppression techniques are then analyzed and discussed. Finally, according to the problems of existing initial alignment methods and the development requirements of the carrier, the future research direction of SINS initial alignment technology is predicted. © 2022 Journal of Clinical Hepatology. All rights reserved.     

Influence of initial heeling angle on ship roll motion response北大核心CSCD

[目的]系统地研究初始横倾角对随机横浪下船舶横摇运动响应的影响。[方法]以路径积分法为基础,通过数值求解控制横摇运动微分方程概率属性的Fokker-Planck方程,得到横摇运动响应的概率分布。[结果]结果显示,初始横倾角对船舶横摇运动响应谱的影响有限,但对横摇角概率分布以及横摇运动响应极值分布的影响十分明显,且会造成船舶安全性的显著恶化。[结论]路径积分法可作为研究随机海浪下船舶横摇运动特性的有效数值方法。     

基于核磁共振与无侧限抗压试验对纤维加固红黏土的宏微观特性研究

红黏土因其具有孔隙比大、易压缩等不良工程特性,常在工程建设中引起一列工程问题.为此,采用聚丙烯纤维对红黏土进行加固,并采用核磁共振(NMR)技术和无侧限抗压强度试验对不同含量纤维加固后土体的宏微观特性进行测试,得到以下结论:1)不同含量纤维加固后红黏土的T2谱形态基本保持一致,均在弛豫时间为1 ms附近出现峰值,且纤维含量为0.2％时,试样内部信号最强;不同含量纤维加筋土内部的孔径主要分布在0.01μm到0.05μm之间,且0.02μm孔径所占比例最大;试样的孔隙度和T2谱峰值面积随纤维含量的增加表现出先增加后减小的趋势,且均在纤维含量为0.2％时到达最大值;2)纤维能够明显增加红黏土的抗压强度,加筋土的抗压强度与纤维含量保持良好的线性增加关系;且随着纤维含量的增加,试样由脆性破坏逐渐表现为韧性破坏特征.3)纤维在土体中起到加筋作用,显著增加了土体间的连接力,且纤维相互交叉连接形成了空间网状结构,限制了土体的变形,使得加筋土抗压强度增加并表现出韧性破坏特征.     

Do supra-modal traveller types exist? A travel behaviour market segmentation using Goal framing theory

Travel behaviour market segmentations have become a popular method of identifying different types of car users, bicyclists or public transport users. However, while previous studies have looked at different types of users within single modes, such as the car, little research has explored the existence of traveller types transcending modes. The study presented here is an extension of an earlier segmentation study that distinguished travellers based on their individual preferences, yet did so independent of their current mode choice. The data came from a travel survey at a middle-sized UK university and were analysed using a combination of hierarchical and iterative partitioning methods. Crucially, however, the current study uses a different theoretical framework to previous segmentation research—goal framing theory—which may more adequately explain the findings than models used in the past such as the theory of planned behaviour. The findings supported earlier work, suggesting the presence of seemingly stable traveller types that cut across modes and can be distinguished based on gain, hedonic and normative goals. This has important implications for policies aimed at encouraging mode change which may have been too preoccupied with changing people’s attitudes rather than paying attention to people’s underlying travel preferences.

     

Growth of urban transportation: Peoples republic of China

The Peoples Republic of China, with its great urban populations, is finding it necessary to develop a range of strategies to deal with increasing demand for goods and people movement, increasing motorization and the increasing congestion that results from the increasing travel demand. This paper discusses strategies being adopted in two northern cities, Changchun and Shenyang. Both transit and roadway programs are examined for Changchun. Problems and successes of a new toll road are examined for Shenyang. Sustained infrastructure investment is essential to assure the necessary mobility for economic growth.     

A stated preference examination of time of travel choice for a recreational trip: An addendum

A paper was published in the immediately previous issue of this journal describing a stated preference experiment examining how people are influenced in the selection of a departure time for a hypothetical trip to see a movie. The title was ‘A stated preference examination of time of travel choice for a recreational trip’, Volume 30(3):17–44. Numbers were used to indicate references in the text of the paper and in Table 1 accompanying the text, but these numbers were omitted from the list of references at the end of the paper - making it very difficult to identify specific citations. The list of references from the paper is reprinted below with the reference numbers included. This provides a listing that can be used in conjunction with the text of the paper and Table 1 as published to identify specific citations as intended.     

Active Roll Control for Passenger Cars

The development of a mathematical model of a limited bandwidth hydro-pneumatic suspension that is incorporated into a vehicle handling model is described. The combined model is used to evaluate a suitable control strategy for eliminating body roll during a cornering manoeuvre. The philosophy behind the roll control strategy has been to use feedback measurements of the body motions which do not compromise the ride control. A study of the influence of the position of the body motion feedback transducer on the effectiveness of the system to reduce the body roll is presented. Non-linear modelling of the suspension components for a 0.8g cornering manoeuvre has revealed performance limitations. Conclusions are drawn as to the effectiveness of the control scheme.     

Basic Analytical Study of Pantograph-catenary System Dynamics

For a high speed electrical rail system, good dynamic performance of the pantograph-catenary system is vital for smooth and continuous current collection. It has been known for many years that to achieve this the head of the pantograph should be made as light as possible and the average stiffness of the catenary should be high. These conclusions, however, have been reached by numerical modelling and operational experience. In this paper the pantograph-catenary system is modelled as a time-varying, single degree-of-freedom system to facilitate an analytical investigation of the system dynamics. Although the model is very simple, it allows physical insight into the dynamic behaviour of the system, and because the excitation is parametric it also allows the stability of the system to be investigated. The finite element method is used to determine the catenary characteristics and Floquet theory is used to analyse the behaviour of the coupled system.     

The role of professional associations in shipping

This article is in three parts. The first covers the historical development of qualifying associations. The second covers the particular role of maritime institutions that include The Royal Institution of Naval Architects, The Institute of Marine Engineering Science and Technology and The Nautical Institute. The third and final section considers the future for maritime professional associations in the context of international shipping.