Framework for designing sample travel surveys for transport demand modelling in cities

Transportation - Travel surveys in cities remain the main source of information for obtaining people’s trip characteristics and developing transport models that serve to predict the...     

Investigation of carriers’ ability to transfer toll increases: an empirical analysis of freight agents’ relative market power

Transportation - Design of effective freight policies requires a comprehensive understanding of freight agents’ interactions. A critical component of the interaction is the freight...     

Costs of air pollutants from shipping: a meta-regression analysis

ABSTRACT

This study estimated the external cost of air pollution from shipping by means of a meta-regression analysis, which has not been made before. Three pollutants, which were included in most of the primary studies, were considered: nitrogen oxides (NO_x), sulphur dioxides (SO₂) and particulate matters with a diameter of max 2.5 micrometres (PM_2.5). All primary studies included damages of health and a majority added impacts on agriculture and estimated the cost of air pollutants by transferring cost estimates from studies on costs of air emissions from transports in Europe. Different regression models and estimators were used and robust results were found of statistically significant emission elasticities of below one, i.e. total external costs increase by less than 1% when emissions increase by 1%. There was a small variation between the pollutants, with the highest elasticity for PM_2.5 and lowest for NO_x. Calculations of the marginal external cost of the pollutants showed the same pattern, with this cost being approximately six times higher for PM_2.5 than for the other pollutants. Common to all pollutants was that the marginal external cost decreases when emission increases. Another robust result was a significant increase in the cost of studies published in journals compared with other publication outlets. These findings point out some caution when transferring constant external unit cost of air pollutant from shipping, which is much applied in the literature, and the cost functions estimated in this study could thus provide a complementary transfer mechanism.     

The marine electronic highway in the Straits of Malacca and Singapore—an assessment of costs and key benefits

The Straits of Malacca and Singapore are an important trade route linking the Indian Ocean to the South China Sea and Pacific Ocean. They are also rich in resources and support a range of activities that benefit the economies of the littoral states (Indonesia, Malaysia and Singapore). This important shipping route is a very congested waterway and the authorities are keen to improve navigation facilities to promote ship safety and reduce the risk of groundings, collisions and accidents. This will also help to protect the marine environment from the effects of pollution and hence reduce its damaging impact on activities related to the Straits, e.g. fisheries and tourism. The Marine Electronic Highway (MEH) is an attempt to bring together maritime safety technologies and environmental management systems. The paper examines the costs of providing such a highway and considers some of the benefits which could accrue from its implementation. The analysis, conducted in the form of a cost-benefit study, clearly shows the economic viability of the scheme.     

Marketing management at the world's major ports

Recent technological developments in maritime transport, particularly in container shipping and larger vessels, are having major repercussions at ports the world over. The latest wave of innovations has increased the level of competition in maritime transport, in particular in port activities. Shippers have many more alternatives available, something that tends to increase the hinterland of each port, precisely by reducing captive hinterlands. Ports are now generally moving towards formulas in which private initiative has a bigger role to play. Increases in competition combined with growth in private initiatives highlight the usefulness of marketing tools in two ways. Externally, because they help to achieve throughputs from remote points of origin and destination, and internally, by aiding the proper coordination of business and organizational activity at a commercial port. The present paper is a transversal study of the current situation of marketing and quality tools at major ports, including the opinions of a range of port commercial and marketing managers. We have also tried to describe the differentiated groups to be found at ports, as a useful methodology for identifying the nearest competition or ports with similar characteristics.     

Effects of information in road transport networks with recurrent congestion

This paper aims to gain more insight into the implications of information provision to drivers on the performance of road transport networks with recurrent congestion. For this purpose, a simulation program consisting of three components has been written. The first component is the traffic simulation model, the second component is the information provision mechanism, and the third component monitors the behavioural decision-making process of the drivers, which is modelled using a utility-based satisficing principle. Three types of information provision mechanisms will be considered: information based upon own-experience, after-trip information and real-time en route information. The findings in this paper, obtained in a hypothetical context, underline the important relationship betweenoverreaction, thelevel of market penetration and thequality of the information. High quality information allows a high level of market penetration, while low quality information, even when provided at low levels of market penetration, induces overreaction. Furthermore, real-time en route information is in particular beneficial during the process leading to a steady state; it reduces the variance in travel time considerably. The paper concludes with a discussion on the market potential of motorist information systems when commercially marketed.     

Correlation between automotive CO, HC, NO, and PM emission factors from on-road remote sensing: implications for inspection and maintenance programs

Carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxide (NO) emission factors (EFs) are measured with a commercial vehicle emissions remote sensing system (VERSS) during a large-scale vehicle exhaust emissions study in Las Vegas. Particulate matter (PM) EFs are simultaneously measured for individual vehicles with a newly developed PM-VERSS based on ultraviolet backscatter light detection and ranging (Lidar). The effectiveness of CO and HC EFs as proxy for NO and PM EFs for spark-ignition vehicles is evaluated. Poor correlations were found between EFs for pollutants on an individual vehicle basis indicating that high EFs for one or more pollutants cannot be used as a predictor of high EFs for other pollutants. Stronger functional relationships became evident after averaging the EF data in bins based on rank-order of a single pollutant EF. Low overlap between the highest 10% emitters for CO, HC, NO, and PM was found. These results imply that for an effective reduction of the four pollutants, inspection and maintenance (I/M) programs, including clean screening, should measure all four pollutants individually. Fleet average CO and HC concentrations determined by gaseous VERSS were compared with fleet average CO and HC concentrations measured at low-idle and at high-idle during local I/M tests for spark-ignition vehicles. The fleet average CO concentrations measured by I/M tests at either idle were about half of those measured by remote sensing. The fleet average high-idle HC concentration measured by I/M tests was about half of that measured by VERSS while low-idle I/M and VERSS HC average concentrations were in better agreement. For a typical vehicle trip, most of the fuel is burned during non-idle conditions. I/M measurements collected during idling conditions may not be a good indicator of a vehicle’s potential to be a high emitter. VERSS measurements, when the vehicle is under a load, should more effectively identify high emitting vehicles that have a large contribution to the mobile emissions inventory.     

Analyzing fluctuations in car-following

Many car-following models predict a stable car-following behavior with a very small fluctuation around an equilibrium value g¹ of the net headway g with zero speed-difference Δv between the following and the lead vehicle. However, it is well-known and additionally demonstrated by data in this paper, that the fluctuations are much larger than these models predict. Typically, the fluctuation in speed difference is around ±2 m/s, while the fluctuation in the net time headway T = g/v can be as big as one or even two seconds, which is as large as the mean time headway itself. By analyzing data from loop detectors as well as data from vehicle trajectories, evidence is provided that this randomness is not due to driver heterogeneity, but can be attributed to an internal stochasticity of the driver itself. A final model-based analysis supports the hypothesis, that the preferred headway of the driver is the parameter that is not kept constant but fluctuates strongly, thus causing the even macroscopically observable randomness in traffic flow.     

Urban walkability considering pedestrians’ perceptions of the built environment: a 10-year review and a case study in a medium-sized city in Latin America

ABSTRACT

Numerous methodologies measuring walkability have been developed over the last years. This paper reviews the Walkability Index (WI) literature of the last decade (2009–2018) and highlights some limitations in the current approaches. Only a few studies have evaluated walkability in Latin America, mainly in big cities but not in medium and small-sized cities in the region, which present their own urbanisation dynamics, security issues, sidewalk invasion problems, and poor planning. Furthermore, most WIs in the literature use objective mesoscale variables to assess walkability in a given area. This paper contributes to filling these gaps by generating new evidence from a medium-sized city in Latin America to question if characteristics of the built environment encourage walking trips, as found in the literature, are transferable among regions. The study also proposes a novel index comprised of microscale and mesoscale built environment variables to assess walkability using virtual tools and considering users’ perceptions. The WI estimation relies on ranking probability models. The results of the case study suggest that subjective Security and Traffic Safety are the most crucial factors influencing walkability in these kind of cities, which is different from what is found in the literature from cities in developed countries where Sidewalk Condition and Attractiveness are the most important factors. Security appeared to be strongly associated with a subjective dimension, represented by the fear of crime or perceived risk for crime, instead of the actual occurrence of crimes. This result evidences the importance of the physical attributes of the real world and how they are captured, judged, and processed by pedestrians. Then, regional transferability of WIs needs to be done carefully. Finally, results in this paper highlight the importance of microscale built environment characteristics in the WI formulation in these cities. Results are in line with other research in some cities of the region, which found that microscale variables such as pavement quality and presence of obstacles on the sidewalks are relevant components to promote walkability.     

Influence of vehicle driving parameters on the noise caused by passenger cars in urban traffic

In this work, a sample of vehicles has been instrumented to measure of variables that influence vehicle noise emissions in Madrid. A circuit reproducing a normal travel pattern in large city is traveled by a fleet of vehicle models representing the fleets of cars in a European city. A sample of drivers covers the test track under different traffic conditions. Driving parameters and noise emitted have been recorded in each test and average values have been extracted. These data have been analyzed to define the noise emissions produced by a vehicle in real driving conditions and to identify the noisiest driving behaviors.