Shape Optimization of Elliptical Road Containers Due to Liquid Load in Steady-State Turning

A numerical analysis of liquid load in elliptical road containers undergoing a steady-state turning manoeuvre is presented for containers of unrestricted size and for containers of fixed capacity. The liquid load is expressed in terms of the horizontal and vertical forces and the overturning moment created by these forces around the middle bottom point of the container. The moment is obtained by integrating the liquid free-surface equation and using numerical calculation of the resulting expressions. An optimization study with an objective to minimize the peak overturning moment is performed on containers of fixed capacity to identify the optimal height/width ratio of the container. The results of this investigation being of a general nature, i.e. with no restriction for an application, are particularly intended for road tankers under a steady turning manoeuvre, where they can be applied with high degree of accuracy.     

Transit assignment under crowded conditions

This paper presents a transit assignment algorithm for crowded networks. Both congestion in vehicles and queuing at stations are explicitly taken into account in predicting passenger flows for a fixed pattern of origin-destination trip demands. The overflow effects due to insufficient capacity of transit lines are considered to be concentrated at transit stations, while the in-vehicle congestion effects (or discomforts) are considered to be dependent on in-vehicle passenger volume. Overflow delay at a transit station is dependent on the number of excess passengers required to wait for the next transit car. We use a logit model to determine the split between passengers that chose to wait for the next transit car and passengers that chose to board on the alternative transit lines. The proposed algorithm predicts how passenger will choose their optimal routes under both queuing and crowded conditions.     

FRP正弦波形夹心桥面板的等效有限元模型

以FRP正弦波形夹心桥面板作为研究对象,得到等效正交各项异性实心板,通过理论分析和数值对比,证明了方法的可行性;采用该法对一实际的FRP正弦波形夹心板桥进行了模态分析。     

A study of passenger discomfort measures at the Hong Kong mass transit railway system

This note investigates the important attributes relating to the crowding effects at the Mass Transit Railway (MTR) stations in Hong Kong. Data was collected at two sets of three MTR stations to study the responses of the passengers due to the discomfort at crowded vehicles and platforms. Stated preference surveys were used to study the effects of passenger discomfort measures.     

Development of Green-Naghdi models with a wave-absorbing beach for nonlinear, irregular wave propagation

Two-dimensional and three-dimensional Green-Naghdi (GN) models equipped with a numerical wave-absorbing beach have been developed to simulate nonlinear, regular, and irregular wave propagation. The numerical beach is introduced near the downstream boundary to absorb outgoing waves. An appropriate amount of numerical damping and an appropriate length of numerical beach are investigated using numerical experiments. The results show that the GN models with a numerical beach work very well in simulating wave propagation in water in a small computational domain.     

腹地经济发展对港口吞吐量影响的动态研究

腹地经济规模和经济结构的变化影响着港口的发展方向，但是一般的静态回归模型中解释变量参数是固定的，无法反应腹地各种影响因素变化对港口吞吐量产生的动态影响，而变参数状态空间模型克服了这一缺陷，解释变量的参数可以随时间改变，充分体现了解释变量对因变量影响关系的改变，因此能够更加准确反映考察期内腹地各种因素对港口吞吐量的动态影响。在介绍模型的基础上，就东北经济对大连港集装箱吞吐量影响进行了实证研究，得出了较为详尽的结论，这些结论是港口未来发展的重要决策依据。     

Effect of fatigue strain range on properties of high-strength structural steel

Ship hulls are built with stiffened steel plates and experience continuous fatigue load cycles when in service. Mechanical properties of the steel are expected to change due to the application of these cyclic loads. Therefore, the mechanical properties of the material at various levels of fatigue damage need to be understood. This paper presents two test series that were conducted to determine the effect of two different strain ranges (2000 and 3000 micro strains) of fatigue cycles on the mechanical properties of high-strength structural steel. The test results indicate that the cycle-dependent behaviours of the material can cause a slight increase or a significant decrease in the yield strength when compared to its virgin state. However, the ductility of the steel does not change much as the strain cycle increases.     

The design of bus route systems — An interactive location-allocation approach

An interactive modelling approach is developed to solve the practical problem of bus route network design. Possible bus routes are identified with facilities which can be located. Zones or pairs of zones in the urban area are identified with customers who will be allocated to the established facilities. It is shown that the classical Set Covering Problem is useful under the assumption of fixed demand; the Simple Plant Location Problem is effective under the assumption of demand which is sensitive to the level of bus service provided.     

铁路隔震连续梁桥地震碰撞响应研究

在地震作用下隔震桥梁的梁体位移比非隔震桥梁明显增加,使得相邻梁发生碰撞的概率增大。以1联3跨铁路隔震连续梁桥为例,选用3条人工地震波,采用非线性时程分析方法进行该桥的碰撞响应分析,研究梁间伸缩缝宽度和隔震支座刚度对梁间碰撞响应的影响。结果表明:随着伸缩缝宽度的增大和隔震支座刚度的增大,相邻梁碰撞的发生次数和碰撞力均有明显减小;地震作用下隔震固定墩墩底最大弯矩和最大剪力均随着隔震支座刚度的增加而增加。因此,在进行隔震桥梁设计时,应综合考虑隔震支座的隔震效果和碰撞响应,从而得到既经济又安全的隔震桥梁设计参数。