冲绳城市单轨运输系统

简要介绍了冲绳城市单轨运输系统的设施和车辆概况.     

Fluxes of dissolved inorganic carbon in three estuarine systems of the Cantabrian Sea (north of Spain)

The diffusive and in situ fluxes of dissolved inorganic carbon (DIC) and total alkalinity (TA) have been measured and an estimation has been made of the water–atmosphere fluxes of CO₂ in three estuarine systems of the Cantabrian Sea during the spring of 1998. Each of these systems undergoes a different anthropogenic influence. The diffusive fluxes of dissolved inorganic carbon and total alkalinity obtained present values ranging between 0.54–2.65 and 0.0–2.4 mmol m⁻² day⁻¹, respectively. These ranges are in agreement with those of other coastal systems. The in situ fluxes are high and extremely variable (35–284 mmol TA m⁻² day⁻¹, 43–554 mmol DIC m⁻² day⁻¹ and 22–261 mmol dissolved oxygen (DO) m⁻² day⁻¹), because the systems studied are very heterogeneous. The values of the ratio of the in situ fluxes of TA and DIC show on average that the rate of dissolution of CaCO₃ is 0.37 times that of organic carbon oxidation. Equally, the interval of variation of the relationship between the benthic fluxes of inorganic carbon and oxygen (F_DIC/F_DO) is very wide (0.3–13.9), which demonstrates the different contributions made by the processes of aerobic and anaerobic degradation of the organic matter, as well as by the dissolution–precipitation of CaCO₃. The water–atmosphere fluxes of CO₂ present a clear dependence on the salinity. The brackish water of these systems (salinity<20), where maximum fluxes of 989 mmol m⁻² day⁻¹ have been estimated, act as a source of CO₂ to the atmosphere. The more saline zones of the estuary (salinity>30) act as a sink of CO₂, with fluxes between −5 and −10 mmol m⁻² day⁻¹.     

Shape Optimization of Elliptical Road Containers Due to Liquid Load in Steady-State Turning

A numerical analysis of liquid load in elliptical road containers undergoing a steady-state turning manoeuvre is presented for containers of unrestricted size and for containers of fixed capacity. The liquid load is expressed in terms of the horizontal and vertical forces and the overturning moment created by these forces around the middle bottom point of the container. The moment is obtained by integrating the liquid free-surface equation and using numerical calculation of the resulting expressions. An optimization study with an objective to minimize the peak overturning moment is performed on containers of fixed capacity to identify the optimal height/width ratio of the container. The results of this investigation being of a general nature, i.e. with no restriction for an application, are particularly intended for road tankers under a steady turning manoeuvre, where they can be applied with high degree of accuracy.     

A practical approach to identifying the market potential for high speed rail: A case study in the Sydney-Canberra corridor

This paper presents the methodology and selective empirical results from a study of the demand for a high speed rail system serving the Sydney-Canberra corridor currently dominated by air travel for business trips and car travel for non-business trips. We outline the steps involved in the study from problem specification, data needs, development of base year trip tables, model specification and estimation to establish switching behaviour in the presence of a new mode and calculation of induced demand for current travellers. A stated choice heteroskedastic extreme value switching model is used to evaluate the choice of fare type for business and non-business travel given the current mode used in the corridor for each sampled traveller conventional train, charter coach, scheduled coach, plane or car. Starting with the current travel profile, patronage can be predicted under alternative fare regimes, taking into account diverted traffic, induced traffic and growth. Treating fare class as endogenous enhances the real choice context facing potential patrons.     

Young drivers and graduated licensing: The Ontario case

Despite improvements in road safety over the past several decades, accident rates remain high for young drivers. One accident countermeasure that is expected to improve the safety record of this group is graduated licensing. The philosophy behind this licensing system is that novice drivers, of whom the majority are young, should be restricted to relatively safe driving environments during the initial learning period. Graduated licensing was implemented in the Province of Ontario, Canada in 1994. The objective of this study is to estimate the potential benefits and costs for young drivers associated with two components of the Ontario graduated licensing package: the late-night driving curfew and the high-speed roadway restrictions. Based on accident and travel data for the year 1988, accident-involvement rates per kilometre driven were calculated for different driver groups for various combinations of time of day and roadway speed limit. These rates were then applied to the expected mobility profiles of young drivers affected by graduated licensing. The results of the study support the late-night curfew and suggest that this component of the licensing package should reduce total accident involvements for the affected group by up to 10 percent and fatal accident involvements by up to 24 percent, while reducing their total driving by only four percent. By contrast, the empirical evidence suggest that the high-speed roadway restrictions are likely to increase accident involvements, and thus it is strongly recommended that this component of Ontario's graduated licensing package be changed.     

Driver steering and muscle activity during a lane-change manoeuvre

The article reports an experimental study of driver steering control behaviour in a lane-change manoeuvre. Eight test subjects were instrumented with electromyography to measure muscle activation and co-contraction. Each subject completed 30 lane-change manoeuvres with one vehicle on a fixed-base driving simulator. For each driver, the steering torque feedback characteristic was changed after every ten manoeuvres; the response of the vehicle to steering angle inputs was not changed. Drivers' control strategies were found to be robust to changes in steering torque feedback. Path-following errors, muscle activity and muscle co-contraction all reduce with the number of lane-changes performed by the driver, suggesting the existence of a learning process. Comparing the test subjects, there was some evidence that high levels of co-contraction were used to allow high-frequency steering inputs to be generated. The results contribute to the understanding of vehicle-driver (and more generally, human-machine) dynamic interaction.     

Basic Analytical Study of Pantograph-catenary System Dynamics

For a high speed electrical rail system, good dynamic performance of the pantograph-catenary system is vital for smooth and continuous current collection. It has been known for many years that to achieve this the head of the pantograph should be made as light as possible and the average stiffness of the catenary should be high. These conclusions, however, have been reached by numerical modelling and operational experience. In this paper the pantograph-catenary system is modelled as a time-varying, single degree-of-freedom system to facilitate an analytical investigation of the system dynamics. Although the model is very simple, it allows physical insight into the dynamic behaviour of the system, and because the excitation is parametric it also allows the stability of the system to be investigated. The finite element method is used to determine the catenary characteristics and Floquet theory is used to analyse the behaviour of the coupled system.     

Dynamic Parameter Estimation of a MacPherson Strut Suspension

The dynamic parameters of a MacPherson strut suspension were estimated from the kinematic responses and measured external forces on the system. First, Lagrange equation was used to develop the equations of motion of the system, and then equations of motion were written as linear with respect to the dynamic parameters being estimated. The generalized coordinate partitioning technique was applied to create a reduced set of equations of motion of the constrained dynamic system. In this method only the measurements of positions and kinematic responses of the independent coordinates, and the external forces applied on the system are required as inputs. The rank deficient linear system was solved by QR decomposition. Good correlation was obtained between the actual parameters and the estimated parameters, by comparison between the simulated system response from the actual parameters and from the estimated parameters.     

Analysis of Driver's Decelerating Strategy in a Car-following Situation

This report describes a decelerating driver-model expressed by driving mode transition in car-following situations. The assumptions for constructing the model are that decelerating strategy of a driver is classified into several simple driving modes and that a driver changs his driving modes based on his perceptible characteristics and experiential rules. Deceleration action is divided into three states; following, standing and braking, which are applied to the model. The model has two paths for driver's decelerating action, one of which is selected by the driver based on the perceptible characteristics and experiential rules. The suitability of the model has been experimentally verified.