Development and prospects of initial alignment method for strap-down inertial navigation system北大核心CSCD

Initial alignment technology is directly related to the navigation accuracy and startup time of the strap-down inertial navigation system (SINS), and has always been regarded as a challenging focal point in the research field of inertial navigation. This paper makes a comprehensive survey of SINS initial alignment technology, briefly introduces the basic principles of initial alignment without latitude, coarse alignment with known latitude and precise alignment, and points out their advantages, disadvantages and applicable conditions. The research and effects of existing initial alignment error suppression techniques are then analyzed and discussed. Finally, according to the problems of existing initial alignment methods and the development requirements of the carrier, the future research direction of SINS initial alignment technology is predicted. © 2022 Journal of Clinical Hepatology. All rights reserved.     

Influence of initial heeling angle on ship roll motion response北大核心CSCD

[目的]系统地研究初始横倾角对随机横浪下船舶横摇运动响应的影响。[方法]以路径积分法为基础,通过数值求解控制横摇运动微分方程概率属性的Fokker-Planck方程,得到横摇运动响应的概率分布。[结果]结果显示,初始横倾角对船舶横摇运动响应谱的影响有限,但对横摇角概率分布以及横摇运动响应极值分布的影响十分明显,且会造成船舶安全性的显著恶化。[结论]路径积分法可作为研究随机海浪下船舶横摇运动特性的有效数值方法。     

基于核磁共振与无侧限抗压试验对纤维加固红黏土的宏微观特性研究

红黏土因其具有孔隙比大、易压缩等不良工程特性,常在工程建设中引起一列工程问题.为此,采用聚丙烯纤维对红黏土进行加固,并采用核磁共振(NMR)技术和无侧限抗压强度试验对不同含量纤维加固后土体的宏微观特性进行测试,得到以下结论:1)不同含量纤维加固后红黏土的T2谱形态基本保持一致,均在弛豫时间为1 ms附近出现峰值,且纤维含量为0.2％时,试样内部信号最强;不同含量纤维加筋土内部的孔径主要分布在0.01μm到0.05μm之间,且0.02μm孔径所占比例最大;试样的孔隙度和T2谱峰值面积随纤维含量的增加表现出先增加后减小的趋势,且均在纤维含量为0.2％时到达最大值;2)纤维能够明显增加红黏土的抗压强度,加筋土的抗压强度与纤维含量保持良好的线性增加关系;且随着纤维含量的增加,试样由脆性破坏逐渐表现为韧性破坏特征.3)纤维在土体中起到加筋作用,显著增加了土体间的连接力,且纤维相互交叉连接形成了空间网状结构,限制了土体的变形,使得加筋土抗压强度增加并表现出韧性破坏特征.     

Shape Optimization of Elliptical Road Containers Due to Liquid Load in Steady-State Turning

A numerical analysis of liquid load in elliptical road containers undergoing a steady-state turning manoeuvre is presented for containers of unrestricted size and for containers of fixed capacity. The liquid load is expressed in terms of the horizontal and vertical forces and the overturning moment created by these forces around the middle bottom point of the container. The moment is obtained by integrating the liquid free-surface equation and using numerical calculation of the resulting expressions. An optimization study with an objective to minimize the peak overturning moment is performed on containers of fixed capacity to identify the optimal height/width ratio of the container. The results of this investigation being of a general nature, i.e. with no restriction for an application, are particularly intended for road tankers under a steady turning manoeuvre, where they can be applied with high degree of accuracy.     

Active Roll Control for Passenger Cars

The development of a mathematical model of a limited bandwidth hydro-pneumatic suspension that is incorporated into a vehicle handling model is described. The combined model is used to evaluate a suitable control strategy for eliminating body roll during a cornering manoeuvre. The philosophy behind the roll control strategy has been to use feedback measurements of the body motions which do not compromise the ride control. A study of the influence of the position of the body motion feedback transducer on the effectiveness of the system to reduce the body roll is presented. Non-linear modelling of the suspension components for a 0.8g cornering manoeuvre has revealed performance limitations. Conclusions are drawn as to the effectiveness of the control scheme.     

Evasive manoeuvres with a steering robot

In the pursuit of an objective rating on vehicle stability performance, it is always desirable to reduce disturbances and inconsistencies during experimental evaluations, especially the ones introduced by human drivers. This paper presents the development of a steering robot designed for closed-loop steering tasks during evasive manoeuvres. It describes the controller structure and discusses experimental results, in addition to simulation/vehicle model verifications and theoretical control analysis.     

FRP正弦波形夹心桥面板的等效有限元模型

以FRP正弦波形夹心桥面板作为研究对象,得到等效正交各项异性实心板,通过理论分析和数值对比,证明了方法的可行性;采用该法对一实际的FRP正弦波形夹心板桥进行了模态分析。     

Development of Green-Naghdi models with a wave-absorbing beach for nonlinear, irregular wave propagation

Two-dimensional and three-dimensional Green-Naghdi (GN) models equipped with a numerical wave-absorbing beach have been developed to simulate nonlinear, regular, and irregular wave propagation. The numerical beach is introduced near the downstream boundary to absorb outgoing waves. An appropriate amount of numerical damping and an appropriate length of numerical beach are investigated using numerical experiments. The results show that the GN models with a numerical beach work very well in simulating wave propagation in water in a small computational domain.     

Estimation of origin‐destination matrices for a multimodal public transit network

This paper presents a procedure for the estimation of origin‐destination (O‐D) matrices for a multimodal public transit network. The system consists of a number of favored public transit modes that are obtained from a modal split process in a traditional four‐step transportation model. The demand of each favored mode is assigned to the multimodal network, which is comprised of a set of connected links of different public transit modes. An entropy maximization procedure is proposed to simultaneously estimate the O‐D demand matrices of all favored modes, which are consistent with target data sets such as the boarding counts and line segment flows that are observed directly in the network. A case study of the Hong Kong multimodal transit network is used to demonstrate the effectiveness of the proposed methodology.     

A traffic flow simulator for short‐term travel time forecasting

This paper presents an off‐line forecasting system for short‐term travel time forecasting. These forecasts are based on the historical traffic count data provided by detectors installed on Annual Traffic Census (ATC) stations in Hong Kong. A traffic flow simulator (TFS) is developed for short‐term travel time forecasting (in terms of offline forecasting), in which the variation of perceived travel time error and the fluctuations of origin‐destination (O‐D) demand are considered explicitly. On the basis of prior O‐D demand and partial updated detector data, the TFS can estimate the link travel times and flows for the whole network together with their variances and covariances. The short‐term travel time forecasting by O‐D pair can also be assessed and the O‐D matrix can be updated simultaneously. The application of the proposed off‐line forecasting system is illustrated by a numerical example in Hong Kong.