福建渡运安全专项整治综述

本文通过对在役码头的资料收集与分析研究,提出来现阶段的在役码头急需改造的必要性,并就如何对在役码头进行检测和评估就行了阐述。     

一种具有鲁棒性的磁链观测器在异步电机直接转矩控制中的应用

对磁链的准确估计在异步电机直接转矩控制中具有至关重要的作用．针对参数不确定电机模型．利用Lyapunov函数方法，给出了一种基于线性矩阵不等式（LMI）的具有鲁棒性的磁链观测器设计方法．得到了磁链观测器辨识的收敛性条件：相对于基于参数辩识磁链估计方法，其计算量很小．容易满足实时性控制的要求、仿真结果表明．磁链受定转子电月且不确定性变化影响较小．具有较强的鲁捧性．     

基于非线性观测器的IPMSM无位置传感器控制

为了解决内嵌式永磁同步电机(IPMSM)无位置传感器控制中转子角度和速度估计问题,根据IPMSM的状态方程和非线性理论,设计了一种非线性状态观测器,并基于Lyapunov稳定性原理讨论了观测器稳定条件.同时考虑负载影响,加入了负载转矩的观测由于模型参数问题和采样精度问题,状态变量的观测值和实际值存在一定误差,因此对角度和速度观测值分别进行了修正.仿真和试验研究表明,改进后的非线性观测器能够准确估计转子角度和速度,可以获得良好的动态和稳态性能.     

动态OD反推理论中的关键问题研究

针对ITS研究中动态OD矩阵难以获得的问题,回顾动态OD反推理论的发展历程,在此基础上明确了该领域研究中的四个关键问题:状态变量的选择、系统方程的确定、OD量与路段流量的关系和OD矩阵动态特性的体现,在对其进行分析的基础上提出每个关键问题的解决方法,为动态OD反推理论的进一步研究垫定基础。     

考虑横向漂移的船舶路径跟踪自抗扰控制

针对船舶运动系统中内部动态不确定和外部干扰等问题,进行了欠驱动船舶路径跟踪的自抗扰方法研究。利用Backstepping设计参考航向角,并通过线性扩张状态观测器对流干扰和横向运动引起的横向漂移进行估计。其次,根据自抗扰算法对航向进行控制,采用线性扩张状态观测器对外界干扰及内部不确定项进行估计。最后仿真结果表明,在风流干扰下所设计的控制器仍能使船准确地跟踪上参考路径,验证了所提控制方案的有效性。     

Coloured Petri net-based traffic collision avoidance system encounter model for the analysis of potential induced collisions

The Traffic Alert and Collision Avoidance System (TCAS) is a world-wide accepted last-resort means of reducing the probability and frequency of mid-air collisions between aircraft. Unfortunately, it is widely known that in congested airspace, the use of the TCAS may actually lead to induced collisions. Therefore, further research regarding TCAS logic is required. In this paper, an encounter model is formalised to identify all of the potential collision scenarios that can be induced by a resolution advisory that was generated previously by the TCAS without considering the downstream consequences in the surrounding traffic. The existing encounter models focus on checking and validating the potential collisions between trajectories of a specific scenario. In contrast, the innovative approach described in this paper concentrates on quantitative analysis of the different induced collision scenarios that could be reached for a given initial trajectory and a rough specification of the surrounding traffic. This approach provides valuable information at the operational level. Furthermore, the proposed encounter model can be used as a test-bed to evaluate future TCAS logic changes to mitigate potential induced collisions in hot spot volumes. In addition, the encounter model is described by means of the coloured Petri net (CPN) formalism. The resulting state space provides a deep understanding of the cause-and-effect relationship that each TCAS action proposed to avoid an actual collision with a potential new collision in the surrounding traffic. Quantitative simulation results are conducted to validate the proposed encounter model, and the resulting collision scenarios are summarised as valuable information for future Air Traffic Management (ATM) systems.     

State estimation in roll dynamics for commercial vehicles

Accurate lateral load transfer estimation plays an important role in improving the performance of the active rollover prevention system equipped in commercial vehicles. This estimation depends on the accurate prediction of roll angles for both the sprung and the unsprung subsystems. This paper proposes a novel computational method for roll-angle estimation in commercial vehicles employing sensors which are already used in a vehicle dynamic control system without additional expensive measurement units. The estimation strategy integrates two blocks. The first block contains a sliding-mode observer which is responsible for calculating the lateral tyre forces, while in the second block, the Kalman filter estimates the roll angles of the sprung mass and those of axles in the truck. The validation is conducted through MATLAB/TruckSim co-simulation. Based on the comparison between the estimated results and the simulation results from TruckSim, it can be concluded that the proposed estimation method has a promising tracking performance with low computational cost and high convergence speed. This approach enables a low-cost solution for the rollover prevention in commercial vehicles.     

国家助学贷款资产证券化制度设计研究

在2004年的国家助学贷款新政策背景下,尽管出现了许多利好方面,仍存在一些尚未解决的问题。而完整的国家助学贷款市场应当是由一级市场和二级市场组成的一个有序开放式的市场体系：一级市场是创造国家助学贷款形成借贷关系的市场,二级市场是创造国家助学贷款债权转让的市场。资产证券化是我国目前解决问题、完善市场、金融创新的重要选择,这项选择不仅很有必要,且基本具备了可行条件。当然,我国如果进行国家助学贷款资产证券化,还需要建立良好的征信制度和其它保障制度。     

加强航海人员VTS意识的必要性

文中首先阐述了VTS的重要性,为进一步发挥VTS作用,提出了加强航海人员VTS意识的必要性,并结合案例进一步论证航海人员VTS意识的重要性,最后结合国际公约及国家的相关规则,对现有航海人员的培训提出细化及增添的建议,提出了通过岸基管理、航海人员的培训及港口国监督等方法来提升航海人员的VTS意识。     

未知负载和转子电阻的交流感应电机自适应控制

基于自适应观测控制器设计了三相交流感应电机调速系统,该控制器在未知电机转子电阻和负载及不需要测量磁链情况下,可同时且不受限制地单独控制电机转速(转矩)和磁链.控制器只测量转速、电压和电流信号自适应估计磁链和未知参数.用该控制方法设计了两相坐标轴磁场定向电机模型,系统不存在非线性,因此适合离散化和DSP系统的数字实现.