首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   373篇
  免费   26篇
公路运输   128篇
综合类   130篇
水路运输   63篇
铁路运输   48篇
综合运输   30篇
  2024年   1篇
  2022年   5篇
  2021年   10篇
  2020年   8篇
  2019年   6篇
  2018年   13篇
  2017年   7篇
  2016年   14篇
  2015年   21篇
  2014年   33篇
  2013年   21篇
  2012年   21篇
  2011年   32篇
  2010年   30篇
  2009年   35篇
  2008年   25篇
  2007年   37篇
  2006年   29篇
  2005年   21篇
  2004年   9篇
  2003年   3篇
  2002年   7篇
  2001年   2篇
  2000年   3篇
  1998年   1篇
  1997年   1篇
  1995年   1篇
  1993年   1篇
  1992年   1篇
  1984年   1篇
排序方式: 共有399条查询结果,搜索用时 15 毫秒
1.
目前,针对具有多个原位地应力测试钻孔的隧址区初始地应力场反演,往往一次性将全部实测值用以计算值的回归反分析,没有考虑到隧道纵向长度远超其他方向且钻孔分布较远的特点,单个钻孔表征的临近区域地应力分布特征或反演精度被其余钻孔实测值“拉低”,导致整体反演结果容易陷入局部优解。依托拉林铁路桑珠岭隧道、叙毕铁路斑竹林隧道、沿江高速火山隧道、木寨岭公路隧道等工程,采用多元线性回归法结合最小二乘法寻优准则,分析了隧址区仅有单个钻孔反演精度较高的原因,提出了对具有多个钻孔的隧址区分段并分别进行单钻孔回归反演的新方法。在此基础上,重点讨论了木寨岭公路隧道断层破碎带区域地应力分布特征。结果表明:分段单孔反演较多孔反演进一步提高了反演精度;地应力的分布在断层前后呈现出先急剧增大后急剧减小的特征;除自重应力与埋深存在一定关联外,两项水平主应力随断层间距或厚度的增大突变性加剧;断层之间间距、断层倾角、断层厚度均是影响地应力方向偏转大小的重要因素,断层之间间距或断层倾角越小、断层越厚,地应力方向偏转越显著。  相似文献   
2.
用非常规的施工工艺来解决路基施工中的一些具体问题 ,在实践中证明对工程质量和进度的现场控制是有利的 .非常规工艺并非违背常规工艺或操作程序 ,而是在原理相同的前提下 ,本着具体问题具体对待的原则 ,对常规工艺、程序及方法的又一补充  相似文献   
3.
深圳地铁一期工程无线通信系统技术方案   总被引:1,自引:1,他引:0  
介绍了深圳地铁一期工程无线通信系统的技术方案、无线调度系统的构成及关键设备,对系统功能进行说明,具有实际应用价值。  相似文献   
4.
Bus Priority Using pre-signals   总被引:2,自引:0,他引:2  
The need to provide efficient public transport services in urban areas has led to the implementation of bus priority measures in many congested cities. Much interest has recently centred on priority at signal controlled junctions, including the concept of pre-signals, where traffic signals are installed at or near the end of a with-flow bus lane to provide buses with priority access to the downstream junction. Although a number of pre-signals have now been installed in the U.K., particularly in London, there has been very little published research into their design, operation and optimisation. This paper addresses these points through the development of analytical procedures which allow pre-implementation evaluation of specific categories of pre-signals. The paper initially sets out three categories of pre-signal, which have different operating characteristics, different requirements for signalling and different impacts on capacity and delay. Key issues concerning signalling arrangements for these categories are then discussed, together with a summary of the analytical approach adopted and the assumptions required. Equations are developed to allow appropriate signal timings to be calculated for pre-signalised intersections. Further equations are then developed to enable delays to priority and non-priority traffic, with and without pre-signals, to be estimated with delay being taken here as the key performance criterion. The paper concludes with three application examples illustrating how the equations are applied and the impacts of pre-signals in different situations.The analyses confirm the potential benefits of pre-signals, where these signals apply to non-priority traffic only. Where buses are also subject to a pre-signal, it is shown that disbenefits to buses can often occur, unless bus detectors are used to gain priority signalling.  相似文献   
5.
应用水平定向钻安装管道时回拖拉力的计算方法   总被引:1,自引:2,他引:1  
研究了应用水平定向钻机安装地下管道回拖过程中的受力特征,分析了计算回拖拉力时参数的选择以及公式应用的特点,并将预测数据与实验数据作了对比分析,从而得出了回拖拉力与孔道直径成反比.  相似文献   
6.
李硕 《中南公路工程》2005,30(1):158-160,164
提出的自动判定和实时跟踪高速公路常发性拥挤路段的方法包含3个算法:①路段平均车速算法;②交通流区段类型判定算法;③排队类型判定算法。考虑采用两个前后相邻车辆检测站之间的路段平均车速来实时判定和跟踪常发性交通拥挤路段的情况,使得模型所提供的信息更能反映路段的真实交通状况。采用路段平均车速的方法克服了目前采用点速度来跟踪车队方法的局限性,并且采用“客观”标定临界车速作为基于现场数据判定车队状态的一种方法。  相似文献   
7.
关于城轨列车折返能力计算与加强的研究   总被引:4,自引:0,他引:4  
论证折返出发间隔时间是决定列车折返能力的基本参数,提出折返出发间隔时间计算方法,分析采用特殊列车交路对折返出发间隔时间的影响,并针对影响折返出发间隔时间的因素提出加强列车折返能力的措施。  相似文献   
8.
为解决信号交叉口运行效率评价方法偏理论化、实用性不强等问题,以出租车、公交车、驾图(车联网)多源GPS轨迹数据为基础,充分利用车辆减速、停车、加速等连续速度变化特征及位置信息,提出交叉口个体车辆排队长度、通行时间、停车次数等交通参数提取技术.基于此,构建以信号交叉口运行指数为一级指标,车辆平均通行时间,第95%分位排队...  相似文献   
9.
三门海特大桥复杂的天然条件相对于主墩的深水基础施工而言相当恶劣,通过对高桩承台三个方案的优化比选,确定了承台采用钢吊箱施工方案,并详细介绍了水中临设、深水桩基、钢吊箱施工的方法,最后对深水基础施工进行了系统总结。  相似文献   
10.
ABSTRACT

Predicting the risk of traffic demands and delays exceeding critical limits at road junctions, airports, hospitals, etc., requires knowing how both mean and variance of queue size vary over time. Microscopic simulation can explore variability but is computationally demanding and gives only sample results. A computationally efficient approximation to the mean is used in many modelling tools, but only empirical extensions for variance in particular situations have been available. The paper derives theoretical formulae for time-dependent and equilibrium variance, believed to be novel and to apply generally to queues covered by the Pollaczek–Khinchin mean formula, and offering possible structural insights. These are applied in an extended approximation giving mutually consistent mean and variance estimates with improved accuracy. Tests on oversaturated peak demand cases are compared with Markov probabilistic simulation, demonstrating accuracy (R2?>?0.99) for typical random, priority-like (M/M/1) and traffic-signal-like (M/D/1) queues. Implications for risk analysis, planning and policy are considered.  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号