基于无人机的高层住宅最后“一百米”配送优化

针对城市高层住宅顾客对上门配送服务的需求，借助无人机停放平台，考虑包裹异质性以及无人机在不同配送阶段的精确能耗，构建以无人机飞行成本和能耗成本最小为目标，以无人机容量、电池组容量等为约束的高层住宅无人机上门配送模型，解决“垂直位置最后一百米配送”问题。基于此模型，设计带变邻域下降(VND)搜索的混合蚁群算法(HACO-VND)，引入4个算子进行变邻域下降搜索，为了提高算法的求解性能，提出两种局部搜索算子组合，根据顾客点数量使用不同的算子组合。实验结果表明，HACO-VND算法较CPLEX在求解精度与求解时间方面更优，特别是在大中型算例中表现出较佳性能。参数分析表明，高层住宅楼层数越多，无人机单次 飞行的能耗利用率越大，无人机容量与电池组容量共同对配送方案产生影响。为以后无人机送货上门服务方面的研究提供参考和思路。     

Costs of air pollutants from shipping: a meta-regression analysis

ABSTRACT

This study estimated the external cost of air pollution from shipping by means of a meta-regression analysis, which has not been made before. Three pollutants, which were included in most of the primary studies, were considered: nitrogen oxides (NO_x), sulphur dioxides (SO₂) and particulate matters with a diameter of max 2.5 micrometres (PM_2.5). All primary studies included damages of health and a majority added impacts on agriculture and estimated the cost of air pollutants by transferring cost estimates from studies on costs of air emissions from transports in Europe. Different regression models and estimators were used and robust results were found of statistically significant emission elasticities of below one, i.e. total external costs increase by less than 1% when emissions increase by 1%. There was a small variation between the pollutants, with the highest elasticity for PM_2.5 and lowest for NO_x. Calculations of the marginal external cost of the pollutants showed the same pattern, with this cost being approximately six times higher for PM_2.5 than for the other pollutants. Common to all pollutants was that the marginal external cost decreases when emission increases. Another robust result was a significant increase in the cost of studies published in journals compared with other publication outlets. These findings point out some caution when transferring constant external unit cost of air pollutant from shipping, which is much applied in the literature, and the cost functions estimated in this study could thus provide a complementary transfer mechanism.     

预制节段拼装结构套筒连接检测方法综述

随着我国逐步推进预制节段拼装结构的应用,灌浆套筒作为节段拼装可靠的钢筋连接方式,广泛应用于桥梁建造中。本文介绍了目前钢筋套筒连接使用中的容易产生的缺陷及其影响,针对这些问题,本文介绍了几种主要检测方法,对其检测原理进行了简要阐述,总结了检测效果及其适用范围,并归纳了现有规范中对于这些检测方法的要求。同时对于套筒连接施工中的质量控制,本文以实际工程项目为例提出了一些监控措施。     

A new solution for two-bag air suspension system with leaf spring for heavy-duty vehicle

The design problem of a two-bag air suspension system for heavy-duty vehicles is formulated as a two-level (suspension system level and component level) optimization problem. At the suspension system level, optimal stiffness matrix of leaf spring, characteristics of damper and upper rod layout are determined by solving a multi-objective constrained optimization problem with response surface. At the component level, shape and thickness of the leaf spring are formed using cubic-spline curves to make the stiffness matrix as close to the target values cascaded from suspension system level as possible. Simulations using a vehicle model described by multi-body model and FEM of the novel leaf spring validate the suspension system thus derived.     

含酚废水处理工艺综述

含酚废水是一种常见的工业废水，本文分别阐述了萃取、SBR、湿式氧化几种典型工艺处理含酚废水的试验情况，归纳出不同含酚废水合适的处理工艺。     

金属橡胶液体复合弹簧的发展和应用

介绍了橡胶减振器的产生和发展过程，以及金属橡胶液体复合弹簧的发展与应用，着重介绍了铁路车辆用的金属橡胶液体复合弹簧的性能，最后简述了这种弹簧今后的发展情况。     

电机悬挂方式对LIM地铁系统动力特性的影响研究

研究目的：研究直线电机地铁在不同电机悬挂方式下的气隙变化规律及车辆、轨道的动力响应特性，并将二者进行比较。研究方法：应用车辆轨道耦合动力学理论，分别建立不同悬挂方式下的系统模型并编制相应的仿真程序，通过在轨道局部加入谐波型余弦不平顺激励对系统的动力特性进行分析。研究结果：2种悬挂方式对系统的各向加速度和轮轨力的影响差别较小，而气隙变化呈现明显不同的规律。研究结论：直线电机采用架悬式悬挂时，要严格控制幅值大于5．5mm的长波不平顺，防止电机和反力板之问的刮蹭；而当采用抱轴式悬挂时，要注意控制大幅值的短波不平顺出现，防止气隙过大，影响电机效率。     

转K2型转向架弹簧载荷识别及其对弹簧寿命影响的研究

用试验的方法得到在垂直载荷作用下弹簧45°方向应力和最大主应力之间的差异,用有限元法计算了弹簧在横向、垂向加载时的载荷识别系数。根据线路实测动应力识别出转K2型转向架弹簧在运用工况下的2种载荷。最后根据载荷计算出弹簧的应力,利用疲劳损伤模型计算出损伤,得出了2种载荷对疲劳寿命的影响。     

MARPOL73/78附则Ⅵ大气污染物排放控制的进展

文章以IMO大气污染通信工作组在2006年底召开的工作会议为背景,介绍了针对船用柴油发动机和燃料控制排放标准的讨论情况。     

采用喷风冷却工艺提高淬火钢轨性能的研究

钢轨喷风淬火工艺采用单一的冷却介质压缩空气,使淬火冷却均匀性得到提高,而且不受钢轨表面状态对淬火质量的影响,便于生产管理。由于在冷却装置中加入侧面喷风冷却,淬火硬度分布更合理,有利于提高淬火钢轨抗侧磨能力。线路铺设使用也表明,喷风淬火钢轨比喷雾淬火钢轨具有更好的抗剥离性。根据目前国内淬火线生产状况,提出调整钢轨的成分和采用喷风冷却工艺是当前迫切需要解决的问题。