西韩城际铁路湿陷性黄土地层现场浸水试验研究

在分析西韩城际铁路沿线黄土分布特征的基础上,选取代表性场地开展现场试坑浸水试验。试验结果表明:场地实测最大自重湿陷量为46 mm,仅为室内压缩试验计算值的0.23倍;湿陷土层厚度15 m,除Q;黄土全部具有湿陷性外,Q;上部黄土亦具有湿陷性;地表水自然入渗深度超过50 m,浸润角约为40°,浸润范围约为浸水试坑直径的1.7倍。对现场实测值和室内计算值差异原因进行深入分析,得出在黄土结构未完全破坏之前,发生过湿陷的土体在特定条件下还有可能再次湿陷的结论。     

航空货运产业关联性及临空产业体系构建研究

本文将从航空经济链条体系结构入手,运用投入产出法对航空货运业与各产业部门的关联性进行定量分析,构建以运输成本为主要影响因素的区位选择指标分析货运枢纽机场的产业带动机制。最后本文对目前我国航空货运业对国民经济的整体贡献进行评价,并提出通过航空货运业带动区域经济发展的政策建议。     

The uplift capacity of single-plate helical pile in shallow dense sand including the influence of installation

The helical pile has been used to resist the tension for a long time. However, the prediction of the uplift capacity of helical piles including the influence of installation is still a challenge in design. Based on the change in stress according to Mohr-Coulomb failure criterion, a simple theoretical method has been developed, which can calculate the uplift capacity of shallow pre-embedded circular plate anchors and the uplift capacity of helical piles installed by torque and compression. In order to analyse the influence of installation process of a single-plate helical pile on its uplift capacity and verify the theoretical model, a series of model tests have been conducted in dense saturated sand. The single-plate helical piles with different out diameters of helixes have been installed with different installation speeds, and then, the single-plate helical piles have been moved up monotonically. The test results show that the installation speed and the size of the out diameter of the helix have significant influence on the uplift capacity of the helical piles, and the results of the theoretical method have a good fit with the test results. Using this simple theoretical method, the designer can easily predict the uplift capacities of helical piles, which includes the influence of installation.     

FPSO内孤立波载荷实验观测及理论预报模型研究

利用大型密度分层水槽开展了下凹型内孤立波作用在FPSO上的载荷特性系列实验;并依据实验工况,考虑KdV、eKdV和MCC内孤立波理论的适用性条件,数值研究了FPSO内孤立波载荷成分构成;基于实验结果和载荷成分构成,建立了FPSO内孤立波载荷的理论预报模型.研究表明:FPSO内孤立波水平载荷由粘性力和Froude-Krylov力组成,而垂向载荷主要为垂向Froude-Krylov力;Froude-Krylov力可通过动压力沿FPSO浮体湿表面积分得到,粘性力则通过经实验回归的摩擦系数Cf、形状修正因数K乘以内孤立波诱导水质点切向速度沿FPSO浮体湿表面积分得到.系列实验结果得出:摩擦系数Cf和形状修正因数K与雷诺数Re、KC数和流体层深度比h1/h有关;摩擦系数与Re呈自然对数关系;而形状修正因数K与KC数呈幂函数关系.理论预报模型预报的水平载荷、垂向载荷结果均与系列实验和数值结果吻合较好,并且发现随着内孤立波振幅的增加,载荷幅值近乎线性增加,而且上层流体深度对水平力幅值有明显的影响.     

某款商用汽车电堆散热系统方案设计

从商用汽车电堆散热系统设计要求的实际角度出发设计系统原理图,从而进行计算匹配及选型零部件,对所选零部件进行仿真校核是否满足最初的设计要求,保证商用汽车电堆散热系统的正常工作。     

A signal decomposition method based on repeated extraction of maximum energy component for offshore structures

Contrary to most signal decomposition methods that usually decompose an original signal into a series of components simultaneously, a novel approach based on repeated extraction of Maximum Energy Component (MEC) is proposed. The approach starts from determination of the MEC referring to the estimated Power Spectral Density (PSD) function, and then represents the MEC by employing an exponential function to fit the original signal. By defining a stopping criterion based on two adjacent estimated PSDs, each MEC can be accurately extracted with an improved performance throughout the entire signal decomposition. To verify the proposed method, a single degree-of-freedom system subject to harmonic loads has been examined. Numerical results show that the analytical response can not only be decomposed into four MECs corresponding to the excitation and the system, respectively, but also provide an accurate estimation of natural frequency and damping ratio of the system. Meanwhile, by observing results from the Ensemble Empirical Mode Decomposition (EEMD), Variational Mode Decomposition (VMD) and Prony based on state-space model (Prony-SS), an improved decomposition accuracy has been achieved from the proposed approach. Furthermore, experimental data from the Norwegian Deepwater Programme and two sets of field-test data from one fixed offshore platform and an offshore wind turbine have been used to demonstrate the correctness of the developed signal decomposition method. It is noted that divergence in results by Prony-SS can be observed when a very large model order is used, while the proposed method provides the better decomposition and reconstruction of signals.     

抛石基床振夯工艺在重力式码头施工中的应用

针对重力式码头基床抛石中传统的重锤夯实及爆破夯实工艺效率较低、对周边环境影响较大等问题，进行振动夯实的试验和研究。通过典型试验确定振夯基床厚度、夯锤转速、单点振夯时间等施工参数，并分析和检验振夯效果，验证了抛石基床振夯施工工艺的可行性。该工艺可大幅度提高作业效率和夯实质量，为类似工程提供借鉴。     

特殊条件下的真空预压密封技术

结合广州港南沙港区二期工程软基处理工程实例,针对在局部有抛石地段的软土采取真空预压方法加固时传统的挖密封沟和施打淤泥搅拌墙技术存在相当大困难的情况,提出了在有抛石地段采取高压旋喷桩密封技术。实测结果表明,采取该技术密封效果良好,真空度能达到设计要求。与堆载方案相比,采取本技术经济效益良好,具有较好的推广价值。     

汽车动力总成弯曲振动应力响应及其激励灵敏度分析

本文利用文献（５）建立的汽车动力总成弯曲有限元分析模型，计算分析离合器壳的动应力响应，并考察了动应力关于不平衡质量位置的灵敏度，对计算分析进行了实验验证。     

空气污染气象与大气环境影响评价和预测研究

通过关于大气污染与气象条件、污染气象要素的测量手段和方法的介绍,以及对区域大气边界层扩散参数、大气扩散数学模式选择等计算方法的分析后,进一步阐明污染物在大气输送、扩散、迁移的稀释过程中,与气候、气象条件有着密切关系,应在大气环境影响评价和预测分析中予以重视。