全文获取类型
收费全文 | 211篇 |
免费 | 10篇 |
专业分类
公路运输 | 38篇 |
综合类 | 74篇 |
水路运输 | 53篇 |
铁路运输 | 44篇 |
综合运输 | 12篇 |
出版年
2023年 | 3篇 |
2022年 | 5篇 |
2021年 | 10篇 |
2020年 | 9篇 |
2019年 | 6篇 |
2018年 | 3篇 |
2017年 | 9篇 |
2016年 | 5篇 |
2015年 | 7篇 |
2014年 | 10篇 |
2013年 | 14篇 |
2012年 | 17篇 |
2011年 | 11篇 |
2010年 | 16篇 |
2009年 | 12篇 |
2008年 | 18篇 |
2007年 | 20篇 |
2006年 | 14篇 |
2005年 | 15篇 |
2004年 | 3篇 |
2003年 | 4篇 |
2002年 | 2篇 |
2001年 | 2篇 |
1999年 | 2篇 |
1997年 | 1篇 |
1995年 | 2篇 |
1991年 | 1篇 |
排序方式: 共有221条查询结果,搜索用时 15 毫秒
1.
电机悬挂方式对LIM地铁系统动力特性的影响研究 总被引:1,自引:0,他引:1
研究目的:研究直线电机地铁在不同电机悬挂方式下的气隙变化规律及车辆、轨道的动力响应特性,并将二者进行比较。研究方法:应用车辆轨道耦合动力学理论,分别建立不同悬挂方式下的系统模型并编制相应的仿真程序,通过在轨道局部加入谐波型余弦不平顺激励对系统的动力特性进行分析。研究结果:2种悬挂方式对系统的各向加速度和轮轨力的影响差别较小,而气隙变化呈现明显不同的规律。研究结论:直线电机采用架悬式悬挂时,要严格控制幅值大于5.5mm的长波不平顺,防止电机和反力板之问的刮蹭;而当采用抱轴式悬挂时,要注意控制大幅值的短波不平顺出现,防止气隙过大,影响电机效率。 相似文献
2.
利用计算流体力学软件Pumplinx模拟鱼雷发动机中三组元比例控制器的内部流场,分析计算中不同压差情况下对比例控制器性能的影响,以及叶片与定子间间隙大小对于比例控制器性能的影响,同时对不同叶片数目下性能进行对比。计算结果表明:由于比例控制器为被动旋转马达结构,其转速和流量均随时间呈周期性脉动变化,随着工作压差增大,转速脉动幅度基本保持不变,而流量和扭矩脉动幅值增加;随着间隙增大,泄漏量增大,但流量、扭矩、转速脉动幅值大幅降低,出口流量较为平稳;叶片数目增多后比例控制器转速降低、排量降低。由计算结果推断出目前比例控制器的最优叶片数目为4。本文可为进一步研究比例控制器精度问题提供参考。 相似文献
3.
在充分分析典型四相位交叉口行人二次过街设置前、后的行人流与右转车流冲突的前提下,以行人过街时间占有率和行人群到达分布作为分析指标,利用可插车间隙理论得出行人单向通行和双向通行条件下的右转车通行能力计算公式;根据行人流随机消散和集中消散的不同特征,应用随机分布理论推导出右转车穿越行人流的延误模型;并通过算例对比分析行人二次过街设置前、后右转车通行能力和延误的变化值。结果表明,除了在少数行人流量比较大的情况下,
行人二次过街的设置会小幅度减少右转车的延误;在其他大多数情况下,行人二次过街设置后,
右转车的通行能力将受到限制,延误增大,其中,平均通行能力降低了16.68%,平均延误时间增大
了21%,所以,当右转车交通需求较大时,需同时考虑行人和右转车的交通运行状态,优化设计是否采用行人二次过街,避免右转车超出极限忍耐时间而增大与行人冲突的概率。 相似文献
4.
In this paper, a novel mesoscopic multilane model is proposed to enable simultaneous simulation of mandatory and discretionary lane-changing behaviors to realistically capture multilane traffic dynamics. The model considers lane specific fundamental diagrams to simulate dynamic heterogeneous lane flow distributions on expressways. Moreover, different priority levels are identified according to different lane-changing motivations and the corresponding levels of urgency. Then, an algorithm is proposed to estimate the dynamic mandatory and discretionary lane-changing demands. Finally, the lane flow propagation is defined by the reaction law of the demand–supply functions, which can be regarded as an extension of the Incremental-Transfer and/or Priority Incremental-Transfer principles. The proposed mesoscopic multilane cell transmission model is calibrated and validated on a complex weaving section of the State Route 241 freeway in Orange County, California, showing both the positive and negative impact of lane changing maneuvers, e.g., balancing effect and capacity drop, respectively. Moreover, the empirical study verifies that the model requires no additional data other than the cell transmission model does. Thus, the proposed model can be deployed as a simple simulation tool for accessing dynamic mesoscopic multilane traffic state from data available to most management centers, and also the potential application in predicting the impact of traffic incident or lane control strategy. 相似文献
5.
从故障现象原因入手,根据先外后内、先简后繁原则,对故障进行由外到内,先易到难的检查,然后依据厂家提供的数据参数,运用专用检测设备,对电机内部进行精确测量,通过数据对比分析,最终确定故障根源。 相似文献
6.
本文以介绍轴系校中的计算方法为主,同时简单介绍Nauticus Shaft Alignment软件在计算过程中的应用。轴系校中的目的在于通过调整各轴承的合理位置,使各个轴承上的负荷在各种工况下均能合理分配。 相似文献
7.
通过对河北省沿海高速公路秦皇岛段进行重载交通长寿命半刚性基层沥青路面关键技术的研究,提出优化的SAC沥青混合料设计方法,尝试在解决沥青面层的早期破坏问题的同时满足面层的功能要求,可供同行参考。 相似文献
8.
9.
《Vehicle System Dynamics: International Journal of Vehicle Mechanics and Mobility》2012,50(8):661-690
This paper presents a vehicle adaptive cruise control algorithm design with human factors considerations. Adaptive cruise control (ACC) systems should be acceptable to drivers. In order to be acceptable to drivers, the ACC systems need to be designed based on the analysis of human driver driving behaviour. Manual driving characteristics are investigated using real-world driving test data. The goal of the control algorithm is to achieve naturalistic behaviour of the controlled vehicle that would feel natural to the human driver in normal driving situations and to achieve safe vehicle behaviour in severe braking situations in which large decelerations are necessary. A non-dimensional warning index and inverse time-to-collision are used to evaluate driving situations. A confusion matrix method based on natural driving data sets was used to tune control parameters in the proposed ACC system. Using a simulation and a validated vehicle simulator, vehicle following characteristics of the controlled vehicle are compared with real-world manual driving radar sensor data. It is shown that the proposed control strategy can provide with natural following performance similar to human manual driving in both high speed driving and low speed stop-and-go situations and can prevent the vehicle-to-vehicle distance from dropping to an unsafe level in a variety of driving conditions. 相似文献
10.