引水隧洞突涌段变形特征及控制关键技术研究

深埋引水隧洞突泥突水洞段注浆固结圈与初期支护结构作为协同承载结构,其荷载分担与变形控制对结构和施工安全有重要作用。为研究深埋引水隧洞突涌洞段围岩与支护体系稳定性,以滇中引水狮子山隧洞为工程依托,通过现场对围岩-支护监控量测与第二层型钢拱架受力监测,结合施工工况动态分析围岩-支护体系受力与变形,研究总结突涌段施工变形控制关键技术。研究结论:(1)深埋隧洞突涌洞段拱顶累计沉降17.4 mm,达预留值的17%左右;拱肩、拱腰累计收敛106.6 mm、98.1 mm,达预留值100%左右。(2)突涌洞段理论预测极限位移150 mm;现场监测评价设定阈值uo=100 mm,当达到2/3时,应采取加强措施。(3)最佳开挖方法为微台阶法。各级台阶长度控制在3 m左右,按“快挖、快支、快封闭”原则组织施工。(4)超前预支护管棚结构起到提高固结体刚度作用,较固结体提高约13倍。(5)双层支护结构强度、刚度增加,承载能力明显提高,施工安全性也得以提高。     

掘进机黏性渣土结泥饼机制及聚合物改良研究

针对掘进机在黏性地层中施工刀盘结泥饼的问题，以无锡地铁4号线某矩形顶管工程为例，通过添加不同质量的聚合物对不同含水率的渣土进行改良，测试改良前后渣土的黏附强度、不排水抗剪强度及高温环境下渣土的保水能力，并通过液塑限变化分析渣土改良的机制，借助泥饼形成风险分区图评估泥饼形成的风险与改良效果。研究表明： 1）添加聚合物和水对渣土黏附强度有一定影响，增大含水率能显著降低渣土的黏附强度，当渣土含水率为35%~45%时，添加聚合物能有效降低渣土的黏附强度； 2）含水率的增大会降低渣土的不排水抗剪强度，而添加聚合物能有效增强渣土的不排水抗剪强度，当添胶比达到0.15%后增强效果显著； 3）聚合物能提高渣土的液限和保水能力，保证渣土的流塑性满足施工需要； 4）结合泥饼形成风险分区图，比较渣土-金属界面的黏附强度和渣土的不排水抗剪强度，可以综合判断黏性渣土结泥饼的风险和改良效果。     

完善我国海难救助报酬分配的几点建议

救助报酬的分配是海难救助制度中一个至关重要的方面。分配方案的合理与否,公正与否直接影响鼓励救助这一目的的实现。分析了我国有关海难救助报酬分配的现状,比较、借鉴有关救助公约和英、美、日等国家国内法,为其完善提出了几点修改建议。     

Distribution of suspended sediment in the coastal sea off the Ganges–Brahmaputra River mouth: observation from TM data

Remote sensing technique was applied to estimate suspended sediment concentration (SSC) and to understand transportation, distribution and deposition of suspended sediment in the estuary and throughout the coastal sea, off the Ganges–Brahmaputra River mouth. During low river discharge period, zone of turbidity maximum is inferred in the estuary near the shore. SSC map shows that maximum SSC reaches 1050 mg/l in this period. Magnitude of SSC is mainly owing to resuspension of the bottom surface sediments induced by tidal currents flowing over shallow water depths. The influence of depth on resuspension is farther revealed from the distribution and magnitude of SSC along the head of Swatch of No Ground (SNG) submarine canyon. During high river discharge period, huge river outflow pushed the salt wedge and flashes away the suspended sediments in the coastal sea off the river mouth. Zone of turbidity maximum is inferred in the coastal water approximately within 5–10 m depth of water, where the maximum SSC reaches 1700 mg/l. In this period, huge fluvial input of the suspended sediments including the resuspended bottom sediments and the particles remaining in suspension for longer period of time since their initial entry control mainly the magnitude of SSC. In the estuary near the shore, seasonal variation in the magnitude of SSC is not evident. In the coastal sea (>5 m water depth), seasonal influence in the magnitude of SSC could be concluded from the discrepancy between SSC values of two different seasons. Transportation and deposition of suspended sediments also experiences seasonal variations. At present, suspended sediments are being accumulated on the shallow shelf (between 5 and 10 m water depth) in low discharge period and on the mid-shelf (between 10 and 75 m water depth) during high discharge period. An empirical (exponential) relationship was found between gradual settle down of suspended sediments in the coastal sea and its lateral distance from the turbidity maximum.     

Species of Thaumatomastix (Thaumatomastigidae, Protista incertae sedis) from the Arctic sea ice biota (North-East Water Polynya, NE Greenland)

The sea ice biota of polar regions contains numerous heterotrophic flagellates very few of which have been properly identified. The whole mount technique for transmission electron microscopy enables the identification of loricate and scaly forms. A survey of Arctic ice samples (North-East Water Polynya, NE Greenland) revealed the presence of ca. 12 taxa belonging to the phagotrophic genus Thaumatomastix (Protista incertae sedis). Species of Thaumatomastix possess siliceous body scales and one naked and one scale-covered flagellum. The presence in both Arctic samples and sea ice material previously examined from the Antarctic indicates that this genus is most likely ubiquitous in polar sea ice and may be an important component in sea ice biota microbial activities.     

加速发展我国高性能船舶和水上高速客运

为开发海洋经济，发展海上运输，加快海军现代化建设步伐，必须加速发展高性能船舶和水下高速客运。为此，本文提出了有关决策层参考的几点政策性建议。     

加装脱硫塔船舶试航活动的安全监督探讨

随着很多国际航行船舶选择加装脱硫塔来应对全球限硫令,单个设备运转试航船舶艘次大量增加。该类试航活动次数频繁、航经水域通航环境复杂、参与人员较多且未经必要的培训,存在较大的安全风险。文中归纳加装脱硫塔船舶的试航活动特征,梳理、分析存在的安全隐患和监督难点,提出相应的管理对策和建议。     

真空辅助压浆在客运专线箱梁施工中的应用

研究目的:针对温福铁路客运专线平阳特大桥后张法预应力现浇箱梁施工过程中应用的真空辅助压浆施工技术,对实际施工中所采取的质量控制要点进行论述,并阐述采用真空辅助压浆工艺进行质量控制的经验和措施。研究结论:在国内后张法预应力箱梁施工中,传统压浆工艺中浆体本身含有气泡及有害成分的雨水,易造成孔隙或预应力筋的腐蚀,降低结构的耐久性。另外,施工中可能存在压浆不密实、不饱和,极易产生孔隙,为后张法预应力箱梁质量留下隐患。而采用真空辅助压浆施工技术,可有效保证预应力孔道压浆后的密实度,提高了结构的安全性、耐久性和使用年限。     

深水复杂地质深孔灌注桩施工技术

以松陶铁路第二松花江特大桥主桥(48+4×80+48)m跨松花江主河道桩基施工为例,从设备选型,钻孔工艺,水下灌筑以及质量控制等方面,介绍在江底复杂地质条件下,深孔灌注桩基的施工技术及控制要点。     

高压喷射注浆技术在基坑管涌处理中的运用

高压喷射注浆法是在注浆法的基础上，应用高压喷射技术而发展起来的一项新的地基加固方法。本文针对武汉市泰合广场基坑在开挖过程中形成管涌或流上而致使附近建筑物遭受严重破坏的问题，采用高压喷射注浆法施工工艺方法，杜绝了基坑壁管涌或流立现象，使基坑开挖和基础施工得以安全进行。