宁夏铁通MSTP城域网的发展策略探讨

首先分析了当前城域传送网的普遍现状，然后针对宁夏铁通MSTP城域网存在的问题，提出了优化方案和整改建议。     

CA498柴油机冷却水流LDV测量

为验证柴油机冷却水套CFD计算结果的准确性，利用LDV测速系统测量了CA498柴油机缸盖及缸体内流场12个关键点处的速度，并将试验结果与CFD计算结果进行了比较一结果表明，除了缸体上3个点的实际测量结果与CFD计算结果有较大偏差以外，其他各点试验测得的数据与CFD计算结果有较好的一致性。分析了造成偏差的主要原因。     

发动机冷却水套内三维流动的数值模拟研究

应用FIRE软件对某一发动机冷却水套进行了三维数值模拟，得到了冷却液流场速率、换热系数分布、压力损失以及流量分布等流场信息。从计算结果中发现，该发动机缸体水套的第2缸、第3缸等区域存在流动死区．水套进、排气侧流量分布相差较大．整体水套压力损失与同类机型相比偏小等不合理的流动现象，是导致其第2缸、第3缸“拉缸”的主要原因。最后提出了相应的解决方案。     

气压ABS系统流量特性的实验研究

开发了气压ABS电磁阀测试系统，建立了气室充、放气过程压力变化的微分方程，结合两者研究了气压ABS系统的流量特性，获得了某中型客车ABS系统在不同情况下的流量系数。讨论了ABS电磁阀的结构参数和动作频率对整个系统流量特性的影响，并得到了几种典型动作频率下的流量系数。建立的气室压力模型和所求得的流量系数为气压ABS控制逻辑的设计提供了依据。     

屈服假塑性流体管流流动及传热规律研究

结合屈服假塑性流体的本构方程、管流力平衡关系式以及非牛顿流体的能量方程，得出了屈服假塑性流体管流速度分布及温度分布。研究结果表明：由于屈服应力的作用，管中心存在柱塞流动，柱塞的半径与屈服应力成正比，与压力梯度成反比；管流流量随屈服应力的增大而减小；柱塞内温度一致，从柱塞边界到管壁，温度逐渐减小，而且越靠近管壁，温降梯度越大。     

水平管段塞流气量减小瞬变过程流动特性分析

在长378m，内径0．08m的水平不锈钢试验环道上利用空气和水进行了段塞流气量瞬变试验研究。试验采用压力变送器测量压力信号，将相邻两压力信号相减(上游减下游)得到压差信号。分析了气量减小瞬变过程中压力、压差的变化规律，对瞬变过程中的各种现象进行了详细分析和合理解释，并对气量减小瞬变过程中的压力过降值进行了定量描述。     

车用催化转化器流动阻力影响因素的研究

流动阻力是车用催化转化器的重要性能之一。作者对载体结构参数，入口扩张管和出口收这三个因素进行了试验研究，并对载体通道的流动进行了理论分析，提出了一种计算载体流动阻力的方法。研究结果表明，载体结构参数和扩张管锥角对流动阻力影响显著，而收缩管锥角的影响不明显，在载体结构参数中，减小载体壁厚是降低催化器阻力的有效措施。     

汽车发动机气道内的流动模拟计算

本文介绍了汽车发动机气道内三维定常可压缩流动数值模拟的模型、算法及算例。为达到能定量分析并应用于实际设计的目的,提出了一种新的计算网格划分法,并开发了计算软件,对提高计算精度、加速收敛等关键问题进行了探索。     

Effects of countdown timers on queue discharge characteristics of through movement at a signalized intersection

This study investigates how countdown timers installed at a signalized intersection affect the queue discharge characteristics of through movement during the green phase. Since the countdown timers display the time remaining (in seconds) until the onset of the green phase, drivers waiting in the queue at the intersection are aware of the upcoming phase change, and are likely to respond quicker. Thus, the countdown timers could reduce the start-up lost time, decrease the saturation headway, and increase the saturation flow rate. This study observed vehicle flow at an intersection in Bangkok for 24 h when the countdown timers were operating, and for another 24 h when the countdown timers were switched off. The signal plans and timings remained unchanged in both cases. Standard statistical t-tests were used to compare the difference in traffic characteristics between the “with timer” and “without timer” cases. It was found that the countdown timers had a significant impact on the start-up lost time, reducing it by 1.00–1.92 s per cycle, or a 17–32% time saving. However, the effects on saturation headway were found to be trivial, which implies that the countdown timers do not have much impact on the saturation flow rate of signalized intersections, especially during the off-peak day period and the late night period. The savings in the start-up lost time from the countdown timers was estimated to be equivalent to an 8–24 vehicles/h increase for each through movement lane at the intersection being studied.     

Impact of macrozoobenthic structures on near-bed sediment fluxes

Sandy sediments in shallow coastal waters of the Baltic Sea are often characterised by large numbers of biogenic structures which are produced by macrozoobenthos species. A series of experiments was devised to quantify how the interaction of such structures with the near-bed flow regime affects the sediment flux. Most experiments were done with simplified replicates of structures generated by typical species commonly found in the Mecklenburg Bight, starting with solitary structures and regularly-spaced arrays in a range of characteristic population densities, followed by a complex benthic macrofauna community, both artificial and alive. A laboratory flume channel, equipped with an acoustic Doppler flow sensor and a topography scanning laser, was used for high-resolution measurements (2 mm horizontal step size and 0.3 mm vertical resolution) of sand erosion (220 µm median grain size, at 20 cm s^− 1) and fine particle deposition (8 µm grain size, at 5 cm s^− 1). Sediment transport threshold values were measured for each layout. As a rule-of-thumb, both the erosion fluxes and the deposition of suspended matter increased considerably at low population densities (below 2%, expressed as percent of the sediment surface covered, i.e. roughness density RD). Above densities of 4%, erosion almost stopped inside the test arrays, and deposition remained well below the level of unpopulated areas. An attempt to extrapolate these findings to field conditions (using field current velocity data from 2001) showed that the net flux switched from erosion to deposition for densities above 5%. These parameters can now be integrated into a numerical sediment transport model coupling waves, currents, sediment dynamics and biological processes, which is currently under construction at the Baltic Sea Research Institute (IOW), Rostock, Germany.