兰新高铁甘青段路基冻胀自动监测及分析研究

为查明兰新高铁甘青段路基冻胀变形原因和影响因素,提出相应的冻胀处理措施,将路基冻胀变形控制在允许范围之内,采用自动监测系统,对路肩以下5 m范围内路基的冻结深度、水分、冻胀变形等进行监测,并对监测结果进行统计分析和深入研究。研究结果表明:路基冻结深度的发展主要受气温的影响,基床表层以下填料含水量随着冻结深度增加缓慢增加;基床表层及基床底层上部1.0 m范围冻胀量占总冻胀量的80%以上;低路堤地段冻胀最严重。为减少路基冻胀量,设计及施工时应采用全冻结深度防冻胀方案,以填料防冻胀为主,辅以防水、疏水和隔热等综合措施;低路堤地段防冻胀措施应适当加强。     

A signal decomposition method based on repeated extraction of maximum energy component for offshore structures

Contrary to most signal decomposition methods that usually decompose an original signal into a series of components simultaneously, a novel approach based on repeated extraction of Maximum Energy Component (MEC) is proposed. The approach starts from determination of the MEC referring to the estimated Power Spectral Density (PSD) function, and then represents the MEC by employing an exponential function to fit the original signal. By defining a stopping criterion based on two adjacent estimated PSDs, each MEC can be accurately extracted with an improved performance throughout the entire signal decomposition. To verify the proposed method, a single degree-of-freedom system subject to harmonic loads has been examined. Numerical results show that the analytical response can not only be decomposed into four MECs corresponding to the excitation and the system, respectively, but also provide an accurate estimation of natural frequency and damping ratio of the system. Meanwhile, by observing results from the Ensemble Empirical Mode Decomposition (EEMD), Variational Mode Decomposition (VMD) and Prony based on state-space model (Prony-SS), an improved decomposition accuracy has been achieved from the proposed approach. Furthermore, experimental data from the Norwegian Deepwater Programme and two sets of field-test data from one fixed offshore platform and an offshore wind turbine have been used to demonstrate the correctness of the developed signal decomposition method. It is noted that divergence in results by Prony-SS can be observed when a very large model order is used, while the proposed method provides the better decomposition and reconstruction of signals.     

既有线提速路基动应力分析

通过对既有线提速区段路基的调研和试验,得出结论,动应力与轴重、速度及线路平顺性有关。列车提速时,轴重增加和轨道不平顺对路基动应力影响最大。路基面动应力在横向呈马鞍分布,动应力沿深度方向衰减较快。采用当量折算和Boussinesq公式推算出的提速后路基动应力与实测值接近。在既有线提速改造中,重点应消除路基病害,提高基床特别是基床表层的强度和稳定性。     

灌注桩深基坑的有限元计算及影响因素分析

对苏州市轨道交通2号线金民东路站深基坑使用灌注桩作为支挡结构的开挖、支护施工进行了有限元数值模拟,据此分析了灌注桩内力、水平侧移等随施工过程的变化以及主体结构的内力情况,并研究了灌注桩刚度、地基土刚度对支护结构侧移和弯矩的影响,对实际施工起到一定的指导作用。     

戈壁粗粒土填料填筑铁路路基压实评价指标研究

选取兰新铁路第二双线4个具有代表性的路基试验段,进行戈壁粗粒土填筑路基的压实质量评价指标研究。研究表明:粗粒土填料填筑路基的孔隙率偏小,但现有规范规定的孔隙率标准偏大,起不到控制路基密实度的作用,因此提出用填料的细颗粒室内击实试验得到的孔隙率换算整体孔隙率的方法控制粗粒土填筑路基的密实度;K30能较好地反映填料的塑性变形,且对压实质量敏感,比Ev2更适合作为路基压实质量的评价指标;Ev2/Ev1控制路基压实质量的实质是Ev1在起作用;规范不应用统一的Ev2/Ev1标准,而应根据填料的粗颗粒含量制定相应的Ev2/Ev1标准,填料的粗颗粒含量越多,填筑的路基的弹性变形量越小,Ev2/Ev1的规范标准应越大;Ev1的测试深度比K30大,且塑性变形在总变形中的比例也大,因此可以考虑将Ev1设定为路基压实质量的评价指标。     

高坝枢纽新建通航建筑物轴线及通航条件研究

针对山区已建高坝枢纽新建通航建筑物轴线布置受河道窄、水头高、电站泄流及已有建筑物影响等条件限制的问题,依托贵州清水江白市水电站枢纽新建通航建筑物工程,采用1∶100正态整体水工模型与自航遥控船模相结合的技术手段,对多条轴线布置方案进行通航水流条件及船舶航行操控研究与优化。试验结果表明,右岸轴线布置方案通航水流条件及船舶航行状态均较好,为推荐方案。研究成果解决了工程关键问题,可供类似已建高坝水利枢纽新建或扩建通航建筑物工程参考借鉴。     

超重货物作用下的铁路轨道路基响应机理研究

为研究超重货物作用下轨道路基动态响应机理,基于有限元软件ANSYS建立轨道-路基三维有限元模型,分析轨道路基在超重货物作用下的应力分布和位移变形规律,并与现有设计规范进行比较。研究结果表明:超重货物作用下,钢轨和轨枕均满足运输要求,道床应力达637.72 k Pa,超出碎石道床容许值,路基基床局部受力达202.33 k Pa。超重货物运输过后,会对既有轨道结构造成一定的损伤,因此要进行必要的养护维修以满足其他车辆的安全运营。研究结果可为以后超重货物的安全运营和重载铁路的养护维修提供一定的参考。     

形状记忆合金对纤维增强聚合物梁驱动效应的分析

着重研究了形状记忆合金偏心埋置于树脂复合材料梁/板后,合金在逆相变过程中对梁弯曲变形的驱动效应。试验结果表明:合金在逆相变过程中能对树脂基复合材料梁产生很大的驱动力,可以按需要主动控制复合材料梁、柱的变形;合金的预应变值因素对于合金的驱动效应有较大影响,合金可以进行多次激励。     

海湾大桥北引道沥青混凝土罩面设计

结合广东省汕汾高速公路汕头海湾大桥北引道路面加铺工程,分析软基路段过渡性路面的病害,提出沥青混凝土路面罩面结构设计和施工中须注意的问题.     

Comparing different contour methods with response-based methods for extreme ship response analysis

Environmental contours are often applied in probabilistic structural reliability analysis to identify extreme environmental conditions that may give rise to extreme loads and responses. They facilitate approximate long term analysis of critical structural responses in situations where computationally heavy and time-consuming response calculations makes full long-term analysis infeasible. The environmental contour method identifies extreme environmental conditions that are expected to give rise to extreme structural response of marine structures. The extreme responses can then be estimated by performing response calculations for environmental conditions along the contours.Response-based analysis is an alternative, where extreme value analysis is performed on the actual response rather than on the environmental conditions. For complex structures, this is often not practical due to computationally heavy response calculations. However, by establishing statistical emulators of the response, using machine learning techniques, one may obtain long time-series of the structural response and use this to estimate extreme responses.In this paper, various contour methods will be compared to response-based estimation of extreme vertical bending moment for a tanker. A response emulator based on Gaussian processes regression with adaptive sampling has been established based on response calculations from a hydrodynamic model. Long time-series of sea-state parameters such as significant wave height and wave period are used to construct N-year environmental contours and the extreme N-year response is estimated from numerical calculations for identified sea states. At the same time, the response emulator is applied on the time series to provide long time-series of structural response, in this case vertical bending moment of a tanker. Extreme value analysis is then performed directly on the responses to estimate the N-year extreme response. The results from either method will then be compared, and it is possible to evaluate the accuracy of the environmental contour method in estimating the response. Moreover, different contour methods will be compared.