基于可靠性方框图与蒙特卡洛仿真的船舶配电网可靠性分析方法

国船舶工业发展迅速,尤其在近几年迎来了跨越式的发展。船舶建设工业的发展能充分体现一个国家的经济和国防建设水平。但船舶配电网拓扑结构与陆上电网不尽相同,其运行环境非常恶劣,供电连续性和可靠性成为衡量船舶生命力的重要指标,同时也深刻影响大型船舶的平均寿命。因此,可靠性研究在船舶建设中发挥着越来越重要的作用。本研究以典型大型船舶中压配电网结构为研究对象,在全系统元件正常运行时相互独立的情况下,重点研究不可维修与可维修下的系统可靠度、MTBF、可用度、停运时间和失效数等,并进行详细的分析与讨论。首先,本文综合考察各种可靠性分析方法的适用性和准确性,选择利用可靠性框图、最小路集分析法计算并分析不可维修情况下系统的可靠度、平均故障间隔时间等可靠性指标；接着,本文简述了配电网的多种维修任务类型,并采用最小路集法与蒙特卡洛仿真法相结合的方法计算并分析可维修系统的可用度、停电时间、失效数等指标。本文研究结果对船舶配电网的设计、建造、运行和维修等具有积极的意义。     

Costs of air pollutants from shipping: a meta-regression analysis

ABSTRACT

This study estimated the external cost of air pollution from shipping by means of a meta-regression analysis, which has not been made before. Three pollutants, which were included in most of the primary studies, were considered: nitrogen oxides (NO_x), sulphur dioxides (SO₂) and particulate matters with a diameter of max 2.5 micrometres (PM_2.5). All primary studies included damages of health and a majority added impacts on agriculture and estimated the cost of air pollutants by transferring cost estimates from studies on costs of air emissions from transports in Europe. Different regression models and estimators were used and robust results were found of statistically significant emission elasticities of below one, i.e. total external costs increase by less than 1% when emissions increase by 1%. There was a small variation between the pollutants, with the highest elasticity for PM_2.5 and lowest for NO_x. Calculations of the marginal external cost of the pollutants showed the same pattern, with this cost being approximately six times higher for PM_2.5 than for the other pollutants. Common to all pollutants was that the marginal external cost decreases when emission increases. Another robust result was a significant increase in the cost of studies published in journals compared with other publication outlets. These findings point out some caution when transferring constant external unit cost of air pollutant from shipping, which is much applied in the literature, and the cost functions estimated in this study could thus provide a complementary transfer mechanism.     

地铁临时支援供电中压环网方案研究

因征地拆迁等原因,地铁主变电所及电缆通道常因工期滞后而需临时支援供电。针对临时支援供电问题研究其中压环网方案,提出了系统运行方式及可靠性、压降要求、倒接可行性和经济性4方面评价标准。以武汉地铁2号线南延线为例,提出3种临时支援供电方案。分别阐述了每种方案的运行方式,计算了环网压降,研究倒接方案的可行性和经济性。通过综合比较,总结出各方案的优缺点,提出注意事项,为后续工程提供思路。     

云南省民航客运发展预测

民航运输是云南省在进行综合交通运输建设的重点之一,也是该省在未来"十四五"(2021-2025年)和"十五五"(2026-2030年)规划期间的研究热点。本文以云南省为研究范围,以省内民航客运为研究对象,选取省内主要的社会经济因素为影响因子,运用主成分分析法(PCA)、反向传播神经网络算法(BP神经网络算法)和回归分析法,构建了省内民航客运的预测模型,得出省内各主要机场在"十四五"末和"十五五"末的预计旅客吞吐量,对省政府在进行机场改扩建上有一定的指导意义。     

基于分段单孔反演的隧址区多断层地应力分布特征

目前，针对具有多个原位地应力测试钻孔的隧址区初始地应力场反演，往往一次性将全部实测值用以计算值的回归反分析，没有考虑到隧道纵向长度远超其他方向且钻孔分布较远的特点，单个钻孔表征的临近区域地应力分布特征或反演精度被其余钻孔实测值“拉低”，导致整体反演结果容易陷入局部优解。依托拉林铁路桑珠岭隧道、叙毕铁路斑竹林隧道、沿江高速火山隧道、木寨岭公路隧道等工程，采用多元线性回归法结合最小二乘法寻优准则，分析了隧址区仅有单个钻孔反演精度较高的原因，提出了对具有多个钻孔的隧址区分段并分别进行单钻孔回归反演的新方法。在此基础上，重点讨论了木寨岭公路隧道断层破碎带区域地应力分布特征。结果表明：分段单孔反演较多孔反演进一步提高了反演精度；地应力的分布在断层前后呈现出先急剧增大后急剧减小的特征；除自重应力与埋深存在一定关联外，两项水平主应力随断层间距或厚度的增大突变性加剧；断层之间间距、断层倾角、断层厚度均是影响地应力方向偏转大小的重要因素，断层之间间距或断层倾角越小、断层越厚，地应力方向偏转越显著。     

含初始变形船体加筋板有效宽度及剩余极限强度研究

为了评估舰船结构损伤后的剩余强度,对船体加筋板出现初始几何变形后,参与总纵强度的有效宽度和加筋板剩余极限强度进行研究。将加筋板受到垂直于平面压力后的变形,作为其初始几何变形,改变变形的方向和大小,利用有限元软件Ansys对加筋板结构进行线性和非线性分析。定义了板有效宽度计算方法,对不同变形方向和变形幅值时板的有效宽度和加筋板的极限强度进行对比分析,并拟合得到了计算板有效宽度和加筋板极限强度的经验公式。结果表明,初始几何变形会削弱加筋板结构的强度。在对损伤后船体结构强度进行分析和校核时,提出的经验公式可以直接用来计算板的有效宽度和加筋板的极限强度。     

海洋核动力平台全频段舱室噪声预报与降噪方案研究

随着新规范对船舶及海上工作平台提出了更高要求，舱室噪声的控制及优化设计越来越受到人们的关注。本文首先对全频段舱室噪声预报软件——VA One软件统计能量分析理论及软件概况进行了阐述，其次应用该软件对海洋核动力平台进行几何建模与仿真计算。通过对舱室仿真计算结果与标准指标要求的对比分析，在设计阶段提出了海洋核动力平台舱室空气噪声综合治理降噪方案，该措施可以缩短建造周期、降低制造成本，提高海洋核动力平台的舒适性与安全性，具有十分重要的经济效益和社会效益。     

A signal decomposition method based on repeated extraction of maximum energy component for offshore structures

Contrary to most signal decomposition methods that usually decompose an original signal into a series of components simultaneously, a novel approach based on repeated extraction of Maximum Energy Component (MEC) is proposed. The approach starts from determination of the MEC referring to the estimated Power Spectral Density (PSD) function, and then represents the MEC by employing an exponential function to fit the original signal. By defining a stopping criterion based on two adjacent estimated PSDs, each MEC can be accurately extracted with an improved performance throughout the entire signal decomposition. To verify the proposed method, a single degree-of-freedom system subject to harmonic loads has been examined. Numerical results show that the analytical response can not only be decomposed into four MECs corresponding to the excitation and the system, respectively, but also provide an accurate estimation of natural frequency and damping ratio of the system. Meanwhile, by observing results from the Ensemble Empirical Mode Decomposition (EEMD), Variational Mode Decomposition (VMD) and Prony based on state-space model (Prony-SS), an improved decomposition accuracy has been achieved from the proposed approach. Furthermore, experimental data from the Norwegian Deepwater Programme and two sets of field-test data from one fixed offshore platform and an offshore wind turbine have been used to demonstrate the correctness of the developed signal decomposition method. It is noted that divergence in results by Prony-SS can be observed when a very large model order is used, while the proposed method provides the better decomposition and reconstruction of signals.